☆ 4.7 Article

Effects of stator and rotor geometry on inline high shear mixers: Residence time distribution, flow, and energy consumption

CHEMICAL ENGINEERING JOURNAL (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Chemical

Nanoparticle de-agglomeration in viscous fluids using different high shear mixer geometries

Vikash Vashisth et al.

Summary: The study investigated the impact of batch high shear mixer (HSM) geometries on nanoparticles deagglomeration and power draw in water and aqueous glycerol solutions. It found that the mesh head geometry is more efficient in generating fines compared to the disintegrated head. Bi-modal particle size distribution was observed, with erosion as the dominant break-up mechanism. Power draw increased with viscosity, continuous media viscosity, and rotor speed.

CHEMICAL ENGINEERING SCIENCE (2022)

添加到收藏夹

Article Engineering, Chemical

Effects of rotor and stator geometry on dissolution process and power consumption in jet-flow high shear mixers

Lin Yang et al.

Summary: The study shows that by adjusting the configuration of the rotor blade inclination and stator bottom opening of the JF-HSM, the solid-liquid mass transfer rate can be significantly increased to enhance mixing efficiency. These results provide dimensionless correlations to guide the design and selection of such new equipment.

FRONTIERS OF CHEMICAL SCIENCE AND ENGINEERING (2021)

添加到收藏夹

Article Engineering, Environmental

Investigation of gas-liquid mass transfer and power consumption characteristics in jet-flow high shear mixers

Yudong Liu et al.

Summary: Experimental measurements were conducted to investigate the effects of operating conditions and structural configurations of the rotor-stator head on gas-liquid characteristics and power consumption of the jet-flow high shear mixer (HSM). The results showed that gas-liquid mass transfer performance and power consumption were significantly influenced by structural parameters and increasing gas flow rate or reducing surface tension could enhance mass transfer performance. Dimensionless correlations were established based on the experimental data to predict Pog and kLa, providing useful guidance for scaleup design and optimization of the jet-flow HSM.

CHEMICAL ENGINEERING JOURNAL (2021)

添加到收藏夹

Review Engineering, Chemical

Residence time distribution (RTD) revisited

Alirio E. Rodrigues

Summary: This article revisits the Residence Time Distribution (RTD) theory and discusses the application of tracer technology as well as modeling of fluid flow and chromatographic processes. It also addresses the shortcomings of the Standard Dispersion Model (SDM) and highlights the importance of Computational Fluid Dynamics (CFD) in calculating RTD.

CHEMICAL ENGINEERING SCIENCE (2021)

添加到收藏夹

Article Engineering, Chemical

Design and development of high shear mixers: Fundamentals, applications and recent progress

Vikash Vashisth et al.

Summary: HSMs, as important devices, are widely used in industrial production processes such as dispersion of nanoparticles, emulsification, and mixing. The geometry of the stator has a significant impact on the uniform size distribution and energy dissipation in HSMs. Despite extensive research on hydrodynamics and mixing in HSMs, there is still a lack of specific scale-up/down criteria available.

CHEMICAL ENGINEERING SCIENCE (2021)

添加到收藏夹

Article Engineering, Chemical

Liquid-Liquid Dispersion and Selectivity of Chemical Reactions in the Inline Teethed High Shear Mixers

Bingyan Ai et al.

Summary: The study focused on the effects of various structural and operating parameters on liquid-liquid dispersion and selectivity of chemical reactions in inline single-row teethed high shear mixers. Results showed that increasing rotor speed and flow rate initially decreased X-s significantly, then slightly increased it. Structural parameters of the rotors were found to play a crucial role in enhancing mass transfer efficiency, with increasing rotor teeth number having the most significant impact on decreasing X-s and drop size. Computational fluid dynamics were used to predict flow and power characteristics, and a dimensionless correlation for X-s was established for design and optimization references.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Effect of structural parameters on the flow field and power consumption of in-line high shear mixer

Cholu Kwon et al.

Summary: The experimental results show that the stator tooth thickness and tooth tip-base distance have a slight effect on the flow field, while the shear gap width is a key parameter affecting the flow field. As the structural parameters increase, the power number decreases, and there is a linear relationship between the constant k1 and the structural parameters.

