☆ 4.6 Article

The molecular dynamics study of vacancy defect influence on carbon nanotube performance as drug delivery system

ENGINEERING ANALYSIS WITH BOUNDARY ELEMENTS (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Biochemistry & Molecular Biology

The study of boron-nitride nanotube behavior as an atomic nano-pump for biomedicine applications

Roozbeh Sabetvand et al.

Summary: This study employs molecular dynamics simulations to investigate the drug delivery performance of boron nitride nanotubes (BNNTs) and succeeds in reducing the nano pumping time by adjusting the process parameters. The findings reveal the molecular-level dispersion mechanism of BNNTs as a drug delivery tool and provide insights into optimizing the dispersion process and its biomedical applications.

JOURNAL OF MOLECULAR MODELING (2022)

添加到收藏夹

Article Thermodynamics

Numerical performance of thermal conductivity in Bioconvection flow of cross nanofluid containing swimming microorganisms over a cylinder with melting phenomenon

Muhammad Imran et al.

Summary: This study investigates the effects of melting phenomena and non-linear thermal radiation in Cross nanofluid bioconvection flow with motile microorganisms over a cylinder. The mathematical model takes into account Brownian motion and thermophoresis diffusion. Numerical solutions and profiles analysis show that increasing mixed convection parameter estimates can enhance velocity, while increasing Prandtl number decreases temperature and nanoparticle concentration. A higher Peclet value is shown to lower the microorganism's profile.

CASE STUDIES IN THERMAL ENGINEERING (2021)

添加到收藏夹

Article Thermodynamics

Experimental investigation on compression ignition engine powered with pentanol and thevetia peruviana methyl ester under reactivity controlled compression ignition mode of operation

P. A. Harari et al.

Summary: The study showed that adding 10% pentanol in the fuel is beneficial for increasing the brake thermal efficiency of diesel and pentanol fuel combination in RCCI mode, while reducing nitrogen oxide and smoke emissions.

CASE STUDIES IN THERMAL ENGINEERING (2021)

添加到收藏夹

Article Engineering, Chemical

Boiling flow of graphene nanoplatelets nano-suspension on a small copper disk

Marjan Goodarzi et al.

Summary: This study experimentally quantified the boiling heat transfer coefficient of graphene oxide-water nano-suspension in inflow boiling heat transfer regime and found that the presence of graphene oxide imposed extreme fouling thermal resistance to the surface, leading to a reduction in BHTC. Additionally, the sedimentation layer promoted the critical heat flux point while increasing heat flux and flow rate increased BHTC.

POWDER TECHNOLOGY (2021)

添加到收藏夹

Review Chemistry, Physical

Advances in Drug Delivery Nanosystems Using Graphene-Based Materials and Carbon Nanotubes

Josef Jampilek et al.

Summary: Carbon, one of the most abundant elements on Earth, has various allotropic modifications like graphene, which have shown potential in delivering drugs more efficiently, especially for cancer treatment.

MATERIALS (2021)

添加到收藏夹

Article Energy & Fuels

Effect of different building envelope materials on thermal comfort and air-conditioning energy savings: A case study in Basra city, Iraq

Raad Z. Homod et al.

Summary: The study suggests that the materials used in buildings are the most significant factor affecting the energy consumption of HVAC systems. A hybrid calculation model is employed to evaluate thermal comfort in buildings, reflecting their energy consumption. Simulation results of vernacular buildings and autoclaved aerated concrete buildings show that vernacular buildings have the highest energy saving potential throughout the day.

JOURNAL OF ENERGY STORAGE (2021)

添加到收藏夹

Article Thermodynamics

Two-phase frictional pressure drop with pure refrigerants in vertical mini/micro-channels

Muhammad Shujaat Ali et al.

Summary: This study investigated the frictional pressure drop during flow boiling of eco-friendly refrigerants, such as isobutane, HFC-152a, and HFO-1234yf, compared to HFC-134a. The study found that critical controlling parameters like heat flux, mass velocity, and exit vapor quality had a significant impact on pressure drop, with effects varying based on saturation temperature.

CASE STUDIES IN THERMAL ENGINEERING (2021)

添加到收藏夹

Article Engineering, Chemical

Clean combustion and emissions strategy using reactivity controlled compression ignition (RCCI) mode engine powered with CNG-Karanja biodiesel

S. P. Wategave et al.

Summary: This study focuses on optimizing combustion noise and emissions of diesel engines by using CNG as the primary fuel, combined with diesel and biodiesel as pilot fuels. The research indicates that an optimized energy share of CNG in the RCCI mode is crucial for achieving clean combustion and emission strategies.

