4.7 Article

Correlation between microstructural evolution and corrosion resistance of hypoeutectic Al-Si-Mg alloy: Influence of corrosion product layer

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Engineering, Civil

The influence of AlSi10Mg recycled powder on corrosion-resistance behaviour of additively manufactured components: mechanical aspects and acoustic emission investigation

Claudia Barile et al.

Summary: This study analyzed the effects of using recycled powders on the mechanical properties and corrosion-resistance behavior of components manufactured via selective laser melting (SLM). The results showed that the utilization of recycled powders led to coarsening of the interdendritic Si-network, but had almost no influence on the corrosion behavior in terms of surface roughness, density, and porosity. Additionally, the acoustic emission (AE) technique was used to investigate the impact of powders on corrosion performance, and a good correlation was found between corrosion resistance and AE test results. The mechanical properties of samples produced using both virgin and recycled powders were comparable, and no notable influence of exposure to a corrosive environment was observed.

ARCHIVES OF CIVIL AND MECHANICAL ENGINEERING (2022)

Article Materials Science, Multidisciplinary

Recycling of additive manufactured AlSi10Mg and its effect on mechanical properties

Mert Coskun et al.

Summary: Energy savings and sustainability are critical for economic development, and recycling of aluminum has been a long-studied area. In recent years, additive manufacturing (AM) of aluminum has gained popularity due to its advantages such as flexible geometry and no design limits. This study compared the properties of recycled AM aluminum with both AM and cast alloy, and conducted statistical analysis to characterize the changes. The results showed that the yield strength decreased in recycled AM, while the ultimate tensile strength values were similar to the cast alloy. The average elongation at fracture for recycled AM was higher than the cast alloy, but the reliability and reproducibility were lower compared to the cast alloy.

MATERIALS CHEMISTRY AND PHYSICS (2022)

Article Materials Science, Multidisciplinary

Effect of aging treatment on microstructure and corrosion behavior of Al-Zn-Mg aluminum alloy in aqueous solutions with different aggressive ions

Pan Liu et al.

Summary: The microstructure and corrosion behavior of Al-Zn-Mg alloy after natural aging treatment (NAT) and artificial aging treatment (AAT) in aqueous NaCl solutions with different aggressive ions were studied. Results showed that AAT improved corrosion resistance compared to NAT, with noticeable differences in grain size and precipitates.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)

Article Materials Science, Multidisciplinary

Ultra-high corrosion resistance of Al-Mg-Si film on steel sheet formed by PVD Mg coating and heat treatment

Gi-Dong Park et al.

Summary: Alloy films with excellent corrosion resistance were fabricated by depositing an Mg film on Al-Si coated steel sheets and applying heat treatment. The Mg in the film was widely distributed in a dissolved state on the AI phase and continuously involved in the corrosion product formation reaction, leading to the excellent barrier effect against corrosion factors. The corrosion resistance evaluation results were explained by analyzing the properties of the alloy film and the mechanism of forming corrosion products.

CORROSION SCIENCE (2021)

Review Automation & Control Systems

A review on direct hot extrusion technique in recycling of aluminium chips

Abdullah Wagiman et al.

INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2020)

Article Chemistry, Physical

Impact of rare earth compounds on corrosion of aluminum alloy (AA6061) in the marine water environment

M. A. Deyab et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Article Nanoscience & Nanotechnology

Effect of Mg content on age-hardening response, tensile properties, and microstructures of a T5-treated thixo-cast hypoeutectic Al-Si alloy

K. Yamamoto et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

Article Chemistry, Physical

Structural and electron-optical properties of transparent nanocrystalline MgAl2O4 spinel implanted with copper ions

A. F. Zatsepin et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Article Materials Science, Multidisciplinary

Electrochemical corrosion behavior of 2A02 Al alloy under an accelerated simulation marine atmospheric environment

Min Cao et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2019)

Article Materials Science, Multidisciplinary

The effect of grain size and grain boundary misorientation on the corrosion resistance of commercially pure aluminium

Marta Orlowska et al.

