☆ 4.5 Article

Study on Surrounding Rock Control and Support Stability of Ultra-Large Height Mining Face

ENERGIES (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Geochemistry & Geophysics

Floor Disturbance and Failure Characteristics of Super-Large Mining Height Working Face

Cunjin Lu et al.

Summary: This study examines the floor failure situation of a working face with a super-large mining height in the western mining area of China. It is found that, under this super-large mining height, the floor failure depth is smaller. This is due to the falling roof inhibiting pressure relief, the large mining height reducing advance pressure, and the decrease in shear stress of the floor.

GEOFLUIDS (2022)

添加到收藏夹

Article Energy & Fuels

Roof deformation characteristics and experimental verification of advanced coupling support system supporting roadway

Kun Zhang et al.

Summary: This study investigates the influence of the initial bearing capacity of advanced hydraulic support on roadway roof deformation. By establishing a contact mechanics model and conducting simulation experiments, the research results show that increasing the initial bearing capacity of the support has a significant impact on the support effect in the middle area of the roadway but has a relatively small impact on the surrounding area of the roof.

ENERGY SCIENCE & ENGINEERING (2022)

添加到收藏夹

Article Engineering, Mechanical

Research on roof damage mechanism and control technology of gob-side entry retaining under close distance gob

Hongyang Liu et al.

Summary: This study investigated the failure mechanism and control technology of gob-side entry retaining in short-distance coal seam at Panel #11426 of Xieqiao Mine. Various support methods were proposed to control the surrounding rock of gob-side entry during roadway excavation and mining, resulting in successful engineering results.

ENGINEERING FAILURE ANALYSIS (2022)

添加到收藏夹

Article Geochemistry & Geophysics

Research on Theory and Technology of Floor Heave Control in Semicoal Rock Roadway: Taking Longhu Coal Mine in Qitaihe Mining Area as an Example

Xuming Zhou et al.

Summary: This paper conducts a detailed analysis and simulation study on the problem of floor heave in mine roadways of Longhu coal mine. A mechanical model and a supported roadway model are established, three support optimization schemes are proposed, and the best scheme is determined, providing important reference and guidance for solving the problem of floor heave in mine roadways.

LITHOSPHERE (2022)

添加到收藏夹

Article Engineering, Multidisciplinary

Analysis of pressure regulating characteristics of safety valve in hydraulic system of offshore oil production equipment

Chenghu Guo

Summary: This study designs and tests a two-stage safety valve for controlling oil production equipment in offshore oil exploitation. Simulation and experimental results demonstrate that the two-stage safety valve exhibits favorable dynamic response characteristics and effectively ensures the stability of the hydraulic system. This research provides a theoretical basis and experimental reference for the design of safety valves in offshore oil production equipment.

AIN SHAMS ENGINEERING JOURNAL (2022)

添加到收藏夹

Article Geochemistry & Geophysics

Research on Theory and Technology of Floor Heave Control in Semicoal Rock Roadway: Taking Longhu Coal Mine in Qitaihe Mining Area as an Example

Xuming Zhou et al.

Summary: The paper investigates the floor heave issue in the third section winch roadway of Qitaihe Longhu coal mine and proposes an optimized support scheme through mechanical modeling and FLAC3D simulation. The best scheme reduces floor heave by 81% and meets the deformation requirements, providing guidance for roadway support optimization.

LITHOSPHERE (2022)

添加到收藏夹

Article Engineering, Multidisciplinary

Anti-impact load characteristics of two-stage safety valve for hydraulic support

Chenghu Guo et al.

Summary: This study designed a two-stage safety valve that can effectively adjust the pressure stability of the hydraulic support system, and verified its reliability through simulation and experimentation.

AIN SHAMS ENGINEERING JOURNAL (2022)

添加到收藏夹

Article Geochemistry & Geophysics

Iteratively Coupled Flow and Geomechanics in Fractured Poroelastic Reservoirs: A Phase Field Fracture Model

Jinzhou Zhao et al.

Summary: The study introduces a model that considers fluid-solid coupling, where fractures are regularized by the phase field, and efficiently solves the multifield problem through an iterative coupling method.

GEOFLUIDS (2021)

添加到收藏夹

Article Engineering, Industrial

ANALYSIS OF THE FORCE RESPONSE OF A DOUBLE-CANOPY HYDRAULIC SUPPORT UNDER IMPACT LOADS

Z. S. Meng et al.

Summary: The study investigated the force response of hydraulic support under impact loads, establishing a dynamic simulation model based on rigid-flexible coupling. Results showed that the support exhibited variable stiffness under parallel static loads, with the rear canopy bearing higher loads than the front canopy. The sensitivity of support joints to impact loads varied, with the joint between the canopy and goaf shield being the most sensitive.

