☆ 4.7 Article

Numerical study of plastic waste pyrolysis driven by char smoldering

PROCESS SAFETY AND ENVIRONMENTAL PROTECTION (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Thermodynamics

Numerical simulation of coal dust self-ignition and combustion under inclination conditions

Xueqiang Shi et al.

Summary: The study investigates the self-ignition and combustion characteristics of coal dust under inclination conditions using a two-step parallel oxidation reaction mechanism, providing a theoretical basis for the prevention and control of coal dust fires. Experimental results show that the self-ignition and combustion process of coal dust can be divided into five stages and the inclination angle affects the minimum ignition temperature, with coal dust deposited under the ceiling being more easily ignited.

ENERGY (2022)

添加到收藏夹

Article Chemistry, Analytical

Thermal degradation of polyethylene in the presence of a non-acidic porous solid by a continuous flow reactor

Katsuhide Murata et al.

Summary: The presence of porous silicalite during the thermal degradation of polyethylene influences the behavior of polymer macromolecules, favoring chain-end scissions and leading to an increase in the rate of double bonds formation without significantly affecting the mass rate of pyrolysis.

JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS (2022)

添加到收藏夹

Article Engineering, Environmental

Na2CO3 promoted CaO-based heat carrier for thermochemical energy storage in concentrated solar power plants

Yongqing Xu et al.

Summary: This study proposes a novel Na2CO3 modification method to enhance the energy storage density (ESD) of CaO-based materials in a closed-loop CaL-TCES system. The results show that the 10Na(2)CO(3)/CaO exhibits a higher ESD over the cycles, despite sintering. Furthermore, Na2CO3 improves reaction kinetics and may break through mass transfer barriers to absorb CO2.

CHEMICAL ENGINEERING JOURNAL (2022)

添加到收藏夹

Article Engineering, Environmental

Investigation on the co-pyrolysis of agricultural waste and high-density polyethylene using TG-FTIR and artificial neural network modelling

Jishuo Li et al.

Summary: This study investigates the individual pyrolysis and co-pyrolysis characteristics of kidney beans stalk (KS) and high-density polyethylene (HDPE) to realize the utilization of agricultural and plastic waste for alleviating environmental pollution. The results show the occurrence of synergistic and inhibitive effects during co-pyrolysis, with the most significant effect observed at temperatures between 470 and 510 degrees C. The gaseous products of KS pyrolysis mainly consist of oxygen-containing compounds, while those of HDPE pyrolysis mainly consist of hydrocarbons. Co-pyrolysis of samples with different proportions promotes or inhibits the production of certain gaseous products to varying degrees, and the activation energy during co-pyrolysis is lower than that of the pure sample. An artificial neural network (ANN) model is established to effectively predict the mass loss of a sample with temperature.

PROCESS SAFETY AND ENVIRONMENTAL PROTECTION (2022)

添加到收藏夹

Article Engineering, Environmental

Understanding pressure changes in smouldering thermal porous media reactors

Marco A. B. Zanoni et al.

Summary: The use of thermal porous media reactors for environmental applications is increasing, and understanding the pressure increases within these systems is crucial for their success. Numerical modeling and experiments were used to quantify and explain the pressure increases during gas injection into smoldering treatment systems. Additionally, a new method was presented to estimate the maximum bed pressure drop for thermal porous media reactors.

CHEMICAL ENGINEERING JOURNAL (2021)

添加到收藏夹

Article Thermodynamics

Developing a combustion-driven reactor for waste conversion

Joao Vitor F. Duque et al.

Summary: A novel device is proposed in this study to address the high electric energy consumption issue of pyrolysis reactors in industrial applications. Experimental results verified the reliability and positive energy balance characteristics of this device under different operating conditions.

ENERGY (2021)

添加到收藏夹

Article Energy & Fuels

Impacts of Anisotropic Porosity on Heat Transfer and Off-Gassing during Biomass Pyrolysis

M. Brennan Pecha et al.

Summary: The study explores the impact of implementing anisotropic permeability and diffusivity on the conversion time and yields predicted for pyrolysis of oak and pine particles using a biomass single particle model. It shows that anisotropic permeability significantly affects predicted conversion time when certain nondimensional numbers are met. Additionally, the pore structure can have a significant impact on pyrolytic conversion time, especially in the conduction controlled regime.

ENERGY & FUELS (2021)

添加到收藏夹

Article Thermodynamics

Glycine tailored effective CaO-based heat carriers for thermochemical energy storage in concentrated solar power plants

Yongqing Xu et al.

Summary: Organic acid-modified CaO-based heat carriers show promising thermochemical energy storage performance in a closed-loop CaLP-TCES system, with glycine-modified eggshell exhibiting the highest energy storage capacity after repeated cycles at high temperatures. The rich mesoporous and macroporous structure generated in the materials after glycine modification significantly improves cyclic thermochemical energy storage performance.