JOURNAL OF THE TAIWAN INSTITUTE OF CHEMICAL ENGINEERS (2021)

添加到收藏夹

Article Thermodynamics

A detailed hydrothermal investigation of a helical micro double-tube heat exchanger for a wide range of helix pitch length

Nidal H. Abu-Hamdeh et al.

Summary: The study found that applying a helix angle in the helical micro double-tube heat exchanger can enhance heat transfer, with an optimal effect varying with Reynolds number. Increasing Reynolds number leads to higher overall heat transfer coefficient, pressure drop, and pumping power. Additionally, increasing pitch length decreases OHTC, pressure drop, and pumping power.

CASE STUDIES IN THERMAL ENGINEERING (2021)

添加到收藏夹

Article Multidisciplinary Sciences

Membrane fusion and drug delivery with carbon nanotube porins

Nga T. Ho et al.

Summary: Liposomes with carbon nanotube porins (CNTPs) on their membranes have been found to be efficient vehicles for direct cytoplasmic drug delivery, enhancing the killing effect of anticancer drugs on cancer cells. This research opens up new possibilities for designing more efficient drug delivery carriers.

PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA (2021)

添加到收藏夹

Article Mathematics

Combination Effect of Baffle Arrangement and Hybrid Nanofluid on Thermal Performance of a Shell and Tube Heat Exchanger Using 3-D Homogeneous Mixture Model

Mashhour A. Alazwari et al.

Summary: The study found that adding nanoparticles to the distilled water or increasing the fluid's Reynolds number can improve the heat transfer performance in shell and tube heat exchangers, especially at a baffle angle of 135 degrees. Additionally, increasing the baffle angle resulted in more fluid blocking areas, leading to increased pressure drop and friction.

MATHEMATICS (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Experimental Analysis of Engine Performance and Exhaust Pollutant on a Single-Cylinder Diesel Engine Operated Using Moringa Oleifera Biodiesel

Manzoore Elahi M. Soudagar et al.

Summary: The experiment showed that using MOB10 in the biodiesel production from Moringa oleifera oil can reduce some emissions, but also increase CO and NOx emissions.

APPLIED SCIENCES-BASEL (2021)

添加到收藏夹

Article Engineering, Multidisciplinary

Effect of injection parameters and producer gas derived from redgram stalk on the performance and emission characteristics of a diesel engine

K. M. Akkoli et al.

Summary: By altering the geometry of the injector nozzle, the study investigated the performance and emission characteristics of a dual-fuel engine under different operating conditions, identifying the optimal parameter combinations. The results showed that a 4-hole nozzle is suitable for Diesel-PG operation, while a 6-hole nozzle is ideal for HOME-PG operation, resulting in improved performance and reduced emissions.

ALEXANDRIA ENGINEERING JOURNAL (2021)

添加到收藏夹

Article Thermodynamics

Heat transfer evaluation of a micro heat exchanger cooling with spherical carbon-acetone nanofluid

Z. X. Li et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)

添加到收藏夹

Article Chemistry, Multidisciplinary

Configuration and Optimization of a Minichannel Using Water-Alumina Nanofluid by Non-Dominated Sorting Genetic Algorithm and Response Surface Method

Ali Akbar Ahmadi et al.

NANOMATERIALS (2020)

添加到收藏夹

Article Thermodynamics

Transient pool boiling and particulate deposition of copper oxide nano-suspensions

Zhixiong Li et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)

添加到收藏夹

Article Engineering, Multidisciplinary

Comparative study of the performance of air and geothermal sources of heat pumps cycle operating with various refrigerants and vapor injection

Saeed Maddah et al.

ALEXANDRIA ENGINEERING JOURNAL (2020)

添加到收藏夹

Article Energy & Fuels

Estimation of Pressure Drop of Two-Phase Flow in Horizontal Long Pipes Using Artificial Neural Networks

Mostafa Safdari Shadloo et al.

JOURNAL OF ENERGY RESOURCES TECHNOLOGY-TRANSACTIONS OF THE ASME (2020)

添加到收藏夹

Article Chemistry, Physical

Rheological behavior of hybrid MWCNTs-TiO2/EG nanofluid: A comprehensive modeling and experimental study

Shu-Rong Yan et al.

JOURNAL OF MOLECULAR LIQUIDS (2020)

添加到收藏夹

Article Thermodynamics

Operation analysis, response and performance evaluation of a pulsating heat pipe for low temperature heat recovery

Zhixiong Li et al.

ENERGY CONVERSION AND MANAGEMENT (2020)

添加到收藏夹

Article Green & Sustainable Science & Technology

Prediction of viscosity of biodiesel blends using various artificial model and comparison with empirical correlations

Yuanzhou Zheng et al.

RENEWABLE ENERGY (2020)

添加到收藏夹

Article Engineering, Multidisciplinary

Boiling heat transfer characteristics of graphene oxide nanoplatelets nano-suspensions of water-perfluorohexane (C6F14) and water-n-pentane

Marjan Goodarzi et al.

