☆ 4.4 Article

Effect of chloride threshold on pitting behavior of 316LN stainless steel in sour water solution by electrochemical analysis

MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Multidisciplinary

Point defect model for passivity breakdown on hyper-duplex stainless steel 2707 in solutions containing bromide at different temperatures

Li Sun et al.

Summary: Passivity breakdown on HDSS 2707 has been studied and interpreted using the Point Defect Model. Pitting parameters of HDSS 2707, such as polarizability at bl/s interface, defect annihilation rate, and defect diffusion coefficient, have been determined. The breakdown potential is shown to have linear relationships with log [Br-], pH, and the square root of potential scan rate (v1/2), following a near-normal distribution. The critical vacancy concentration calculated from the PDM aligns with crystallographic estimates from the chromic barrier layer, and the dominant point defect is confirmed through Mott-Schottky measurements.

CORROSION SCIENCE (2022)

添加到收藏夹

Article Engineering, Mechanical

Failure analysis of anion synergy on pitting behavior of liner 316L in sour water system by electrochemical tests

Kuijiao Li et al.

Summary: Electrochemical tests were conducted to investigate the synergistic effects of chloride, sulfate, and carbonate ions on pitting. The results revealed that sulfate ions initially increased the pitting potential of 316L, reaching a peak at 0.2 M concentration, before decreasing. At this concentration, the highest critical pitting temperature, breakdown potential, and maximum impedance were obtained. On the other hand, carbonate ions increased the pitting potential but accelerated the general corrosion of the 316L surface. The study proposed an effective adsorption area based on the competitive adsorption mechanism to explain the pitting and passivation behaviors of 316L, and comprehensively analyzed the properties of the passive film.

ENGINEERING FAILURE ANALYSIS (2022)

添加到收藏夹

Article Engineering, Mechanical

Failure analysis and experimental verification on the hydrogen-driven pitting corrosion of heat exchanger tube material

Dong Liu et al.

Summary: This study experimentally analyzed and verified the effect of hydrogen on the failure of heat exchanger tube material. The results showed that hydrogen significantly decreased the charge transfer resistance and the pitting potential, while increasing the densities of point defects in the passive film. This increased the pitting corrosion susceptibility and weakened the corrosion resistance of the material during hydrocracking, leading to failure.

ENGINEERING FAILURE ANALYSIS (2022)

添加到收藏夹

Article Materials Science, Multidisciplinary

Pitting of carbon steel in the synthetic concrete pore solution

Digby D. Macdonald et al.

Summary: Pitting corrosion is a possible mode of failure of the carbon steel overpack in the Belgian supercontainer concept for the isolation of high-level nuclear waste. Stabilization via differential aeration produces a potentially damaging, stable pit. However, analysis of experimental data and mechanistic research suggest that failure of the carbon steel overpack containing high-level nuclear waste over a storage horizon of 100,000 years is improbable.

MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Localized corrosion: Passive film breakdown vs. Pit growth stability, Part VI: Pit dissolution kinetics of different alloys and a model for pitting and repassivation potentials

Tianshu Li et al.

Summary: The study found a correlation between idiss,max and pitting and repassivation potentials, with lower idiss,max correlating with higher pitting and repassivation potentials. A conceptual model based on a recently proposed pitting framework was established to discuss the effect of idiss,max on pitting resistance.

CORROSION SCIENCE (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion of rebar in concrete. Part IV. On the theoretical basis of the chloride threshold

Digby D. Macdonald et al.

Summary: The theory developed calculates the chloride threshold (CT) using the Point Defect Model (PDM), with CT defined as the ratio [Cl- ]/[OH- ] where passivity breakdown voltage (Eb) equals corrosion potential, ECP. CT is sensitive to temperature, ECP, pH, and Eb, emphasizing the need for accurate data. The theory is demonstrated by successfully calculating CT for selected systems.

CORROSION SCIENCE (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion of rebar in concrete. Part III: Artificial Neural Network analysis of chloride threshold data

Yakun Zhu et al.

Summary: An approach combining KSOM and ANN was developed to find missing values of independent variables in a sparse database and quantitatively evaluate their effects on CT values.

CORROSION SCIENCE (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Point defect model for the corrosion of steels in supercritical water: Part I, film growth kinetics

Yanhui Li et al.

CORROSION SCIENCE (2020)

添加到收藏夹

Article Environmental Sciences

A corrosion evaluation of mild carbon steel in reclaimed refinery stripped sour water

Pedro D. A. Bastos et al.

JOURNAL OF ENVIRONMENTAL MANAGEMENT (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion of rebar in concrete. Part I: Calculation of the corrosion potential in the passive state

Digby D. Macdonald et al.

CORROSION SCIENCE (2020)

添加到收藏夹

Article Electrochemistry

Corrosion behavior of carbon steel in dilute ammonia solution

Li Sun et al.

ELECTROCHIMICA ACTA (2020)

添加到收藏夹

Article Electrochemistry

Synergistic effect of cold work and hydrogen charging on the pitting susceptibility of 2205 duplex stainless steel

Liqiang Yin et al.

ELECTROCHIMICA ACTA (2019)

添加到收藏夹

Article Chemistry, Multidisciplinary

The aggression behavior study of Cl- on the defect structure of passive films on copper

Aoni Xu et al.

