☆ 4.5 Article

Effects of Tab Design in 21700 Li-Ion Cells: Improvements of Cell Impedance, Rate Capability, and Cycling Aging

ENERGY TECHNOLOGY (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Electrochemistry

Detection of Li Deposition on Si/Graphite Anodes from Commercial Li-Ion Cells: A Post-Mortem GD-OES Depth Profiling Study

Marius Fluegel et al.

Summary: A new semi-quantitative method has been developed to detect Li deposition on Si/graphite anodes. This method defines a corridor based on GD-OES depth profiles to determine the minimum amount of metallic Li on the anode. It has been applied to fresh cells and cells intentionally produced with Li plating by cycling at low temperatures.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2022)

添加到收藏夹

Article Electrochemistry

A post-mortem study of commercial 18650 lithium-ion cells with LiNi0.5Co0.2Mn0.3O2//Graphite chemistry after prolonged cycling (>70 00 cycles) with low C-rates

Christian Weisenberger et al.

Summary: The post-mortem analysis of commercial 18650 lithium-ion cells after long-term cycling reveals that the main capacity loss is caused by the degradation of the positive cathode rather than the negative graphite anode. The cathode degradation is attributed to a combination of effects including mechanical damage, particle cracking, and crystallographic changes.

ELECTROCHIMICA ACTA (2021)

添加到收藏夹

Article Engineering, Chemical

Increase of Cycling Stability in Pilot-Scale 21700 Format Li-Ion Cells by Foil Tab Design

Thomas Waldmann et al.

Summary: Comparing welded tabs and foil tabs on Li-ion cells in the 21700 format reveals that the cells with foil tabs exhibit 14.4% longer cycling stability and 11.2% increased total charge throughput until 80% SOH, likely due to less inhomogeneities in the case of the foil tab design.

PROCESSES (2021)

添加到收藏夹

Article Electrochemistry

A Direct Comparison of Pilot-Scale Li-Ion Cells in the Formats PHEV1, Pouch, and 21700

Thomas Waldmann et al.

Summary: In this study, Li-ion cells of industrially-relevant formats, including PHEV1 (prismatic), multi-layer pouch, and 21700 (cylindrical), were directly compared for the first time. Despite using the same materials and configurations, these cell formats showed differences in capacities, volume/surface ratios, and configurations, with various parameters such as formation processes, discharge rate capabilities, and geometrical properties being compared to provide insights into their performance. The data were also compared with cells from other studies to provide a comprehensive analysis.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2021)

添加到收藏夹

Review Chemistry, Physical

Fast Charging of Lithium-Ion Batteries: A Review of Materials Aspects

Manuel Weiss et al.

Summary: Fast charging is essential for the economic success of electric vehicles, with lithium-ion batteries facing limitations due to the transport of lithium ions within the electrodes. Understanding these limitations is crucial for optimizing material properties for fast-charging applications.

ADVANCED ENERGY MATERIALS (2021)

添加到收藏夹

Article Electrochemistry

A Comparison of Lithium-Ion Cell Performance across Three Different Cell Formats

Grace Bridgewater et al.

Summary: The study investigated the influence of different cell formats on lithium-ion cells, finding that stacked pouch cells showed higher discharge capacities at higher rates compared to coin and single layer pouch cells. Different formats exhibited differences in degradation mechanisms, possibly due to varying thermal and mechanical environments. Development within a single cell format may lead to improvements across all cell formats.

BATTERIES-BASEL (2021)

添加到收藏夹

Article Chemistry, Physical

18650 vs. 21700 Li-ion cells - A direct comparison of electrochemical, thermal, and geometrical properties

Thomas Waldmann et al.

JOURNAL OF POWER SOURCES (2020)

添加到收藏夹

Article Electrochemistry

Impact of Electrode and Cell Design on Fast Charging Capabilities of Cylindrical Lithium-Ion Batteries

J. Sturm et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2020)

添加到收藏夹

Article Electrochemistry

4-Electrode Full Cells for Operando Li+ Activity Measurements and Prevention of Li Deposition in Li-Ion Cells

Bjoern-Ingo Hogg et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2020)

添加到收藏夹

Article Electrochemistry

The Development of Jelly Roll Deformation in 18650 Lithium-Ion Batteries at Low State of Charge

Lisa Willenberg et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2020)

添加到收藏夹

Article Electrochemistry

Design Strategies for High Power vs. High Energy Lithium Ion Cells

Michael J. Lain et al.

