☆ 4.7 Article

Raceway Defect Features of a High-Speed Train Axle Box Bearing in the VehicleTrack Coupled System

IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Mechanical

Vibration characteristics of rotor-bearing system with angular misalignment and cage fracture: Simulation and experiment

Pengfei Wang et al.

Summary: This paper studies the vibration characteristics of cage fracture faults in rolling bearings from both simulation and experimental aspects. It finds that when cage fracture occurs, the system amplitude increases and obvious impact vibration characteristics appear, and the vibration energy gradually concentrates to low-frequency vibration. These results provide important reference for the identification and diagnosis of rolling bearing misalignment and cage fracture.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2023)

添加到收藏夹

Article Engineering, Mechanical

Investigation on the characterisation of axle box resonance characteristics to wheel excitation

Cai Yi et al.

Summary: An increasing number of studies have shown the effectiveness and superiority of reverse engineering in using axle box vibration acceleration signals to deduce the operation state of wheelsets. However, there is a lack of discussion and summary on the overall mapping relationship between wheel excitation and axle box response, and no detailed investigation on resonance characteristics of axle box. This study proposes a novel resonant excitation loading method and discusses the guiding role of axle box resonance characteristics on wheel operation status detection through two case studies.

VEHICLE SYSTEM DYNAMICS (2023)

添加到收藏夹

Article Engineering, Electrical & Electronic

Self-Adaptive Multivariate Variational Mode Decomposition and Its Application for Bearing Fault Diagnosis

Qiuyu Song et al.

Summary: In actual engineering scenarios, multichannel datasets with complete information are essential for accurate bearing fault diagnosis. The self-adaptive MVMD method proposed in this study addresses the challenge of initial parameter selection, leading to improved fault diagnosis outcomes. Overall, the study demonstrates the potential of a new approach in bearing fault diagnosis.

IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2022)

添加到收藏夹

Article Engineering, Mechanical

Effects of three types of bearing misalignments on dynamic characteristics of planetary gear set-rotor system

Pengfei Wang et al.

Summary: This paper analyzes the effects of axial, radial, and tilt misalignments on the dynamic characteristics of the planetary gear set-rotor system. It proposes a nonlinear restoring force model for ball bearings under different misalignment conditions. The dynamic model of the planetary gear set is established using the lumped parameter method, and the rotor is modeled using the Timoshenko beam element. The results show that misalignments reduce vibration amplitude but increase load-bearing area and contact load. Different types of misalignments also affect the varying compliance frequency amplitude of the bearing. The research provides a theoretical basis for fault diagnosis and identification of bearing misalignment in complex rotating machinery systems.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2022)

添加到收藏夹

Article Engineering, Civil

Dynamic Responses of Ballastless High-Speed Railway Due to Train Passage With Excitation of Uneven Trackbed Settlement

Hongming Liu et al.

Summary: This study proposed a train-track-trackbed coupling model to investigate the dynamic responses of track structure with varied patterns of trackbed settlement. The influences of train speeds, settlement trough amplitude, and length were discussed based on this analysis model. A new trackbed settlement control criteria was proposed, considering both train operation safety and riding comfort standards.

IEEE TRANSACTIONS ON INTELLIGENT TRANSPORTATION SYSTEMS (2022)

添加到收藏夹

Article Engineering, Mechanical

Dynamic modelling of the defect extension and appearance in a cylindrical roller bearing

Jing Liu et al.

Summary: This study proposes new defect extension and morphology modeling methods based on the defect edge features, and analyzes the effect of the evolution of defect edge feature on the vibrations of cylindrical roller bearings. The study also introduces a rigid rotor-roller bearing system with a defect to examine the effect of the defect on the rotor system, providing a useful method for improving modeling methods of defective cylindrical roller bearings.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2022)

添加到收藏夹

Article Engineering, Electrical & Electronic

An Adaptive Demodulation Band Segmentation Method to Optimize Spectral Boundary and Its Application for Wheelset-Bearing Fault Detection

Qingsong Zhang et al.

Summary: The article proposes a novel method called adaptive autocorrelated kurtogram (AAK) for wheelset-bearing fault detection. By reducing interference from unrelated components and accurately obtaining the fault zone, the AAK method achieves accurate detection of wheelset bearing faults.

IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2022)

添加到收藏夹

Article Acoustics

Theoretical and experimental analyses of vibration impulses and their influence on accurate diagnosis of ball bearing with localized outer race defect

Sameera Mufazzal et al.

Summary: This study presents an in-depth analysis of the vibration response of ball bearings using a modified 2DOF lumped parameter model, showing the significant impact of varying compliance vibration on the location and number of impulses. The simulation results reveal that defect-induced vibration peaks may be influenced by the varying compliance vibration, leading to erroneous fault identification.

JOURNAL OF SOUND AND VIBRATION (2021)

添加到收藏夹

Article Engineering, Mechanical

Coupling model and vibration simulations of railway vehicles and running gear bearings with multitype defects

Zhenggang Lu et al.

Summary: This study proposes a comprehensive method for modeling axle box bearings and establishes a closed-loop model by integrating the bearing model with vehicle motion, accurately simulating the vibration response of bearings under train running conditions.

MECHANISM AND MACHINE THEORY (2021)

添加到收藏夹

Article Engineering, Mechanical

A spatial coupling model to study dynamic performance of pantograph-catenary with vehicle-track excitation

Yang Song et al.

Summary: This study focuses on the impact of vehicle-track excitation on the pantograph-catenary system in the high-speed railway industry. By constructing and validating models, the research explores the effects of carbody vibration on contact point deviation and system reliability.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2021)

添加到收藏夹

Article Engineering, Mechanical

Dynamic modeling and characteristics analysis of cylindrical roller bearing with the surface texture on raceways

Shuaiming Su et al.