JOURNAL OF THE INDIAN CHEMICAL SOCIETY (2021)

添加到收藏夹

Article Engineering, Environmental

Controllable synthesis of LiNi1/3Co1/3Mn1/3O2 electrode material via a high shear mixer-assisted precipitation process

Yijun Song et al.

Summary: This study successfully synthesized LiNi1/3Co1/3Mn1/3O2 material with superior performance using a high shear mixer-assisted coprecipitation method, offering high discharge capacity and excellent cycling stability, with potential for application in large-scale production.

CHEMICAL ENGINEERING JOURNAL (2021)

添加到收藏夹

Review Engineering, Chemical

Experimental methods in chemical engineering: Residence time distribution-RTD

Ariane Berard et al.

CANADIAN JOURNAL OF CHEMICAL ENGINEERING (2020)

添加到收藏夹

Article Engineering, Chemical

Turbulent statistics of flow fields using large eddy ID simulations in batch high shear mixers

Vikash et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2019)

添加到收藏夹

Article Polymer Science

The Influence of Residence Time Distribution on Continuous-Flow Polymerization

Marcus H. Reis et al.

MACROMOLECULES (2019)

添加到收藏夹

Article Engineering, Chemical

A comparison of power and flow characteristics between batch and in-line rotor-stator mixers

T. P. John et al.

CHEMICAL ENGINEERING SCIENCE (2019)

添加到收藏夹

Article Engineering, Chemical

Numerical and experimental evaluation of droplet breakage of O/W emulsions in rotor-stator mixers

Mariana Gallassi et al.

CHEMICAL ENGINEERING SCIENCE (2019)

添加到收藏夹

Article Engineering, Chemical

Mixing Performance of an Inline High-Shear Mixer with a Novel Pore-Array Liquid Distributor

Wenpeng Li et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2019)

添加到收藏夹

Article Engineering, Chemical

Effect of tracer material properties on the residence time distribution (RTD) of continuous powder blending operations. Part I of II: Experimental evaluation

M. Sebastian Escotet-Espinoza et al.

POWDER TECHNOLOGY (2019)

添加到收藏夹

Article Chemistry, Multidisciplinary

Streamlining routine organic chemistry reactions by the employment of high shear mixers

Reyna Zeferino-Diaz et al.

GREEN CHEMISTRY (2019)

添加到收藏夹

Article Engineering, Chemical

Local levels of dissipation rate of turbulent kinetic energy in a rotor-stator mixer with different stator slot widths-An experimental investigation

Hans Henrik Mortensen et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)

添加到收藏夹

Article Engineering, Chemical

Flow studies in an in-line Silverson 150/250 high shear mixer using PIV

C. J. U. Espinoza et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)

添加到收藏夹

Article Engineering, Chemical

Particle de-agglomeration with an in-line rotor-stator mixer at different solids loadings and viscosities

Gustavo A. Padron et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)

添加到收藏夹

Article Engineering, Chemical

A validation of commonly used CFD methods applied to rotor stator mixers using PIV measurements of fluid velocity and turbulence

Hans Henrik Mortensen et al.

CHEMICAL ENGINEERING SCIENCE (2018)

添加到收藏夹

Article Engineering, Chemical

Influence of micromixing time and shear rate in fast contacting mixers on the precipitation of boehmite and NH4-dawsonite

Robin Lafficher et al.

CHEMICAL ENGINEERING SCIENCE (2018)

添加到收藏夹

Article Engineering, Chemical

Residence time distribution of particles in circulating fluidized bed risers

Leina Hua et al.

CHEMICAL ENGINEERING SCIENCE (2018)

添加到收藏夹

Article Engineering, Chemical

Effect of Stator Geometry on the Emulsification and Extraction in the Inline Single-Row Blade-Screen High Shear Mixer

Hongyun Qin et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2017)

添加到收藏夹

Article Chemistry, Applied

Characterization of Milli- and Microflow Reactors: Mixing Efficiency and Residence Time Distribution

Sven R. L. Gobert et al.

ORGANIC PROCESS RESEARCH & DEVELOPMENT (2017)

添加到收藏夹

Article Engineering, Chemical

Experimental investigations of turbulent fragmenting stresses in a rotor stator mixer. Part 1. Estimation of turbulent stresses and comparison to breakup visualizations

Andreas Hakansson et al.

