☆ 4.7 Article

Development and Evaluation of Temperature Sensing Smart Skin for High-Temperature Measurements in Pipes

IEEE SENSORS JOURNAL (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Ceramics

Influence of substrate temperature on the microstructure of YSZ films and their application as the insulating layer of thin film sensors for harsh temperature environments

Hao Liu et al.

Summary: The electrical insulation characteristics of a YSZ/Al2O3 multilayer insulating structure were investigated for the purpose of improving the insulation properties and adhesion of thin film sensors used to monitor the health of hot-section components of aeroengine intelligence. The results showed that the YSZ thin film with compact and uniform topography significantly enhanced the insulation resistance of the multilayer insulating structure. The YSZ/Al2O3 multilayer insulating structure was found to be suitable for thin film sensors, as demonstrated by the low relative resistance error.

CERAMICS INTERNATIONAL (2022)

添加到收藏夹

Article Nuclear Science & Technology

Diagnosing nuclear power plant pipe wall thinning due to flow accelerated corrosion using a passive, thermal non-destructive evaluation method: Feasibility assessment via numerical experiments

Chris Nash et al.

Summary: The proposed method utilizes pipe surface temperature measurements to passively monitor for FAC-induced pipe wall thinning, without the need for expensive equipment or post-installation setup time.

NUCLEAR ENGINEERING AND DESIGN (2022)

添加到收藏夹

Article Engineering, Mechanical

Influence of inlet swirl on pattern factor and pressure loss in an aero engine combustor

K. V. L. Narayana Rao et al.

Summary: The study investigates the impact of the compressor exit swirl angle on the exit temperature non-uniformity and combustor total pressure loss in an aero engine combustor. Experimental validation and simulation analysis are conducted to analyze the effect of swirl angle on the combustor pattern factor and pressure loss. The results show that the swirl angle variation affects both the pattern factor and total pressure loss of the combustor, with the lowest pattern factor occuring at 10 degrees swirl angle.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2022)

添加到收藏夹

Article Nuclear Science & Technology

Large-eddy simulation on thermal-mixing experiment at horizontal T-junction with varied flow temperature

Mi Zhou et al.

Summary: This study investigates the thermal fatigue damage mechanism in a thermal-mixing pipe-flow close to a mixing tee. Numerical simulations and experiments were conducted to understand the effects of temperature difference on the damage potential. The study also identifies a new mixing phenomenon, tangential oscillation of thermal stratification, in the thermal-mixing process.

NUCLEAR ENGINEERING AND DESIGN (2022)

添加到收藏夹

Article Physics, Applied

Human motion-driven self-powered stretchable sensing platform based on laser-induced graphene foams

Cheng Zhang et al.

Summary: This study demonstrates a low-cost, scalable, and facile manufacturing approach for a self-powered wireless sensing platform based on laser-induced graphene foams, which efficiently harvest mechanical energy and provide stable power output. Integration of triboelectric nanogenerators and micro-supercapacitor arrays enables driving various stretchable sensors and wireless transmission modules wirelessly to monitor physiological and biochemical signals.

APPLIED PHYSICS REVIEWS (2022)

添加到收藏夹

Article Thermodynamics

The comprehensive solution to decrease cooling wall temperatures of sCO2 boiler for coal fired power plant

Chao Liu et al.

Summary: Compared to water-steam cycle, the use of supercritical carbon dioxide (sCO(2)) cycle in coal fired power plants offers higher efficiency. However, it presents challenges in the boiler where the cooler walls are prone to overheating and bursting due to the higher working fluid temperature and lower convective heat transfer coefficient. This study proposes a comprehensive solution to decrease the cooling wall temperatures by improving the thermal coupling between the radiation heat flux and CO2 fluid. Experimental results confirm the effectiveness of the proposed solution by reducing the cooling wall temperatures in a 1000 MWe power plant.

ENERGY (2022)

添加到收藏夹

Article Engineering, Environmental

Rotating triboelectric-electromagnetic nanogenerator driven by tires for self-powered MXene-based flexible wearable electronics

Dongyue Wang et al.

Summary: The development of flexible electronics has led to a demand for self-powered nanogenerators. In this study, a hybrid nanogenerator powered by tires was developed for gas and movement monitoring. The nanogenerator can power a light and charge a smartphone, and MXene/Ag-based sensors were fabricated for ethanol detection and joint activity monitoring.

CHEMICAL ENGINEERING JOURNAL (2022)

添加到收藏夹

Review Chemistry, Multidisciplinary

Wearable microfluidic-based e-skin sweat sensors

Humairah Tabasum et al.