ENERGY CONVERSION AND MANAGEMENT (2021)

添加到收藏夹

Article Energy & Fuels

Modelling plastic heating and melting in a semi-batch pyrolysis reactor

Shawki Mazloum et al.

Summary: Plastic pyrolysis, as a method to convert plastic waste into fuels and chemicals, has been widely validated and applied at the lab scale, but there is limited literature on numerical modeling and optimization for industrial implementation. This study models and validates the heating and melting phenomena of plastics inside a semi-batch reactor using finite element method, laying the foundation for modeling the entire pyrolysis process.

APPLIED ENERGY (2021)

添加到收藏夹

Article Energy & Fuels

Simulation-assisted design of a catalytic hydrogenation reactor for plastic pyrolysis fuels

Alberto Gala et al.

Summary: The study designed a pilot catalytic hydrotreatment reactor using computational fluid dynamics and considered factors such as fluid flows, gas diffusion, reactions, and heat transfer. The results showed that adjusting the inlet gas temperature and refrigerant oil flow can optimize the system and minimize energy costs. Working at intermediate pressures and increasing H-2 supply can also help avoid condensation in the reactive chamber.

FUEL (2021)

添加到收藏夹

Article Chemistry, Applied

Numerical study on the oxidation reaction characteristics of coal under temperature-programmed conditions

Xueqiang Shi et al.

Summary: The research shows that the reaction between coal and oxygen is influenced by temperature and oxygen concentration, increasing the volume fraction of oxygen and heating rate can promote the reaction between coal and oxygen, and reduce the heating effects under external heating conditions. Therefore, controlling temperature storage conditions can prevent the oxidation reaction of coal, while changing oxygen supply conditions can control the development of coal spontaneous combustion.

FUEL PROCESSING TECHNOLOGY (2021)

添加到收藏夹

Review Thermodynamics

Co-pyrolysis of waste plastic and solid biomass for synergistic production of biofuels and chemicals-A review

Zhiwei Wang et al.

Summary: The study focuses on co-pyrolysis of waste plastic and solid biomass mixtures, which can provide synergistic enhancement for fuels and value-added products, and foster eco-friendly pathways for waste management and sustainability. The paper discusses the properties of different feedstocks and experimental methods for co-pyrolysis, as well as characteristics of co-pyrolysis reactors and catalytic methods.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2021)

添加到收藏夹

Article Engineering, Environmental

Assessment of a detailed biomass pyrolysis kinetic scheme in multiscale simulations of a single-particle pyrolyzer and a pilot-scale entrained flow pyrolyzer

Xi Gao et al.

Summary: In this study, a detailed kinetic scheme of biomass pyrolysis was assessed in multiscale simulations of a single-particle pyrolyzer and a pilot-scale entrained flow pyrolyzer. The simulations indicated that nonisothermal particles matched experimental data better than isothermal particles, providing insights into biomass pyrolysis kinetics development and pyrolyzer multiscale simulation for future studies.

CHEMICAL ENGINEERING JOURNAL (2021)

添加到收藏夹

Article Thermodynamics

Pyrolysis of waste polyethylene in a semi-batch reactor to produce liquid fuel: Optimization of operating conditions

Ruming Pan et al.

Summary: This study investigated the interactive effects of temperature, residence time, and carrier gas flow rate on liquid fuel production through the pyrolysis of waste polyethylene (WPE). Experimental results showed a high predictive accuracy of the adaptive neural fuzzy model, and optimization using genetic algorithm maximized liquid fuel production under the optimal operating conditions.

ENERGY CONVERSION AND MANAGEMENT (2021)

添加到收藏夹

Article Thermodynamics

Modelling pyrolysis process for PP and HDPE inside thermogravimetric analyzer coupled with differential scanning calorimeter

Shawki Mazloum et al.

Summary: This study aims to model the plastic pyrolysis process at particle scale for polypropylene and high density polyethylene, using kinetic triplets and appropriate conditions in a thermogravimetric analyzer. The results show that modeling the melting sub-process using the modified apparent heat capacity method, and dividing the cracking phenomena into latent and apparent processes, can help control the error between simulated and measured results at a low level.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2021)

添加到收藏夹

Article Engineering, Environmental

Characteristics of coal dust ignited by a hot particle

Xueqiang Shi et al.

Summary: This study investigated the coupling details of multi-physical fields of ignition of coal dust caused by hot particles, including the effects of different particle temperatures and contact conditions. Results demonstrated two ways of ignition, volatiles ignition and coal smoldering ignition, with ignition delay time increasing exponentially as hot particle temperature decreases. The interaction between temperature, volatiles molar concentration, and heat release characteristics was examined under various conditions, providing insights into the mechanism and process of the ignition.

