相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。Effect of the fibre length on the mechanical anisotropy of glass fibre-reinforced polymer composites printed by Multi Jet Fusion
Xiaojiang Liu et al.
VIRTUAL AND PHYSICAL PROTOTYPING (2022)
Additive manufacturing of structural materials
Guo Liu et al.
MATERIALS SCIENCE & ENGINEERING R-REPORTS (2021)
Layer-by-Layer Printing of Photopolymers in 3D: How Weak is the Interface?
H. Gojzewski et al.
ACS APPLIED MATERIALS & INTERFACES (2020)
Effects of thermal process parameters on mechanical interlayer strength for additively manufactured Ultem 9085
Travis E. Shelton et al.
POLYMER TESTING (2020)
Recent Progress on Polymer Materials for Additive Manufacturing
Lisa Jiaying Tan et al.
ADVANCED FUNCTIONAL MATERIALS (2020)
Experimental analysis of the tensile property of FFF-printed elastomers
Xiang Lin et al.
POLYMER TESTING (2020)
Degradation of MDI-based polyether and polyester-polyurethanes in various environments - Effects on molecular mass and crosslinking
Philipp Scholz et al.
POLYMER TESTING (2019)
In Situ Time-Resolved X-ray Scattering Study of Isotactic Polypropylene in Additive Manufacturing
Yuval Shmueli et al.
ACS APPLIED MATERIALS & INTERFACES (2019)
Structure Development in Polymers during Fused Filament Fabrication (FFF): An in Situ Small- and Wide-Angle X-ray Scattering Study Using Synchrotron Radiation
Aurora Nogales et al.
MACROMOLECULES (2019)
Simultaneous in Situ X-ray Scattering and Infrared Imaging of Polymer Extrusion in Additive Manufacturing
Yuval Shmueli et al.
ACS APPLIED POLYMER MATERIALS (2019)
Predicting strength of additively manufactured thermoplastic polymer parts produced using material extrusion
Joseph Bartolai et al.
RAPID PROTOTYPING JOURNAL (2018)
Interlayer adhesion and fracture resistance of polymers printed through melt extrusion additive manufacturing process
Nahal Aliheidari et al.
MATERIALS & DESIGN (2018)
Isotropic and anisotropic elasticity and yielding of 3D printed material
Rui Zou et al.
COMPOSITES PART B-ENGINEERING (2016)
An in-process laser localized pre-deposition heating approach to inter-layer bond strengthening in extrusion based polymer additive manufacturing
Abinesh Kurapatti Ravi et al.
JOURNAL OF MANUFACTURING PROCESSES (2016)
Failure Analysis and Anisotropy Evaluation of 3D-Printed Tensile Test Specimens of Different Geometries and Print Raster Patterns
Angel R. Torrado et al.
JOURNAL OF FAILURE ANALYSIS AND PREVENTION (2016)