ALEXANDRIA ENGINEERING JOURNAL (2020)

添加到收藏夹

Article Physics, Multidisciplinary

Modeling different structures in perturbed Poiseuille flow in a nanochannel by using of molecular dynamics simulation: Study the equilibrium

Pedram Alipour et al.

PHYSICA A-STATISTICAL MECHANICS AND ITS APPLICATIONS (2019)

添加到收藏夹

Article Thermodynamics

Numerical assessment into the hydrothermal and entropy generation characteristics of biological water-silver nano-fluid in a wavy walled microchannel heat sink

Abdullah A. A. A. Al-Rashed et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2019)

添加到收藏夹

Article Thermodynamics

Effect of employing a new biological nanofluid containing functionalized graphene nanoplatelets on thermal and hydraulic characteristics of a spiral heat exchanger

Mehdi Bahiraei et al.

ENERGY CONVERSION AND MANAGEMENT (2019)

添加到收藏夹

Article Thermodynamics

Experimental investigation of the effects of temperature and mass fraction on the dynamic viscosity of CuO-paraffin nanofluid

Samad Ghasemi et al.

APPLIED THERMAL ENGINEERING (2018)

添加到收藏夹

Article Thermodynamics

A new correlation for estimating the thermal conductivity and dynamic viscosity of CuO/liquid paraffin nanofluid using neural network method

Arash Karimipour et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2018)

添加到收藏夹

Article Physics, Multidisciplinary

Develop the nano scale method of lattice Boltzmann to predict the fluid flow and heat transfer of air in the inclined lid driven cavity with a large heat source inside, Two case studies: Pure natural convection & mixed convection

Marjan Goodarzi et al.

PHYSICA A-STATISTICAL MECHANICS AND ITS APPLICATIONS (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Investigation of permeability effect on slip velocity and temperature jump boundary conditions for FMWNT/Water nanofluid flow and heat transfer inside a microchannel filled by a porous media

Mehdi Nojoomizadeh et al.

PHYSICA E-LOW-DIMENSIONAL SYSTEMS & NANOSTRUCTURES (2018)

添加到收藏夹

Article Green & Sustainable Science & Technology

Application of nanofluid to improve the thermal performance of horizontal spiral coil utilized in solar ponds: Geometric study

Erfan Khodabandeh et al.

RENEWABLE ENERGY (2018)

添加到收藏夹

Article Chemistry, Multidisciplinary

Effects of Thickness and Amount of Carbon Nanofiber Coated Carbon Fiber on Improving the Mechanical Properties of Nanocomposites

Ferial Ghaemi et al.

NANOMATERIALS (2016)

添加到收藏夹

Article Chemistry, Multidisciplinary

Effects of the surface modification of carbon fiber by growing different types of carbon nanomaterials on the mechanical and thermal properties of polypropylene

F. Ghaemi et al.

RSC ADVANCES (2015)

添加到收藏夹

Article Nanoscience & Nanotechnology

An experimental study on thermal conductivity and viscosity of nanofluids containing carbon nanotubes

Rad Sadri et al.

NANOSCALE RESEARCH LETTERS (2014)

添加到收藏夹

Article Thermodynamics

Investigation of the gravity effects on the mixed convection heat transfer in a microchannel using lattice Boltzmann method

Arash Karimipour et al.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2012)

添加到收藏夹

Review Chemistry, Multidisciplinary

Current Progress on the Chemical Modification of Carbon Nanotubes

Nikolaos Karousis et al.

CHEMICAL REVIEWS (2010)

添加到收藏夹

Article Oncology

Drug delivery with carbon nanotubes for in vivo cancer treatment

Zhuang Liu et al.

CANCER RESEARCH (2008)

添加到收藏夹

Article Materials Science, Multidisciplinary

Carbon nanotubes as drug delivery nanocapsules

Tamsyn A. Hilder et al.

CURRENT APPLIED PHYSICS (2008)

添加到收藏夹

Article Chemistry, Multidisciplinary

Nanopumping using carbon nanotubes

Zeke Insepov et al.

NANO LETTERS (2006)

添加到收藏夹

Article Physics, Multidisciplinary

Thermal transport measurements of individual multiwalled nanotubes

P Kim et al.

PHYSICAL REVIEW LETTERS (2001)

添加到收藏夹

Article Physics, Multidisciplinary

Radial distribution function analysis of carbon nanotubes

A Szczygielska et al.

ACTA PHYSICA POLONICA A (2000)

添加到收藏夹

Article Multidisciplinary Sciences

Strength and breaking mechanism of multiwalled carbon nanotubes under tensile load

MF Yu et al.

SCIENCE (2000)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.