RSC ADVANCES (2019)

添加到收藏夹

Article Electrochemistry

The Critical Pitting Chloride Concentration of Various Stainless Steels Measured by an Electrochemical Method

Xuan Wu et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2018)

添加到收藏夹

Article Materials Science, Multidisciplinary

Growth kinetics of metastable pits on sputtered nanocrystalline stainless steel

Tianshu Li et al.

CORROSION SCIENCE (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

Corrosion of AlxCoCrFeNi high-entropy alloys: Al-content and potential scan-rate dependent pitting behavior

Yunzhu Shi et al.

CORROSION SCIENCE (2017)

添加到收藏夹

Article Engineering, Mechanical

Corrosion investigation of the inlet section of REAC pipes in the refinery

Li Sun et al.

ENGINEERING FAILURE ANALYSIS (2016)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effects of Mo and Mn on Pitting Behavior of Duplex Stainless Steel

Li-cong An et al.

JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL (2016)

添加到收藏夹

Article Electrochemistry

The Kinetics of Nucleation of Metastable Pits on Metal Surfaces: The Point Defect Model and Its Optimization on Data Obtained on Stainless Steel, Carbon Steel, Iron, Aluminum and Alloy-22

Pin Lu et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2016)

添加到收藏夹

Review Materials Science, Multidisciplinary

Density functional theory (DFT) as a powerful tool for designing new organic corrosion inhibitors. Part 1: An overview

I. B. Obot et al.

CORROSION SCIENCE (2015)

添加到收藏夹

Article Materials Science, Multidisciplinary

Passivity: enabler of our metals based civilisation

D. D. Macdonald

CORROSION ENGINEERING SCIENCE AND TECHNOLOGY (2014)

添加到收藏夹

Article Materials Science, Multidisciplinary

Metastable pitting corrosion of 304 stainless steel in 3.5% NaCl solution

Wenming Tian et al.

CORROSION SCIENCE (2014)

添加到收藏夹

Review Materials Science, Multidisciplinary

Application of corrosion inhibitors for steels in acidic media for the oil and gas industry: A review

Matjaz Finsgar et al.

CORROSION SCIENCE (2014)

添加到收藏夹

Review Chemistry, Multidisciplinary

Corrosion problems during oil and gas production and its mitigation

Lekan Taofeek Popoola et al.

INTERNATIONAL JOURNAL OF INDUSTRIAL CHEMISTRY (2013)

添加到收藏夹

Article Materials Science, Multidisciplinary

Study of the correlation between corrosion resistance and semi-conducting properties of the passive film of AISI 316L stainless steel in physiological solution

R. A. Antunes et al.

MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION (2012)

添加到收藏夹

Article Engineering, Mechanical

Prediction of ammonium salt deposition in hydroprocessing air cooler tubes

Guofu Ou et al.

ENGINEERING FAILURE ANALYSIS (2011)

添加到收藏夹

Article Materials Science, Multidisciplinary

Passivity of 316L stainless steel in borate buffer solution studied by Mott-Schottky analysis, atomic absorption spectrometry and X-ray photoelectron spectroscopy

Zhicao Feng et al.

CORROSION SCIENCE (2010)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effects of rare earth metals addition on the resistance to pitting corrosion of super duplex stainless steel - Part 1

Soon-Tae Kim et al.

CORROSION SCIENCE (2010)

添加到收藏夹

Article Engineering, Mechanical

Failure investigation of heat exchanger plates due to pitting corrosion

K. M. Deen et al.

ENGINEERING FAILURE ANALYSIS (2010)

添加到收藏夹

Article Multidisciplinary Sciences

Properties of passive film formed on 316L/2205 stainless steel by Mott-Schottky theory and constant current polarization method

Cheng XueQun et al.

CHINESE SCIENCE BULLETIN (2009)

添加到收藏夹

Article Materials Science, Multidisciplinary

Two-part epoxy-siloxane hybrid corrosion protection coatings for carbon steel

Min Qian et al.

THIN SOLID FILMS (2009)

添加到收藏夹

Article Materials Science, Multidisciplinary

The passivity of Type 316L stainless steel in borate buffer solution

Igor Nicic et al.

JOURNAL OF NUCLEAR MATERIALS (2008)

添加到收藏夹

Article Chemistry, Multidisciplinary

Flat-band potential of a semiconductor: using the Mott-Schottky equation

K. Gelderman et al.

JOURNAL OF CHEMICAL EDUCATION (2007)

添加到收藏夹

Article Electrochemistry

Reflections on the history of electrochemical impedance spectroscopy

DD Macdonald

ELECTROCHIMICA ACTA (2006)

添加到收藏夹

Article Electrochemistry

Chloride threshold dependence of pitting potential of reinforcements

C Alonso et al.

ELECTROCHIMICA ACTA (2002)

添加到收藏夹

Article Materials Science, Multidisciplinary

Pit growth studies in stainless steel foils. I. Introduction and pit growth kinetics

P Ernst et al.

CORROSION SCIENCE (2002)

添加到收藏夹

Article Materials Science, Multidisciplinary

Pit growth studies in stainless steel foils. II. Effect of temperature, chloride concentration and sulphate addition

P Ernst et al.

CORROSION SCIENCE (2002)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.