4.7 Article

Effect of inner strut on mass diffusion and mixing efficiency of cross fuel jet inside the scramjet combustor

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Engineering, Aerospace

Effects of pulsed injection on ignition delay and combustion performance in a hydrogen-fuel scramjet combustor

Zan He et al.

Summary: This paper investigates the pulsed injection of hydrogen fuel in a pulse combustion wind tunnel and analyzes its effects on ignition delay and combustion performance. The results show that pulsed injection at a specific frequency can reduce the ignition delay of hydrogen and enhance its combustion performance, achieving energy release comparable to steady injection at higher equivalence ratios. The pulse frequency does not significantly affect hydrogen combustion performance.

ACTA ASTRONAUTICA (2022)

Article Computer Science, Interdisciplinary Applications

Numerical study of droplet breakup in an asymmetric T-junction microchannel with different cross-section ratios

Milad Isanejad et al.

Summary: In this study, numerical simulations are performed to investigate droplet breakup in an asymmetric T-junction microchannel. The results show good agreement with previous studies, and the effects of capillary number, non-dimensional droplet length, and non-dimensional width ratio on the breakup time and splitting ratio are studied. It is also found that the mass center of the mother droplet is shifted to a wider branch, facilitating the asymmetric breakup in the T-junction microchannel.

INTERNATIONAL JOURNAL OF MODERN PHYSICS C (2022)

Article Multidisciplinary Sciences

Splitting of droplet with different sizes inside a symmetric T-junction microchannel using an electric field

Keivan Fallah et al.

Summary: In this study, droplets dynamics under an asymmetric electric field in a T-junction were numerically investigated, and two novel droplet patterns were observed. It was concluded that using an electric field allows for precise control over droplet size and splitting ratio.

SCIENTIFIC REPORTS (2022)

Article Engineering, Aerospace

Interplay of self-throttling and air throttling on combustion enhancement of the scramjet combustor

Subhasis Chakravarthy et al.

Summary: This study discusses the effects of self-throttling and air throttling on the performance of a scramjet combustor. The research reveals significant improvements in mixing and combustion efficiency. Air throttling proves to be more effective when used in conjunction with self-throttling.

ACTA ASTRONAUTICA (2022)

Article Energy & Fuels

Design and thermodynamics analysis of marine dual fuel low speed engine with methane reforming integrated high pressure exhaust gas recirculation system

Jinbo Qu et al.

Summary: This paper proposes a system consisting of a fuel reformer and a high-pressure EGR natural gas engine to achieve a balance between fuel efficiency and emission control. Through this system, engine efficiency can be improved while reducing methane slip and controlling NOx emissions, saving costs and meeting the IMO Tier III standards.
Article Engineering, Aerospace

Research progress on mixing enhancement using streamwise vortices in supersonic flows

Byeong-Jo Hwang et al.

Summary: Efficient mixing and combustion in supersonic flow is critical for developing hypersonic airbreathing propulsion systems, and inducing streamwise vortices is an effective method to enhance and accelerate mixing. Research on mixing enhancement by streamwise vortices has been conducted extensively for decades and has made significant progress.

ACTA ASTRONAUTICA (2022)

Article Engineering, Aerospace

Effects of swirl injection on the combustion of a novel composite hybrid rocket fuel grain

Zelin Zhang et al.

Summary: The combustion characteristics of a novel composite fuel grain were investigated with the coupling effect of swirl injection. It was found that the swirl injectors significantly improved the regression rate of the fuel grain, and the mechanism behind this effect was revealed through imaging and numerical simulations.

ACTA ASTRONAUTICA (2022)

Article Computer Science, Interdisciplinary Applications

Injection of hydrogen sonic multi-jet on inclined surface at supersonic flow

Amin Hassanvand et al.

Summary: The study investigates the effects of multiple hydrogen jets on an inclined surface in supersonic airflow, finding that mixing performance improves at high jet pressure and with increasing angle of the exterior surface. The study also highlights the significant impact of power and slant of the separation shock on the size of the mixing zone.

INTERNATIONAL JOURNAL OF MODERN PHYSICS C (2021)

Article Thermodynamics

New insights into the effects of methane and oxygen on heat/mass transfer in reactive porous media

Zhilong Cheng et al.

Summary: This study examines the effects of methane and oxygen injection concentrations on sintering performance, showing that high methane concentration can expand the melting zone and increase the melting quantity index, while low oxygen concentration in the reacting flow can slow down the propagation speed of the melting zone, thus improving local sintering performance.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2021)

Article Engineering, Aerospace

Numerical investigation of cavity-induced enhanced supersonic mixing with inclined injection strategies

Dai Jian et al.

Summary: The study found that the grooved configuration significantly improves supersonic mixing in the scramjet combustor, enhancing fuel uniformity in the downstream region.

ACTA ASTRONAUTICA (2021)

Article Thermodynamics

An innovative design for measuring the enhanced mixing effect of a shock wave on supersonic film cooling

Hang Ni et al.

