☆ 4.7 Article

Optimizing the heat transfer characteristics of MWCNTs and TiO2 water-based nanofluids through a novel designed pilot-scale setup

SCIENTIFIC REPORTS (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Thermodynamics

Experimental investigation on the performance of hybrid Fe3O4 coated MWCNT/Water nanofluid as a coolant of a Plate heat exchanger

A. M. Alklaibi et al.

Summary: Experimental investigation of MWCNT + Fe3O4/water hybrid nanofluids as a coolant for a plate heat exchanger showed improved exergy efficiency, thermal performance factor, and effectiveness compared to de-ionized water, indicating the potential for enhancing heat transfer efficiency. The study also revealed a tradeoff between flow rate and cost, suggesting that operating at 5 lpm would be the most cost-effective option.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2022)

添加到收藏夹

Article Thermodynamics

Influence of noise barrier and louver on ventilation and thermal performance of wet cooling towers under crosswind conditions

Lei Jiang et al.

Summary: The study found that the noise barrier increased the internal low wind speed area and high temperature area of the wet cooling tower, leading to a decrease in cooling capacity contribution.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Thermal conductivity of water base Ni-np@MWCNT magnetic nanofluid

Samaneh Ebrahimi

Summary: This study experimentally investigated the thermal conductivity behavior of a nanofluid containing nickel nanoparticles inside multiwall carbon nanotubes (Ni-np@MWCNT) under different conditions. The results showed that the thermal conductivity of the nanofluid can be manipulated by the weight percentage of nanoparticles, fluid temperature, and external magnetic field.

MATERIALS RESEARCH BULLETIN (2022)

添加到收藏夹

Article Energy & Fuels

Experimental study of the effect of filled bed type on the performance of a cross-flow cooling tower with the approach of using water-based

Reza Javadpour et al.

Summary: This study experimentally investigates the effects of filled beds on the performance of a cross-flow cooling tower using nanofluids. The results show that using nanofluids instead of water improves the thermal performance of the tower, and the choice of appropriate filled beds and lower flow ratios are crucial for enhancing the tower's performance.

ENERGY REPORTS (2022)

添加到收藏夹

Article Chemistry, Physical

Molecular dynamics study on the adsorption synergy of MWCNTs/MoS2 nanofluids and its influence of internal-cooling grinding surface integrity

Ruitao Peng et al.

Summary: The combination of nanofluids and internal-cooling grinding effectively addressed the issues of heat transfer and lubrication in machining super-alloys, leading to improved surface integrity, reduced grinding temperature, and surface roughness.

APPLIED SURFACE SCIENCE (2021)

添加到收藏夹

Article Thermodynamics

Effect of stabilization method on the natural convection in an inclined cavity filled with MWCNTs/water nanofluids

Asma Samadzadeh et al.

Summary: This study investigated the effect of stabilization methods on natural convection in an inclined cavity filled with MWCNTs/water, finding that the heat transfer coefficient decreases with increasing nanoparticle concentration. Additionally, the impact of changing the Rayleigh number on the Nusselt number was found to be lower than the effect of incrementing the CNT concentration. Moreover, it was observed that changing the inclination angle had a varying effect on the heat transfer coefficient depending on the method of functionalization.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2021)

添加到收藏夹

Article Thermodynamics

Optimizing the effect of concentration and flow rate of water/MWCNTs nanofluid on the performance of a forced draft cross-flow cooling tower

Reza Javadpour et al.

Summary: This study investigates the use of nanofluid in a cross-flow cooling tower to improve performance, finding that lower flow rates are more effective and certain concentrations of nanofluid show higher cooling range and effectiveness compared to pure water. Economic optimization resulted in the optimal concentration and flow rate of 0.07 wt% and 2.249 kg/min, respectively.

ENERGY (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

CO2 capture activity of a novel CaO adsorbent stabilized with (ZrO2+Al2O3+CeO2)-based additive under mild and realistic calcium looping conditions

Mohammad Heidari et al.

Summary: The study focused on developing a novel synthetic adsorbent using the sol-gel autocombustion method, incorporating ZrO2, Al2O3, and CeO2 during the development of CaO adsorbent. The research found that the adsorbent with a molar ratio of 20/1 of calcium precursor to promoters showed the best performance, with the highest sorption capacity and CaO conversion rate. Additionally, the cyclic performance of modified adsorbents was found to be directly proportional to their morphological properties, with CN/20 demonstrating the best overall performance in capturing CO2.

JOURNAL OF CO2 UTILIZATION (2021)

添加到收藏夹

Article Chemistry, Physical

The impact of SiC, Al2O3, and B2O3 abrasive particles and temperature on wear characteristics of 18Ni (300) maraging steel in abrasive flow machining (AFM)

Seyed Shahin Seyedi et al.

Summary: This research investigated the impact of temperature on surface roughness and material removal rate using a one-way abrasive flow machining with SiC, Al2O3, and B2O3 particles as abrasive particles. The findings showed that media containing Al2O3 particles had higher surface roughness, and material removal rate decreased as temperature decreased.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

添加到收藏夹

Article Thermodynamics

Effects of ZnO/water nanofluid on the thermal performance of wet cooling towers

Mehdi Rahmati

Summary: This study investigates the thermal performance of a mechanical draft wet cooling tower using different packing densities and Zinc Oxide (ZnO) nanoparticles. The results show that increasing the number of packing layers and weight concentrations of nanofluid can enhance the tower's performance, with more notable effects when using denser packing materials.

