☆ 4.4 Article

Detecting Quench in HTS Magnets With LTS Wires-A Theoretical and Numerical Analysis

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Electrical & Electronic

Co-Wound Superconducting Wire for Quench Detection in Fusion Magnets

N. Bykovskiy et al.

Summary: High temperature superconducting materials are commonly used in fusion magnet design proposals, but reliable quench detection in HTS conductors remains a challenge. Using high normal state resistance superconducting wire as a sensor can improve sensitivity for voltage-based quench detection methods. Different wire options can be adapted for fusion conductors, allowing for flexibility in design and experimental verification of the method.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2022)

添加到收藏夹

Article Physics, Applied

Fiber optic quench detection for large-scale HTS magnets demonstrated on VIPER cable during high-fidelity testing at the SULTAN facility

Erica E. Salazar et al.

Summary: The study demonstrates that fiber Bragg grating (FBG) and ultra-long FBG (ULFBG) can quickly and reliably detect small temperature disturbances that induce quench initiation events in high current VIPER HTS conductors under realistic operating conditions, exhibiting strong signal-to-noise ratios and single-digit temperature excursions.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Quench Detection Performance of Low-Temperature Superconducting Quench Detectors for REBCO Tape in Magnetic Fields

Shin Hasegawa et al.

Summary: A quench detection method using a low-temperature superconducting quench detector (QD) has been proposed to protect rare-earth barium copper oxide (REBCO) coils in magnetic fields at temperatures below 20 K. Experimental results showed that the Nb-Ti/Cu-Ni QD could achieve quick quench detection before the thermal runaway of the REBCO tape at 0-9 T, while the Nb-Ti/Cu QD only exhibited this capability at 9 T. Numerical evaluation also confirmed the feasibility of quench detection time with Nb-Ti QDs attached to a locally degraded REBCO tape at 4.2 K in 0-9 T, with a requirement for the contact resistance to be lower than 1.0 x 10(-3) m(2)K/W for quick quench detection.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Study of a Current-Based Quench Detection Method for CCT Magnets via a Co-Wound Superconducting Sensing Wire

Jiani Gao et al.

Summary: This paper introduces a current-based quench detection method for Nb-3 Sn CCT type accelerator magnets, which uses a co-wound superconducting wire and current derivative sensor in the magnet. The detection system relies on the drop in current during a quench to detect the quench, and the advantages and limitations of this method are discussed.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2021)

添加到收藏夹

Review Physics, Applied

Superconductors for fusion: a roadmap

Neil Mitchell et al.

Summary: With ITER and JT60SA well into final assembly and commissioning respectively, nuclear fusion is becoming a mainstream potential energy source for the future. The viability of magnetic confinement for fusion heavily relies on superconductor technology, and the experience gained from these projects is contributing to the development of commercial fusion reactors using new and improved superconducting materials.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Conceptual Design of HTS Bitter Magnet Above 25T Using a Fast Magnetic Field Computational Method

Lingfeng Zhu et al.

Summary: A novel HTS Bitter magnet structure is proposed with REBCO annular plates with slits soldered at the edges, Experimentally, the resistance of the soldering joint is proven to be small enough to control current distribution. The magnetic field and stress distribution of the magnet are calculated using a fast computational method based on a CNN, and the feasibility of the structure and efficiency of the algorithm are experimentally verified on a model magnet.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2021)

添加到收藏夹

Article Physics, Multidisciplinary

A new quench detection method for HTS magnets: stray-capacitance change monitoring

E. Ravaioli et al.

PHYSICA SCRIPTA (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

Research on Quench Detection Method Using Radio Frequency Wave Technology

Bin Chen et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

Quench Simulation of REBCO Cable-in-Conduit Conductor With Twisted Stacked-Tape Cable

Rui Kang et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2020)

添加到收藏夹

Article Physics, Applied

Fluorescent thermal imaging of a quench in insulated and non-insulated REBCO-wound pancake coils following a heater pulse at 77K

R. Gyuraki et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2020)

添加到收藏夹

Article Nuclear Science & Technology

Distributed optical fiber sensor for investigation of normal zone propagation and hot spot location in REBCO cables

Bin Chen et al.

FUSION ENGINEERING AND DESIGN (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

Acoustic MEMS Sensor Array for Quench Detection of CICC Superconducting Cables

Makoto Takayasu

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2020)

添加到收藏夹

Article Physics, Applied

Feasibility study of optical fiber sensor applied on HTS conductors

Kao Zhou et al.

PHYSICA C-SUPERCONDUCTIVITY AND ITS APPLICATIONS (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

The 40 T Superconducting Magnet Project at the National High Magnetic Field Laboratory

Hongyu Bai et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

Fundamental Evaluations of Applicability of LTS Quench Detectors to REBCO Pancake Coil

Shin Hasegawa et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2019)

添加到收藏夹

Article Engineering, Electrical & Electronic

A Numerical Study of Quench in the NHMFL 32 T Magnet

Lorenzo Cavallucci et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2019)

添加到收藏夹

Article Engineering, Electrical & Electronic

Numerical and Experimental Evaluations of the Quench Detection Performance of an YBCO/Nb-Tid Tape

Shin Hasegawa et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2018)

添加到收藏夹

Article Engineering, Electrical & Electronic

Characterization of HTS Insulated Coil for High Field Insert up to 19 T

T. Benkel et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2018)

添加到收藏夹

Article Physics, Applied

Quench detection for high temperature superconductor magnets: a novel technique based on Rayleigh-backscattering interrogated optical fibers

F. Scurti et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2016)

添加到收藏夹

Article Physics, Applied

Critical current densities and n-values of MgB2 strands over a wide range of temperatures and fields

G. Z. Li et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2012)

添加到收藏夹

Article Physics, Applied

Scaling law for the strain dependence of the critical current in an advanced ITER Nb3Sn strand

Y. Ilyin et al.

SUPERCONDUCTOR SCIENCE & TECHNOLOGY (2007)

添加到收藏夹

Article Physics, Applied

The index n of the voltage-current curve, in the characterization and specification of technical superconductors

P Bruzzone

PHYSICA C-SUPERCONDUCTIVITY AND ITS APPLICATIONS (2004)

添加到收藏夹

Article Thermodynamics

A general model for thermal, hydraulic and electric analysis of superconducting cables

L Bottura et al.

CRYOGENICS (2000)

添加到收藏夹

Article Engineering, Electrical & Electronic

A practical fit for the critical surface of NbTi

L Bottura

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2000)

添加到收藏夹

Article Engineering, Electrical & Electronic

Field and temperature dependences of critical current density in rapid quenched and transformed Nb3Al multifilamentary conductors

N Banno et al.

IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY (2000)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.