Summary: This paper develops a complex dynamic model of cylindrical roller bearings with consideration of surface texture, which is verified by simulations and experiments on the relationship between wave numbers and vibration responses. Various dynamic characteristics of roller bearings are discussed, including the influence of radial clearance and rotation speed on cage stability, roller-raceway contact, and rotation angular speed of roller.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2021)

添加到收藏夹

Article Engineering, Mechanical

Effect of dynamic misalignment on the vibration response, trajectory followed and defect-depth achieved by the rolling-elements in a double-row spherical rolling-element bearing

Vivek Parmar et al.

Summary: This paper aims to investigate the physics governing the vibration response of spherical rolling-element bearing with a localized defect and subjected to dynamic-misalignment. The study found that an increase in radial and axial loads have contrasting effects on the acceleration response and contact load shared by the two bearing rows. Furthermore, the behavior observed from the numerically simulated results was validated from the vibration data obtained experimentally from the test-rig.

MECHANISM AND MACHINE THEORY (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Self-Powered Wireless Sensor Node for Smart Railway Axle Box Bearing via a Variable Reluctance Energy Harvesting System

Yun Gong et al.

Summary: This article proposes a variable reluctance energy harvesting system to power the WSN integrated within the smart bearing, optimizing its performance through theoretical modeling and finite-element analysis. The experimental verification of the system's power generation at different rotation speeds and the charging efficiency of the PMC were conducted.

IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Multitask Learning Based on Lightweight 1DCNN for Fault Diagnosis of Wheelset Bearings

Zhiliang Liu et al.

Summary: This article explores the potential of using multitask learning to improve the fault diagnosis performance of bearings, introducing speed identification task and load identification task as auxiliary tasks, and proposing a multitask one-dimensional convolutional neural network (MT-1DCNN). Experimental results demonstrate that multitask learning can enhance the fault diagnosis performance of the network.

IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2021)

添加到收藏夹

Article Engineering, Mechanical

Analysis of vibration and temperature on the axle box bearing of a high-speed train

Zhiwei Wang et al.

VEHICLE SYSTEM DYNAMICS (2020)

添加到收藏夹

Article Engineering, Mechanical

Vibration analysis of the axle bearings considering the combined errors for a high-speed train

Liu Jing et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART K-JOURNAL OF MULTI-BODY DYNAMICS (2020)

添加到收藏夹

Article Engineering, Mechanical

Experimental observations and dynamic modeling of vibration, characteristics of a cylindrical roller bearing with roller defects

Linkai Niu et al.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2020)

添加到收藏夹

Article Engineering, Mechanical

A general multi-objective optimized wavelet filter and its applications in fault diagnosis of wheelset bearings

Shaopu Yang et al.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

Random Response Analysis of Axle-Box Bearing of a High-Speed Train Excited by Crosswinds and Track Irregularities

Zhiwei Wang et al.

IEEE TRANSACTIONS ON VEHICULAR TECHNOLOGY (2019)

添加到收藏夹

Article Engineering, Multidisciplinary

Experimental Investigation of Shaft Radial Load Effect on Bearing Fault Signatures Detection

Fabio Immovilli et al.

IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS (2017)

添加到收藏夹

Article Engineering, Mechanical

An improved 2D modeling of bearing based on DEM for predicting mechanical stresses in dynamic

C. Machado et al.

MECHANISM AND MACHINE THEORY (2017)

添加到收藏夹

Article Automation & Control Systems

Improvements in Axle Box Acceleration Measurements for the Detection of Light Squats in Railway Infrastructure

Zili Li et al.

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2015)

添加到收藏夹

Article Engineering, Mechanical

Analysis of bearing stiffness variations, contact forces and vibrations in radially loaded double row rolling element bearings with raceway defects

Dick Petersen et al.

MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2015)

添加到收藏夹

Article Engineering, Mechanical

Influence of Track Irregularities in the Catenary-Pantograph Dynamic Interaction

A. Carnicero et al.

JOURNAL OF COMPUTATIONAL AND NONLINEAR DYNAMICS (2012)

添加到收藏夹

Article Engineering, Mechanical

An analytical model to investigate skidding in rolling element bearings during acceleration

Wenbing Tu et al.

JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2012)

添加到收藏夹

Article Engineering, Mechanical

Fundamentals of vehicle-track coupled dynamics

Wanming Zhai et al.

VEHICLE SYSTEM DYNAMICS (2009)

添加到收藏夹

Article Engineering, Electrical & Electronic

Dynamic analysis of a high-speed train

Sonia Leva et al.

IEEE TRANSACTIONS ON VEHICULAR TECHNOLOGY (2008)

添加到收藏夹

Article Thermodynamics

Experiments and models for the thermal response of railroad tapered-roller bearings

Constantine M. Tarawneh et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2008)

添加到收藏夹

Article Engineering, Electrical & Electronic

A railway measurement system to evaluate the wheel-rail interaction quality

Filippo Attivissimo et al.

IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT (2007)

添加到收藏夹

Article Engineering, Mechanical

Creep forces in simulations of traction vehicles running on adhesion limit

O Polach

WEAR (2005)

添加到收藏夹

Article Engineering, Mechanical

Simulation and analysis of vibration signals generated by rolling element bearing with defects

Z Kiral et al.

TRIBOLOGY INTERNATIONAL (2003)

添加到收藏夹

Article Acoustics

A stochastic model for simulation and diagnostics of rolling element bearings with localized faults

J Antoni et al.

JOURNAL OF VIBRATION AND ACOUSTICS-TRANSACTIONS OF THE ASME (2003)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.