INTERNATIONAL JOURNAL OF SIMULATION MODELLING (2021)

添加到收藏夹

Article Engineering, Industrial

STABILITY OF A FACE GUARD IN A LARGE MINING HEIGHT WORKING FACE

D. L. Wang et al.

Summary: Hydraulic support is crucial in mining for maintaining stability and safety; a numerical model shows that integral face guards are more flexible and stable compared to split face guards.

INTERNATIONAL JOURNAL OF SIMULATION MODELLING (2021)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

AE waveform characteristics of rock mass under uniaxial loading based on Hilbert-Huang transform

Li Xue-long et al.

Summary: The study utilizes the Hilbert-Huang transform method to analyze AE waveforms, obtaining detailed structural characteristics of coal rock masses at different loading stages related to damage. The results show changes in energy distribution among different frequency components and indicate the main energy concentration areas in each stage.

JOURNAL OF CENTRAL SOUTH UNIVERSITY (2021)

添加到收藏夹

Article Engineering, Industrial

STRUCTURAL ANALYSIS ON IMPACT-MECHANICAL PROPERTIES OF ULTRA-HIGH HYDRAULIC SUPPORT

Z. K. Yang et al.

INTERNATIONAL JOURNAL OF SIMULATION MODELLING (2020)

添加到收藏夹

Article Thermodynamics

CFD modeling of coal dust migration in an 8.8-meter-high fully mechanized mining face

Tao Du et al.

ENERGY (2020)

添加到收藏夹

Article Geosciences, Multidisciplinary

Double-factor control method for calculating hydraulic support working resistance for longwall mining with large mining height

Yihui Pang et al.

ARABIAN JOURNAL OF GEOSCIENCES (2020)

添加到收藏夹

Article Engineering, Geological

Effect of Strata Conditions on Shield Pressure and Surface Subsidence at a Longwall Top Coal Caving Working Face

Chuang Liu et al.

ROCK MECHANICS AND ROCK ENGINEERING (2019)

添加到收藏夹

Article Engineering, Environmental

Study on the failure mechanism and stability control measures in a large-cutting-height coal mining face with a deep-buried seam

De-Zhong Kong et al.

BULLETIN OF ENGINEERING GEOLOGY AND THE ENVIRONMENT (2019)

添加到收藏夹

Article Engineering, Multidisciplinary

A fiber Bragg grating tilt sensor for posture monitoring of hydraulic supports in coal mine working face

Minfu Liang et al.

MEASUREMENT (2019)

添加到收藏夹

Article Engineering, Geological

Study of automated top-coal caving in extra-thick coal seams using the continuum-discontinuum element method

Qunlei Zhang et al.

INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2019)

添加到收藏夹

Article Mining & Mineral Processing

Systematic principles of surrounding rock control in longwall mining within thick coal seams

Jiachen Wang et al.

INTERNATIONAL JOURNAL OF MINING SCIENCE AND TECHNOLOGY (2019)

添加到收藏夹

Article Engineering, Mechanical

Failure analysis of super-large mining height powered support

Zhaosheng Meng et al.

ENGINEERING FAILURE ANALYSIS (2018)

添加到收藏夹

Article Engineering, Industrial

ANALYSIS ON THE POSE AND DYNAMIC RESPONSE OF HYDRAULIC SUPPORT UNDER DUAL IMPACT LOADS

X. T. Zeng et al.

INTERNATIONAL JOURNAL OF SIMULATION MODELLING (2018)

添加到收藏夹

Article Geosciences, Multidisciplinary

Deformation characteristics and stability control of a gateroad in fully mechanized mining with large mining height

Hong-hu Yuan et al.

ARABIAN JOURNAL OF GEOSCIENCES (2018)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Measurement and numerical analysis of influence of key stratum breakage on mine pressure in top-coal caving face with super great mining height

Li Meng et al.

JOURNAL OF CENTRAL SOUTH UNIVERSITY (2017)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Mode of overlying rock roofing structure in large mining height coal face and analysis of support resistance

Wu Feng-feng et al.

JOURNAL OF CENTRAL SOUTH UNIVERSITY (2016)

添加到收藏夹

Article Engineering, Geological

Application of a combined support system to the weak floor reinforcement in deep underground coal mine

Yongshui Kang et al.

INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2014)

添加到收藏夹

Review Mining & Mineral Processing

Sensing for advancing mining automation capability: A review of underground automation technology development

Ralston Jonathon et al.

INTERNATIONAL JOURNAL OF MINING SCIENCE AND TECHNOLOGY (2014)

添加到收藏夹

Article Engineering, Mechanical

Stress analysis and stability analysis on doubly-telescopic prop of hydraulic support

Xuewen Wang et al.

ENGINEERING FAILURE ANALYSIS (2013)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.