☆ 4.7 Article

Enhanced film cooling and flow disturbance of an AGTB turbine cascade with plasma aerodynamic actuation at film-holes outlets

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Aerospace

Effects of plasma actuation and hole configuration on film cooling performance

Jie Sun et al.

Summary: In this paper, plasma actuators are arranged asymmetrically downstream the wall to improve film cooling performance. Effects of blowing ratio, hole configuration and applied voltage on flow characteristics and film cooling effectiveness were investigated numerically on a flat plate. Results show that the highest film cooling effectiveness distribution is obtained both in the spanwise and streamwise directions under blowing ratio of 0.5, and the average wall film cooling effectiveness of cylindrical hole increases by 251.9% under blowing ratio of 0.5 compared to that under blowing ratio of 1.5.

PROPULSION AND POWER RESEARCH (2023)

添加到收藏夹

Article Thermodynamics

Control of Snow Falling Flow around NACA0015 Blade using a Plasma Electrode with Weather Resistant Design

Hisashi Matsuda et al.

Summary: The effect of plasma actuation on the snow falling flow was investigated using a plasma electrode with weather resistant design and the natural snow wind facility. The study found that the fundamental frequency of plasma actuation has a significant impact on controlling the movement of snowflakes. By adjusting the parameters appropriately, the movement of snowflakes can be effectively controlled while ensuring the safe operation of the plasma electrode.

JOURNAL OF THERMAL SCIENCE (2022)

添加到收藏夹

Article Thermodynamics

Experimental investigation and numerical analysis on effects of swirling coolant on flow characteristics and film cooling performance

Rui Zhu et al.

Summary: Modern gas turbines use combined internal and external cooling methods to achieve higher cooling effectiveness. Swirl in the coolant enhances film cooling effectiveness for one row of holes, but decreases it for two rows of staggered holes.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2022)

添加到收藏夹

Article Thermodynamics

Large eddy simulation of compound angle film cooling with vortex generators

Zhiyuan Zhao et al.

Summary: This study investigated the effect of compound angled injection and delta winglets on film cooling performance using LES. The results show that the cooling performance improves significantly when these methods are applied.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2022)

添加到收藏夹

Article Thermodynamics

Coupled heat transfer analysis of internal and film cooling of turbine blade under medium temperature conditions

W. Jin et al.

Summary: There is a lack of research on the coupled heat transfer characteristics of turbine blade cooling. This study numerically investigates the coupled heat transfer in a turbine blade by considering both internal and film cooling. The results show that the heat conduction through the dividing wall enhances the cooling effect, and adjusting the blowing ratio improves the blade cooling performance.

APPLIED THERMAL ENGINEERING (2022)

添加到收藏夹

Article Thermodynamics

Research on the effect of the swirling coolant within endwall passage on film cooling/heat transfer and aerodynamic losses

Ji Hu et al.

Summary: Research shows that using a swirling cooling scheme can significantly improve the cooling effectiveness in the corner region of the pressure surface in the turbine passage, and overall cooling effectiveness at different axial positions. The swirling cooling can achieve a better cooling performance by generating a pair of anti-vortices.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2021)

添加到收藏夹

Article Thermodynamics

Large eddy simulation of film cooling from cylindrical holes partially blocked by CaO-MgO-Al2O3-SiO2

Xiaohu Chen et al.

Summary: The deposition efficiency of CMAS is negatively correlated with the blowing ratio, and the CMAS blockage level increases nonlinearly with the service time. With the increase of blockage and blowing ratio, the film cooling effectiveness degradation rate also increases.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2021)

添加到收藏夹

Article Thermodynamics

Film Cooling Performance Enhancement by Upstream V-shaped Protrusion/Dimple Vortex Generator

Juan He et al.

Summary: The study demonstrates that arranging v-shaped protrusion/dimple vortex generators can significantly enhance film cooling performance, especially the VSPVG, which improves the adiabatic film cooling effectiveness by a large margin under different blowing ratios.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2021)

添加到收藏夹

Article Thermodynamics

Numerical comparison of saw-tooth plasma actuators for film cooling flow control over a flat plate

Guozhan Li et al.

