相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。Design of a Tribo-Simulator for Investigation of the Tribological Behavior of Stainless-Steel Sheets Under Different Contact Conditions
Valmir Dias Luiz et al.
MATERIALS RESEARCH-IBERO-AMERICAN JOURNAL OF MATERIALS (2022)
New Proposal to Calculate the Friction in Sheet Metal Forming Through Bending Under Tension Test
Luis Folle et al.
MATERIALS RESEARCH-IBERO-AMERICAN JOURNAL OF MATERIALS (2019)
Determination of pressure-dependent friction coefficient from draw-bend test and its application to cup drawing
Y. S. Kim et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2012)
Contact pressure evolution at the die radius in sheet metal stamping
Michael P. Pereira et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
Adhesive wear in deep drawing of aluminum sheets
P. Groche et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2008)
Contact pressure evolution and its relation to wear in sheet metal forming
Michael P. Pereira et al.
WEAR (2008)
Simulation of wear on sheet metal forming tools-An energy approach
Kivilcim Ersoy-Nuernberg et al.
WEAR (2008)
A technical note on an experimental device to measure friction coefficient in sheet metal forming
L Fratini et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Bending under tension test with direct friction measurement
JL Andreasen et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2006)
Angle of contact between sheet and die during stretch-bend deformation as determined on the bending-under-tension friction test system
GJ Coubrough et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2002)
Analysis of local loads on the draw die profile with regard to wear using the FEM and experimental investigations
D Hortig et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2001)