BATTERIES-BASEL (2019)

添加到收藏夹

Review Chemistry, Physical

Li plating as unwanted side reaction in commercial Li-ion cells - A review

Thomas Waldmann et al.

JOURNAL OF POWER SOURCES (2018)

添加到收藏夹

Article Chemistry, Physical

Long-term cycling induced jelly roll deformation in commercial 18650 cells

A. Pfrang et al.

JOURNAL OF POWER SOURCES (2018)

添加到收藏夹

Article Electrochemistry

Energy Density of Cylindrical Li-Ion Cells: A Comparison of Commercial 18650 to the 21700 Cells

Jason B. Quinn et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2018)

添加到收藏夹

Article Energy & Fuels

Fast-charging of Lithium Iron Phosphate battery with ohmic-drop compensation method: Ageing study

X. Fleury et al.

JOURNAL OF ENERGY STORAGE (2018)

添加到收藏夹

Article Chemistry, Physical

An extended polarization model to study the influence of current collector geometry of large-format lithium-ion pouch cells

Stephan Kosch et al.

JOURNAL OF POWER SOURCES (2017)

添加到收藏夹

Article Electrochemistry

Effects of Electrolyte Additives and Solvents on Unwanted Lithium Plating in Lithium-Ion Cells

Q. Q. Liu et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2017)

添加到收藏夹

Review Electrochemistry

Review-Post-Mortem Analysis of Aged Lithium-Ion Batteries: Disassembly Methodology and Physico-Chemical Analysis Techniques

Thomas Waldmann et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2016)

添加到收藏夹

Article Electrochemistry

Interplay of Operational Parameters on Lithium Deposition in Lithium-Ion Cells: Systematic Measurements with Reconstructed 3-Electrode Pouch Full Cells

Thomas Waldmann et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2016)

添加到收藏夹

Article Energy & Fuels

Nonlinear aging of cylindrical lithium-ion cells linked to heterogeneous compression

Tobias C. Bach et al.

JOURNAL OF ENERGY STORAGE (2016)

添加到收藏夹

Article Energy & Fuels

Influence of current collecting tab design on thermal and electrochemical performance of cylindrical Lithium-ion cells during high current discharge

Thomas Waldmann et al.

JOURNAL OF ENERGY STORAGE (2016)

添加到收藏夹

Article Electrochemistry

Optimization of Charging Strategy by Prevention of Lithium Deposition on Anodes in high-energy Lithium-ion Batteries - Electrochemical Experiments

Thomas Waldmann et al.

ELECTROCHIMICA ACTA (2015)

添加到收藏夹

Article Electrochemistry

Influence of Cell Design on Temperatures and Temperature Gradients in Lithium-Ion Cells: An In Operando Study

Thomas Waldmann et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2015)

添加到收藏夹

Article Electrochemistry

Impact of Tab Locationon Large Format Lithium-Ion Pouch Cell Based on Fully Coupled Tree-Dimensional Electrochemical-Thermal Modeling

Ahmadou Samba et al.

ELECTROCHIMICA ACTA (2014)

添加到收藏夹

Article Electrochemistry

Effect of thermal contact resistances on fast charging of large format lithium ion batteries

Yonghuang Ye et al.

ELECTROCHIMICA ACTA (2014)

添加到收藏夹

Article Chemistry, Physical

Temperature dependent ageing mechanisms in Lithium-ion batteries - A Post-Mortem study

Thomas Waldmann et al.

JOURNAL OF POWER SOURCES (2014)

添加到收藏夹

Article Electrochemistry

A Mechanical Aging Mechanism in Lithium-Ion Batteries

T. Waldmann et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2014)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

An Explanation of the Ageing Mechanism of Li-Ion Batteries by Metallographic and Material Analysis

S. Gorse et al.

PRAKTISCHE METALLOGRAPHIE-PRACTICAL METALLOGRAPHY (2014)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.