Summary: Large eddy simulations were conducted to study film cooling efficiency of an inclined round jet in crossflow with and without a saw-tooth plasma actuator (STPA). Results show that the STPA may not always be advantageous to film cooling. When the tip of the STPA is located at the centerline, it can enhance film cooling efficiency by inducing coolant outward along the wall and promoting the spanwise-coverage of the coolant through anti-counter rotating vortex pair (CRVP).

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Flow separation control in an axial compressor cascade using various arrangement of plasma actuator

Amin Kadivar et al.

Summary: The study demonstrates that plasma actuators can effectively reduce energy losses and enhance lift-to-drag ratio of axial compressor cascade. At low Reynolds numbers and low angles of attack, using three pairs of electrodes yields the best performance enhancement.

JOURNAL OF ELECTROSTATICS (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Surface cooling by dielectric barrier discharge plasma actuator in confinement channel

Satoshi Uehara et al.

JOURNAL OF ELECTROSTATICS (2020)

添加到收藏夹

Article Thermodynamics

Effect of internal coolant crossflow on the film cooling performance of converging slot hole

Cun-liang Liu et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2020)

添加到收藏夹

Article Engineering, Aerospace

Leading-edge flow separation control over an airfoil using a symmetrical dielectric barrier discharge pasma actuator

Xin Zhang et al.

CHINESE JOURNAL OF AERONAUTICS (2019)

添加到收藏夹

Article Engineering, Mechanical

A Physically Consistent Reduced Order Model for Plasma Aeroelastic Control on Compressor Blades

Valentina Motta et al.

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2019)

添加到收藏夹

Article Physics, Applied

A new plasma actuator configuration for improved efficiency: the stair-shaped dielectric barrier discharge actuator

F. Rodrigues et al.

JOURNAL OF PHYSICS D-APPLIED PHYSICS (2019)

添加到收藏夹

Article Thermodynamics

Experimental Analysis of Dielectric Barrier Discharge Plasma Actuators Thermal Characteristics Under External Flow Influence

F. F. Rodrigues et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2018)

添加到收藏夹

Article Thermodynamics

Large Eddy Simulation of the Elliptic Jets in Film Cooling Controlled by Dielectric Barrier Discharge Plasma Actuators With an Improved Model

Jianyang Yu et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2018)

添加到收藏夹

Article Thermodynamics

Study of influencing characteristics on boundary-layer separation controlled by using DBD plasma actuator with modified model

Tzong-Hann Shieh

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Thermodynamics

Numerical study and GMDH-type neural networks modeling of plasma actuator effects on the film cooling over a flat plate

Samera Dolati et al.

APPLIED THERMAL ENGINEERING (2017)

添加到收藏夹

Article Engineering, Mechanical

Prediction and Analysis of Impact of Thermal Barrier Coating Oxidation on Gas Turbine Creep Life

E. A. Ogiriki et al.

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2016)

添加到收藏夹

Article Engineering, Aerospace

Optimization of micro single dielectric barrier discharge plasma actuator models based on experimental velocity and body force fields

E. Pescini et al.

ACTA ASTRONAUTICA (2015)

添加到收藏夹

Article Engineering, Mechanical

Flow Control Over a Circular Cylinder Using Pulsed Dielectric Barrier Discharge Actuators

William C. Schneck et al.

JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2015)

添加到收藏夹

Article Engineering, Mechanical

Extreme Temperature Coatings for Future Gas Turbine Engines

M. A. Alvin et al.

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2014)

添加到收藏夹

Article Engineering, Mechanical

Control of Tip-Clearance Flow in a Low Speed Axial Compressor Rotor With Plasma Actuation

Giridhar Jothiprasad et al.

JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2012)

添加到收藏夹

Article Thermodynamics

Influence of Trenched Shaped Holes on Turbine Blade Leading Edge Film Cooling

Sima Baheri Islami et al.

HEAT TRANSFER ENGINEERING (2010)

添加到收藏夹

Article Mechanics

Invariants of the velocity-gradient, rate-of-strain, and rate-of-rotation tensors across the turbulent/nonturbulent interface in jets

Carlos B. da Silva et al.

PHYSICS OF FLUIDS (2008)

添加到收藏夹

Article Physics, Applied

Modeling of glow discharge-induced fluid dynamics

W Shyy et al.

JOURNAL OF APPLIED PHYSICS (2002)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.