Summary: This study proposes a non-contact experimental design using pressure sensitive paint to investigate the enhanced mixing effect caused by shock waves in supersonic film cooling. The results show that shock waves increase the oxygen concentration along the wall and the local pressure, leading to an increase in oxygen partial pressure. Further calculations reveal that the enhanced mixing effect of shock waves is stronger for stronger shock waves and lighter cooling gases, which is consistent with previous studies.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2021)

Article Chemistry, Physical

Effect of hybrid coaxial air and hydrogen jets on fuel mixing at supersonic crossflow

Yuelei Zhang et al.

Summary: The research applies a computational method to examine the impacts of coaxial hybrid air and fuel jets on fuel mixing at supersonic cross-flow, revealing significant improvement in fuel penetration and mixing inside the combustion chamber. The study also confirms that the coaxial injector enhances the spiral feature of the fuel jet, promoting fuel mixing downstream and increasing circulation strength in far away from an injector.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Thermodynamics

Study of circular transverse jet - A new method for high-efficiency mixing and combustion in crossflow

Ziwan Li et al.

Summary: This paper investigates a new method of using circular transverse jet to improve combustion efficiency at off-design conditions. Results show that this method can effectively mix fuel and mainstream airflow, leading to combustion efficiency reaching over 99% under specific conditions. The study of flow field structure and temperature distribution in the combustion zone lays the foundation for further research and engineering application.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2021)

Article Engineering, Aerospace

Influence of trapezoidal lobe strut on fuel mixing and combustion in supersonic combustion chamber

Yu Jiang et al.

Summary: This article investigates the fuel injection system in supersonic vehicles, focusing on the use of a trapezoidal strut injector to enhance fuel mixing. The strength of vortices is influenced by injector velocity and free stream conditions, with the results showing an 18% improvement in fuel mixing when using a trapezoidal strut injector.

AEROSPACE SCIENCE AND TECHNOLOGY (2021)

Article Engineering, Aerospace

The influence of the wedge shock generator on the vortex structure within the trapezoidal cavity at supersonic flow

Zhixiong Li et al.

AEROSPACE SCIENCE AND TECHNOLOGY (2020)

Article Engineering, Aerospace

The influence of the sinusoidal shock generator on the mixing rate of multi hydrogen jets at supersonic flow

Yicheng Li et al.

AEROSPACE SCIENCE AND TECHNOLOGY (2020)

Article Chemistry, Physical

Numerical simulation of mixing of hydrogen jet at supersonic cross flow in presence of upstream wavy wall

Tran Dinh Manh et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Article Chemistry, Physical

Computational investigation of multi-cavity fuel injection on hydrogen mixing at supersonic combustion chamber

Zhixiong Li et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Article Computer Science, Interdisciplinary Applications

Computational study of the cavity flow over sharp nose cone in supersonic flow

F. Pish et al.

INTERNATIONAL JOURNAL OF MODERN PHYSICS C (2020)

Review Chemistry, Multidisciplinary

CFD simulation of the structured packings: A review

Younes Amini et al.

SEPARATION SCIENCE AND TECHNOLOGY (2019)

Article Thermodynamics

Viscous equilibrium analysis of heat transfer on blunted cone at hypersonic flow

F. Pish et al.

CASE STUDIES IN THERMAL ENGINEERING (2019)

Article Engineering, Aerospace

Shock wave structures in the wake of sonic transverse jet into a supersonic crossflow

Chang-hai Liang et al.

ACTA ASTRONAUTICA (2018)

Review Engineering, Aerospace

Flame propagation and stabilization in dual-mode scramjet combustors: A survey

Wei Huang et al.

PROGRESS IN AEROSPACE SCIENCES (2018)

Review Engineering, Aerospace

A review on enhanced mixing methods in supersonic mixing layer flows

Jianguo Tan et al.

ACTA ASTRONAUTICA (2018)

Article Thermodynamics

LES study on flow features of the supersonic mixing layer affected by shock waves

Donggang Cao et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2017)

Article Thermodynamics

Evolution of cellular structures on oblique detonation surfaces

Honghui Teng et al.

COMBUSTION AND FLAME (2015)

Article Engineering, Aerospace

Supersonic Combustion and Flame Stabilization of Coflow Ethylene and Air with Splitter Plate

Liwei Zhang et al.

JOURNAL OF PROPULSION AND POWER (2015)

Article Chemistry, Analytical

Numerical modeling of surface reaction kinetics in electrokinetically actuated microfluidic devices

Arman Sadeghi et al.

ANALYTICA CHIMICA ACTA (2014)

Article Mechanics

On the transition pattern of the oblique detonation structure

Hong Hui Teng et al.

JOURNAL OF FLUID MECHANICS (2012)

Article Engineering, Aerospace

Numerical Investigation of Transverse Jets Through Multiport Injector Arrays in Supersonic Crossflow

Adrian S. Pudsey et al.

JOURNAL OF PROPULSION AND POWER (2010)

Article Engineering, Aerospace

Transverse injection through diamond and circular ports into a Mach 5.0 freestream

Ravichandra Srinivasan et al.

AIAA JOURNAL (2008)