期刊
CERAMICS INTERNATIONAL
卷 49, 期 10, 页码 16332-16340出版社
ELSEVIER SCI LTD
DOI: 10.1016/j.ceramint.2023.01.235
关键词
Calcium-strontium titanate; Perovskite structure; Ionic conductivity; Dielectric
The effect of synthesis method and calcium content on the properties of Sr1-xCaxTiO3 materials was investigated. It was found that increasing calcium content resulted in a decrease in symmetry and cell volume of the perovskite structure phases, regardless of the synthesis method. Materials synthesized by the wet chemical method had smaller grain size compared to those synthesized by the solid-state reaction. However, both synthesis methods showed an increase in grain size with increasing calcium content. Additionally, calcium content affected the porosity of materials synthesized by the wet chemical method, while it had little effect on materials synthesized by the solid-state reaction. Electrical properties measurements indicated ionic conductivity in Sr1-xCaxTiO3 materials regardless of the synthesis method.
Materials with a general formula Sr1-xCaxTiO3 (where x = 0.0; 0.2; 0.4; 0.6; 0.8; 1.0) were obtained by two different synthesis routes: wet chemical method and conventional solid-state reaction. The effect of the synthesis method and the calcium content on the properties of the synthesized materials was evaluated. All materials were sintered at 1400 degrees C and tested for structural, microstructural, and electrical properties. X-ray diffraction analysis showed a decrease in the symmetry of the perovskite structure (cubic -> tetragonal -> orthorhombic) and a decrease in the cell volume of the perovskite structure phases with an increase in the Ca amount introduced into the system, regardless of the applied synthesis method. Also, the materials obtained by the citrate method had a smaller grain size compared to the materials synthesized by the solid-state method. However, for materials synthesized by both methods the increase of grain size with increasing calcium amount was observed. Moreover, the effect of calcium content on the porosity of the materials obtained by the citrate method was observed while for materials obtained by the solid-state reaction this parameter was generally not affected by Ca amount. The results of electrical properties measurements carried out in the air atmosphere indicate the ionic conductivity in Sr1-xCaxTiO3 materials irrespective of the applied synthesis method.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据