Summary: Electronic skins (e-skins) are advanced wearable devices that mimic human skin attributes and can detect various medical signals in real-time, providing an intelligent foundation for early disease prediction and diagnosis. Wearable sweat sensors based on microfluidics offer high compatibility with medical and electronic applications, enabling preventive care, timely diagnosis, and health monitoring.

RSC ADVANCES (2022)

添加到收藏夹

Review Engineering, Manufacturing

Conformal manufacturing of soft deformable sensors on the curved surface

Wanqing Zhang et al.

Summary: This article discusses the need for and existing techniques in manufacturing and integrating flexible deformable devices on complex 3D surfaces. While planar fabrication methods are not directly applicable, they can be combined with stretchable structures and transfer printing to achieve device integration.

INTERNATIONAL JOURNAL OF EXTREME MANUFACTURING (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Transient Measurement of Temperature Distribution Using Thin Film Thermocouple Array on Turbine Blade Surface

Zhonglin Ji et al.

Summary: Smart sensors are essential for achieving a more intelligent aero-engine, with a thin-film sensor array fabricated on the turbine blade surface using MEMS technology. The PtRh/Pt thin film thermocouples exhibit good stability and consistency on the blade surface, able to capture temperature distribution and respond quickly to dynamic heat flow.

IEEE SENSORS JOURNAL (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Multifunctional Latex/Polytetrafluoroethylene-Based Triboelectric Nanogenerator for Self-Powered Organ-like MXene/Metal-Organic Framework-Derived CuO Nanohybrid Ammonia Sensor

Dongyue Wang et al.

Summary: The paper introduces a self-powered sensor powered by a TENG for detecting ammonia at room temperature, showing excellent response and the potential to monitor pork quality. The sensor exhibits outstanding voltage and current performance, with great application prospects in wearable devices.

ACS NANO (2021)

添加到收藏夹

Review Materials Science, Multidisciplinary

Approaches to deformable physical sensors: Electronic versus iontronic

Tae Yeong Kim et al.

Summary: In the past two decades, research on stretchable physical sensors has made significant technological advancements and has been applied in various fields. They have evolved from simple sensors to high-resolution array sensors with multiple functions. Different technological methods and principles have been explored based on target applications and materials.

MATERIALS SCIENCE & ENGINEERING R-REPORTS (2021)

添加到收藏夹

Article Chemistry, Physical

Multifunctional poly(vinyl alcohol)/Ag nanofibers-based triboelectric nanogenerator for self-powered MXene/tungsten oxide nanohybrid NO2 gas sensor

Dongyue Wang et al.

Summary: In this paper, a PVA/Ag nanofibers-based TENG was developed for human respiration, movement, and harmful gas monitoring, achieving high voltage and power density outputs. By integrating a voltage regulator module, stable voltage output from the wind-driven TENG was achieved, providing a feasible solution for different wind conditions. A self-powered sensor system was developed by integrating TENGs and a gas sensor, offering a sustainable detection platform for tracking the source of harmful gases.

NANO ENERGY (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Bonding and Thermal-Mechanical Property of Gradient NiCoCrAlY/YSZ Thermal Barrier Coatings with Millimeter Level Thickness

Yu Wang et al.

Summary: By using a novel synchronous dual powder feeding method, this study successfully deposited gradient NiCoCrAlY/YSZ coatings with millimeter level thickness, which exhibited improved bonding strength and thermal cycling life compared to common TBCs.

COATINGS (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Design and Fabrication of Thermocouple Sensors Based on a Ceramic Curved Alumina Substrate

Nan Zhao et al.

Summary: A platinum-platinum/rhodium thick-film thermocouple sensor based on an alumina curved-surface ceramic substrate was designed and tested for stability and repeatability at high temperatures. The sensor showed excellent consistency and reusability, making it suitable for measuring turbine blade surface temperature in aerospace applications.

IEEE SENSORS JOURNAL (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Fabricating functional circuits on 3D freeform surfaces via intense pulsed light-induced zinc mass transfer

Ning Yi et al.

Summary: A new fabrication strategy for printing functional circuits directly onto 3D freeform surfaces has been proposed in this research, with the ability to transform transient devices into long-lasting devices. The viability of this technology in integrating sensors and wireless communication components was demonstrated on 3D glass beakers and seashells with complex surface geometries.