PROCESS SAFETY AND ENVIRONMENTAL PROTECTION (2021)

添加到收藏夹

Article Engineering, Chemical

CFD simulation of combustible solid waste pyrolysis in a fluidized bed reactor

Kuan Ding et al.

POWDER TECHNOLOGY (2020)

添加到收藏夹

Review Materials Science, Multidisciplinary

Plasma spray-physical vapor deposition toward advanced thermal barrier coatings: a review

Mei-Jun Liu et al.

RARE METALS (2020)

添加到收藏夹

Article Green & Sustainable Science & Technology

Economic performance of pyrolysis of mixed plastic waste: Open-loop versus closed-loop recycling

Macarena Larrain et al.

JOURNAL OF CLEANER PRODUCTION (2020)

添加到收藏夹

Editorial Material Multidisciplinary Sciences

Creating value from plastic waste

Bert M. Weckhuysen

SCIENCE (2020)

添加到收藏夹

Article Thermodynamics

Experimental and numerical investigation of weak, self-sustained conditions in engineered smouldering combustion

Marco A. B. Zanoni et al.

COMBUSTION AND FLAME (2020)

添加到收藏夹

Review Thermodynamics

Processes defining smouldering combustion: Integrated review and synthesis

Jose L. Torero et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2020)

添加到收藏夹

Article Thermodynamics

The role of local thermal non-equilibrium in modelling smouldering combustion of organic liquids

Marco A. B. Zanoni et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)

添加到收藏夹

Article Thermodynamics

Delineating and explaining the limits of self-sustained smouldering combustion

Marco A. B. Zanoni et al.

COMBUSTION AND FLAME (2019)

添加到收藏夹

Article Chemistry, Analytical

Catalytic degradation of linear low-density polyethylene over HY-zeolite via pre-degradation method

Ishaka Muhammad et al.

JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS (2019)

添加到收藏夹

Article Thermodynamics

Heat Transfer Modeling of a High-Temperature Porous-Medium Filled Solar Thermochemical Reactor for Hydrogen and Synthesis Gas Production

Ruming Pan et al.

JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2019)

添加到收藏夹

Article Engineering, Environmental

Effect of lignin, cellulose and hemicellulose on calcium looping behavior of CaO-based sorbents derived from extrusion-spherization method

Yongqing Xu et al.

CHEMICAL ENGINEERING JOURNAL (2018)

添加到收藏夹

Article Thermodynamics

Darcy Scale Modeling of Smoldering: Impact of Heat Loss

Victor Pozzobon et al.

COMBUSTION SCIENCE AND TECHNOLOGY (2017)

添加到收藏夹

Article Engineering, Chemical

Smoldering Combustion in Oil Shales: Influence of Calcination and Pyrolytic Reactions

Mustafa Elayeb et al.

TRANSPORT IN POROUS MEDIA (2017)

添加到收藏夹

Article Thermodynamics

Determination of the interfacial heat transfer coefficient between forced air and sand at Reynold's numbers relevant to smouldering combustion

Marco A. B. Zanoni et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)

添加到收藏夹

Article Thermodynamics

The role of gasification reactions during pulverized solid fuel combustion: A detailed char combustion model based on measurements of char structure and kinetics for coal and pre-treated biomass

Ulrich Kleinhans et al.

COMBUSTION AND FLAME (2017)

添加到收藏夹

Review Thermodynamics

A review on pyrolysis of plastic wastes

Shafferina Dayana Anuar Sharuddin et al.

ENERGY CONVERSION AND MANAGEMENT (2016)

添加到收藏夹

Article Engineering, Environmental

Simulation of an innovative reactor for waste plastics pyrolysis

L. J. Yin et al.

CHEMICAL ENGINEERING JOURNAL (2014)

添加到收藏夹

Article Energy & Fuels

Modelling of non-consolidated oil shale semi-coke forward combustion: Influence of carbon and calcium carbonate contents

Hossein Fadaei et al.

FUEL (2012)

添加到收藏夹

Article Chemistry, Multidisciplinary

Catalytic degradation of polyethylene over ferrierite

Hyun Ju Park et al.

RESEARCH ON CHEMICAL INTERMEDIATES (2008)

添加到收藏夹

Article Chemistry, Analytical

Using isothermal kinetic results to estimate the kinetic triplet of the pyrolysis of high density polyethylene

S Kim et al.

JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS (2005)

添加到收藏夹

Article Chemistry, Analytical

Kinetics of pyrolysis of high density polyethylene. Comparison of isothermal and dynamic experiments

J Ceamanos et al.

JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS (2002)

添加到收藏夹

Article Thermodynamics

The combustion of simulated waste particles in a fixed bed

D Shin et al.

COMBUSTION AND FLAME (2000)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.