INTERNATIONAL JOURNAL OF REFRIGERATION (2021)

添加到收藏夹

Article Energy & Fuels

Employing a new micro-spray model and (MWCNTs - SWCNTs) - H2O nanofluid on Si-IGBT power module for energy storage: A numerical simulation

M. Gholinia et al.

Summary: This study investigates the effects of using a cooling fluid and micro-sprays to reduce the heat peak of the electrical system. Increasing the volume fraction of nanoparticles can elevate the thermal diffusivity of the fluid and reduce the temperature peak. Using micro spray can create turbulent fluid behavior, leading to hydrodynamic effects prevailing over thermal effects and reducing module temperature.

ENERGY REPORTS (2021)

添加到收藏夹

Article Thermodynamics

Assessment of evaporative cooling process across the mechanically driven cooling tower based on two-point boundary value problem using novel integral technique

A. K. Aadhithiyan et al.

Summary: A novel integral technique based on a two-point boundary value problem for the evaporative cooling process occurring across the mechanically driven counter flow cooling tower is developed and validated in this study. The study reveals that fluid flow ratio and moisture difference ratio have a significant impact on the thermal performance of the cooling tower when considering air and water as the cooling medium and working fluid.

INTERNATIONAL JOURNAL OF REFRIGERATION (2021)

添加到收藏夹

Article Chemistry, Physical

Removal of Neutral Red Dye via Electro-Fenton Process: A Response Surface Methodology Modeling

Masoud Ebratkhahan et al.

Summary: Recycling wastewater for industries and providing future security for humans and the environment are important issues. In this study, the electro-Fenton process was used to remove neutral red dye, showing high decolorization efficiency under specific conditions.

ELECTROCATALYSIS (2021)

添加到收藏夹

Article Engineering, Chemical

The stability, viscosity and thermal conductivity of carbon nanotubes nanofluids with high particle concentration: A surface modification approach

Xiaoke Li et al.

POWDER TECHNOLOGY (2020)

添加到收藏夹

Article Multidisciplinary Sciences

Re-epithelialization and immune cell behaviour in an ex vivo human skin model

Ana Rakita et al.

SCIENTIFIC REPORTS (2020)

添加到收藏夹

Article Thermodynamics

Thermal performance analysis of mechanical draft cooling tower filled with rotational splash type packing by using nanofluids

Mohammad Amini et al.

APPLIED THERMAL ENGINEERING (2020)

添加到收藏夹

Article Chemistry, Physical

Experimental investigation of ZnO nanoparticles effects on thermophysical and tribological properties of diesel oil

Seyed Borhan Mousavi et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

添加到收藏夹

Article Thermodynamics

Experimental investigation of MoS2/diesel oil nanofluid thermophysical and rheological properties

Seyed Borhan Mousavi et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2019)

添加到收藏夹

Article Thermodynamics

Cooling towers performance in a changing climate: Techno-economic modeling and design optimization

Ali Ayoub et al.

ENERGY (2018)

添加到收藏夹

Article Thermodynamics

Experimental investigation of the effect of different nanofluids on the thermal performance of a wet cooling tower using a new method for equalization of ambient conditions

Peyman Imani-Mofrad et al.

ENERGY CONVERSION AND MANAGEMENT (2018)

添加到收藏夹

Article Thermodynamics

Study of environmentally friendly and facile functionalization of graphene nanoplatelet and its application in convective heat transfer

Rad Sadri et al.

ENERGY CONVERSION AND MANAGEMENT (2017)

添加到收藏夹

Article Thermodynamics

Performance enhancement for the natural draft dry cooling tower under crosswind condition by optimizing the water distribution

Xiaoxiao Li et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Thermodynamics

Impact mechanism of different fill layout patterns on the cooling performance of the wet cooling tower with water collecting devices

Dongqiang Lyu et al.

APPLIED THERMAL ENGINEERING (2017)

添加到收藏夹

Article Thermodynamics

Experimental investigation of filled bed effect on the thermal performance of a wet cooling tower by using ZnO/water nanofluid

Peyman Imani-Mofrad et al.

ENERGY CONVERSION AND MANAGEMENT (2016)

添加到收藏夹

Article Thermodynamics

Performance characteristics of a trickle fill in cross- and counter-flow configuration in a wet-cooling tower

P. J. Grobbelaar et al.

APPLIED THERMAL ENGINEERING (2013)

添加到收藏夹

Article Thermodynamics

Experimental research of the cross walls effect on the thermal performance of wet cooling towers under crosswind conditions

Youliang Chen et al.

APPLIED THERMAL ENGINEERING (2011)

添加到收藏夹

Review Thermodynamics

A review of nanofluid stability properties and characterization in stationary conditions

A. Ghadimi et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2011)

添加到收藏夹

Article Thermodynamics

Experimental analysis of heat and mass transfer phenomena in a direct contact evaporative cooling tower

M. Lemouari et al.

ENERGY CONVERSION AND MANAGEMENT (2009)

添加到收藏夹

Article Chemistry, Physical

Zeta-potential measurements of surfactant-wrapped individual single-walled carbon nanotubes

Brian White et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2007)

添加到收藏夹

Article Thermodynamics

A critical investigation into the heat and mass transfer analysis of crossflow wet-cooling towers

JC Kloppers et al.

NUMERICAL HEAT TRANSFER PART A-APPLICATIONS (2004)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.