MATERIALS TODAY (2021)

添加到收藏夹

Article Materials Science, Ceramics

Study on cyclic thermal corrosion behavior of APS-7YSZ thermal barrier coating at room- and high temperature

Faguo Li et al.

Summary: The study found that the thermal barrier coatings of aircraft engines in the marine environment are subject to salt solution corrosion and high-temperature corrosion. The bond coat is more susceptible to corrosion damage compared to other parts of the TBCs, which is a weakness of the thermal barrier coatings.

CERAMICS INTERNATIONAL (2021)

添加到收藏夹

Review Chemistry, Inorganic & Nuclear

Diversiform metal oxide-based hybrid nanostructures for gas sensing with versatile prospects

Dongzhi Zhang et al.

COORDINATION CHEMISTRY REVIEWS (2020)

添加到收藏夹

Review Physics, Applied

Micro/nanofiber-based noninvasive devices for health monitoring diagnosis and rehabilitation

Rituparna Ghosh et al.

APPLIED PHYSICS REVIEWS (2020)

添加到收藏夹

Proceedings Paper Automation & Control Systems

Analysis of pipeline leakage alarm threshold in nuclear power plant

Jun Ling et al.

2020 CHINESE AUTOMATION CONGRESS (CAC 2020) (2020)

添加到收藏夹

Article Engineering, Mechanical

Thermomechanical fatigue experiment and failure analysis on a nickel-based superalloy turbine blade

R. Wang et al.

ENGINEERING FAILURE ANALYSIS (2019)

添加到收藏夹

Article Chemistry, Analytical

Screen-Printed, Pure Carbon-Black Thermocouple Fabrication and Seebeck Coefficients

Christina Offenzeller et al.

SENSORS (2019)

添加到收藏夹

Article Engineering, Electrical & Electronic

A fully spray processed embedded composite thermocouple for the use at high temperatures and harsh environments

Marcel Knoll et al.

SENSORS AND ACTUATORS A-PHYSICAL (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Preparation and Thermoelectric Characteristics of ITO/PtRh: PtRh Thin Film Thermocouple

Xiaohui Zhao et al.

NANOSCALE RESEARCH LETTERS (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

Preparation and Thermoelectric Characteristics of ITO/PtRh: PtRh Thin Film Thermocouple

Xiaohui Zhao et al.

NANOSCALE RESEARCH LETTERS (2017)

添加到收藏夹

Article Engineering, Multidisciplinary

Effect of steamside oxidation and fireside corrosion degradation processes on creep life of service exposed boiler tubes

M. Mahesh Kumar et al.

INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2016)

添加到收藏夹

Article Materials Science, Ceramics

Preparation and influence of highly concentrated screen-printing inks on the development and characteristics of thick-film varistors

R. Rudez et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2015)

添加到收藏夹

Proceedings Paper Materials Science, Multidisciplinary

Thin Film Thermocouples for Surface Temperature Measurement of turbine blade

Yin-zhi Chen et al.

EIGHTH CHINA NATIONAL CONFERENCE ON FUNCTIONAL MATERIALS AND APPLICATIONS (2014)

添加到收藏夹

Review Chemistry, Analytical

Metallic and Ceramic Thin Film Thermocouples for Gas Turbine Engines

Ian M. Tougas et al.

SENSORS (2013)

添加到收藏夹

Article Materials Science, Ceramics

Stability and Microstructure of Indium Tin Oxynitride Thin Films

Otto J. Gregory et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2012)

添加到收藏夹

Article Materials Science, Multidisciplinary

Ceramic thin film thermocouples for SiC-based ceramic matrix composites

John D. Wrbanek et al.

THIN SOLID FILMS (2012)

添加到收藏夹

Article Thermodynamics

High-temperature high-frequency turbine exit flow field measurements in a military engine with a cooled unsteady total pressure probe

M. Mersinligil et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY (2011)

添加到收藏夹

Article Thermodynamics

A two-dimensional inverse heat conduction problem in estimating the fluid temperature in a pipeline

T. Lu et al.

APPLIED THERMAL ENGINEERING (2010)

添加到收藏夹

Article Nuclear Science & Technology

Numerical analysis of thermal striping induced high cycle thermal fatigue in a mixing tee

Jeong Ik Lee et al.

NUCLEAR ENGINEERING AND DESIGN (2009)

添加到收藏夹

Article Nuclear Science & Technology

Analysis of thermal stratification in the primary circuit of a VVER-440 reactor with the CFX code

Ildiko Boros et al.

NUCLEAR ENGINEERING AND DESIGN (2008)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.