CORROSION SCIENCE (2019)

Article Chemistry, Physical

Corrosion performance of high pressure die-cast Al-Si-Mg-Zn alloys in 3.5 wt% NaCl solution

Srinivasan Arthanari et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Article Materials Science, Multidisciplinary

Improved Corrosion Resistance of 5XXX Aluminum Alloy by Homogenization Heat Treatment

In-Kyu Choi et al.

COATINGS (2018)

Article Materials Science, Multidisciplinary

Characterization of intergranular corrosion defects in a 2024 T351 aluminium alloy

Marie-Laetitia de Bonfils-Lahovary et al.

CORROSION SCIENCE (2017)

Article Materials Science, Multidisciplinary

3D study of intermetallics and their effect on the corrosion morphology of rheocast aluminium alloy

B. Mingo et al.

MATERIALS CHARACTERIZATION (2016)

Article Materials Science, Multidisciplinary

Effects of various Mg/Si ratios on microstructure and performance property of Al-Mg-Si alloy cables

Xuexuan Xu et al.

MATERIALS CHARACTERIZATION (2016)

Article Materials Science, Multidisciplinary

Pitting corrosion of rheocast A356 aluminium alloy in 3.5 wt.% NaCl solution

R. Arrabal et al.

CORROSION SCIENCE (2013)

Article Materials Science, Multidisciplinary

Microstructural Evolution during Partial Remelting of Al-Si Alloys Containing Different Amounts of Magnesium

A. Abedi et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2013)

Article Materials Science, Multidisciplinary

Influence of Silicon on Intergranular Corrosion for Aluminum Alloys

Yoshiyuki Oya et al.

MATERIALS TRANSACTIONS (2013)

Article Materials Science, Multidisciplinary

Effect of Nd on the corrosion behaviour of AM50 and AZ91D magnesium alloys in 3.5 wt.% NaCl solution

R. Arrabal et al.

CORROSION SCIENCE (2012)

Article Electrochemistry

Electrochemical Behavior and Localized Corrosion Associated with Mg2Si Particles in Al and Mg Alloys

R. K. Gupta et al.

ECS ELECTROCHEMISTRY LETTERS (2012)

Article Metallurgy & Metallurgical Engineering

Corrosion mechanism associated with Mg2Si and Si particles in Al-Mg-Si alloys

Zeng Feng-li et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2011)

Article Electrochemistry

Effect of Excess Silicon and Small Copper Content on Intergranular Corrosion of 6000-Series Aluminum Alloys

Magnus Hurlen Larsen et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2010)

Article Materials Science, Multidisciplinary

Addition of iron for the removal of the β-AlFeSi intermetallic by refining of α-AlFeSi phase in an Al-7.5Si-3.6Cu alloy

S. Belmares-Perales et al.

MATERIALS SCIENCE AND ENGINEERING B-ADVANCED FUNCTIONAL SOLID-STATE MATERIALS (2010)

Article Multidisciplinary Sciences

Greenhouse-gas emission targets for limiting global warming to 2 °C

Malte Meinshausen et al.

NATURE (2009)

Article Electrochemistry

Role of intermetallic phases in localized corrosion of AA5083

Kiryl A. Yasakau et al.

ELECTROCHIMICA ACTA (2007)

Article Nanoscience & Nanotechnology

Effect of metallurgical parameters on the hardness and microstructural characterization of as-cast and heat-treated 356 and 319 aluminum alloys

M. Tash et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

Review Chemistry, Applied

Electrodeposition of silane films on aluminum alloys for corrosion protection

Ji-Ming Hu et al.

PROGRESS IN ORGANIC COATINGS (2007)

Article Materials Science, Multidisciplinary

Sequence of steps in the pitting of aluminum by chloride ions

E McCafferty

CORROSION SCIENCE (2003)

Article Materials Science, Multidisciplinary

Solidification and precipitation behaviour of Al-Si-Mg casting alloys

QG Wang et al.

JOURNAL OF MATERIALS SCIENCE (2001)