CHEMICAL ENGINEERING SCIENCE (2017)

添加到收藏夹

Article Engineering, Chemical

Experimental investigations of turbulent fragmenting stresses in a rotor-stator mixer. Part 2. Probability distributions of instantaneous stresses

Andreas Hakansson et al.

CHEMICAL ENGINEERING SCIENCE (2017)

添加到收藏夹

Article Engineering, Chemical

Continuous, recycle and batch emulsification kinetics using a high-shear mixer

S. Carrillo De Hert et al.

CHEMICAL ENGINEERING SCIENCE (2017)

添加到收藏夹

Article Crystallography

Synthesis of aragonite CaCO3 nanocrystals by reactive crystallization in a high shear mixer

Chao Yang et al.

CRYSTAL RESEARCH AND TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Chemical

The effect of stator design on flowrate and velocity fields in a rotor-stator mixer-An experimental investigation

Hans Henrik Mortensen et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2017)

添加到收藏夹

Article Engineering, Environmental

Geometrical improvement of inline high shear mixers to intensify micromixing performance

Hongyun Qin et al.

CHEMICAL ENGINEERING JOURNAL (2017)

添加到收藏夹

Article Engineering, Chemical

CFD analysis of flow pattern and power consumption for viscous fluids in in-line high shear mixers

Chen Zhang et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2017)

添加到收藏夹

Article Engineering, Chemical

Comparative performance of in-line rotor-stators for deagglomeration processes

N. Gul Ozcan-Taskin et al.

CHEMICAL ENGINEERING SCIENCE (2016)

添加到收藏夹

Article Engineering, Environmental

Hydrodynamics and residence time distribution of liquid flow in tubular reactors equipped with screen-type static mixers

K. Abou Hweij et al.

CHEMICAL ENGINEERING JOURNAL (2015)

添加到收藏夹

Article Engineering, Chemical

LDA Measurements and CFD Simulations of an In-Line High Shear Mixer with Ultrafine Teeth

Shuangqing Xu et al.

AICHE JOURNAL (2014)

添加到收藏夹

Article Thermodynamics

Application of test reactions to study micromixing in the rotor-stator mixer (test reactions for rotor-stator mixer)

Magdalena Jasinska et al.

APPLIED THERMAL ENGINEERING (2013)

添加到收藏夹

Article Engineering, Chemical

Residence time distributions of in-line high shear mixers with ultrafine teeth

Shuangqing Xu et al.

CHEMICAL ENGINEERING SCIENCE (2013)

添加到收藏夹

Article Engineering, Chemical

Power consumption characteristics of an in-line silverson high shear mixer

M. Cooke et al.

AICHE JOURNAL (2012)

添加到收藏夹

Review Energy & Fuels

High shear mixers: A review of typical applications and studies on power draw, flow pattern, energy dissipation and transfer properties

Jinli Zhang et al.

CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2012)

添加到收藏夹

Article Chemistry, Applied

Mixing and Dispersion in Small-Scale Flow Systems

Kevin D. Nagy et al.

ORGANIC PROCESS RESEARCH & DEVELOPMENT (2012)

添加到收藏夹

Article Engineering, Chemical

Expression for turbulent power draw of an in-line Silverson high shear mixer

A. J. Kowalski et al.

CHEMICAL ENGINEERING SCIENCE (2011)

添加到收藏夹

Article Engineering, Chemical

Droplet break-up by in-line Silverson rotor-stator mixer

S. Hall et al.

CHEMICAL ENGINEERING SCIENCE (2011)

添加到收藏夹

Article Engineering, Chemical

The effect of stator geometry on the flow pattern and energy dissipation rate in a rotor-stator mixer

A. Utomo et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2009)

添加到收藏夹

Article Engineering, Environmental

Modelling of the residence time distribution in micromixers

D. Boskovic et al.

CHEMICAL ENGINEERING JOURNAL (2008)

添加到收藏夹

Review Engineering, Chemical

Residence time theory

E. Bruce Nauman

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2008)

添加到收藏夹

Article Engineering, Chemical

Validating a prediction method of mean residence time spatial distributions

JN Baléo et al.

AICHE JOURNAL (2000)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.