☆ 4.7 Article

Effects of Ti2SnC on the mechanical properties and tribological properties of copper/graphite composites

CERAMICS INTERNATIONAL (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Mechanical

Effect of heat treatment temperature on mechanical and tribological properties of copper impregnated carbon/carbon composite

Pei Wang et al.

Summary: By utilizing heat treatment and copper impregnation, the toughness and friction behaviors of carbon/carbon composites can be enhanced. With increasing heat treatment temperature, the flexural strength decreases and the failure mode changes. The increase in carbon crystal degree through heat treatment helps form a smooth tribolayer on the wear surface, leading to a decrease in friction coefficient and arc discharging frequency, and a shift in the main wear mechanism during current carrying friction tests.

TRIBOLOGY INTERNATIONAL (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Friction and Wear Behavior of Copper-graphite Composites with Different Compositions in Water Environments

Hongming Wie et al.

Summary: Copper-graphite composites with different copper content were prepared by SPS, showing variations in density, hardness, friction coefficient, and wear rate in friction testing. Increasing copper content improved density and hardness, while decreasing friction coefficients under dry friction conditions. Water friction conditions resulted in lower friction coefficients and the wear rate was influenced by copper content and etching treatment.

CHEMISTRYSELECT (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Preparation and thermophysical properties of graphite flake-carbon fiber coreinforced copper matrix composites

Junchen Huang et al.

Summary: Graphite flake-carbon fiber reinforced copper matrix composites were prepared using vacuum hot pressing technology. The study found that an appropriate amount of carbon fiber can effectively improve the bending strength and thermal conductivity of the composites, while excessive addition leads to a decrease in performance.

MATERIALS RESEARCH EXPRESS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Thermal and tribological properties of MoS2 doped graphite/copper composites by microwave sintering

Tang Zhimeng et al.

Summary: The study synthesized MoS2-doped graphite/copper self-lubricating composites using rapid microwave sintering and investigated their thermal properties and friction behaviors. Doping molybdenum disulfide solid lubricant into graphite promoted the formation of friction film, optimizing the friction and wear properties of the composites. Additionally, the composites exhibited better thermal and frictional properties at 200 degrees C compared to room temperature.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2021)

添加到收藏夹

Review Engineering, Mechanical

Preparation and properties of copper-plated expanded graphite/ copper composites

Lin Bai et al.

Summary: The study focused on the microstructure, physical properties, and tribological properties of EG@Cu/Cu composites with different EG content. The results showed that the copper coating effectively improved the interface bonding between C-Cu, and the uniform distribution of EG improved the continuity of the copper matrix, forming a self-lubricating film during friction.

TRIBOLOGY INTERNATIONAL (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

Fabrication, mechanical and thermal properties of copper coated graphite films reinforced copper matrix laminated composites via ultrasonic-assisted electroless plating and vacuum hot-pressing sintering

Xiaozhen Wang et al.

Summary: The Cu coating on graphite films improves interfacial bonding, mechanical properties, and thermal properties of the laminated composites, offering an effective method for developing novel structural and functional materials for thermal management.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

添加到收藏夹

Article Engineering, Mechanical

Effects of foam copper on the mechanical properties and tribological properties of graphite/copper composites

Linying Zhu et al.

TRIBOLOGY INTERNATIONAL (2020)

添加到收藏夹

Article Chemistry, Multidisciplinary

Chemically stable new MAX phase V2SnC: a damage and radiation tolerant TBC material

M. A. Hadi et al.

RSC ADVANCES (2020)

添加到收藏夹

Article Engineering, Chemical

Properties and microstructure of copper/nickel-iron-coated graphite composites prepared by electroless plating and spark plasma sintering

Jinjuan Cheng et al.

POWDER TECHNOLOGY (2019)

添加到收藏夹

Article Chemistry, Physical

Effect of matrix-alloying-element chromium on the microstructure and properties of graphite flakes/copper composites fabricated by hot pressing sintering

Shubin Ren et al.

CARBON (2018)

添加到收藏夹

Article Chemistry, Physical

Microstructure and flexural properties of C/C-Cu composites strengthened with in-situ grown carbon nanotubes

Gang Kou et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2017)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of Graphite and SiC Addition into Cu and SiC Particle Size Effect on Fabrication of Cu-Graphite-SiC MMC by Powder Metallurgy

Arabinda Meher et al.

TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS (2017)

添加到收藏夹

Article Chemistry, Physical

Properties and microstructure of nickel-coated graphite flakes/copper composites fabricated by spark plasma sintering

Jianhao Chen et al.

CARBON (2017)

添加到收藏夹

Article Materials Science, Ceramics

Crack healing induced electrical and mechanical properties recovery in a Ti2SnC ceramic

Shibo Li et al.

JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2016)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Sliding wear behavior of copper-based composites reinforced with graphene nanosheets and graphite

Jing-fu Li et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2015)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of WS2 addition on electrical sliding wear behaviors of Cu-graphite-WS2 composites

Gang Qian et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2015)

添加到收藏夹

Article Nanoscience & Nanotechnology

Electrical sliding friction and wear properties of Cu-MoS2-graphite-WS2 nanotubes composites in air and vacuum conditions

Shiyin Huang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of sintering temperature on the preparation of Cu-Ti3SiC2 metal matrix composite

Tungwai L. Ngai et al.

PROGRESS IN NATURAL SCIENCE-MATERIALS INTERNATIONAL (2013)

添加到收藏夹

Article Engineering, Mechanical

Friction, wear and tribofilm formation on electrical contact materials in reciprocating sliding against silver-graphite

M. Grandin et al.

WEAR (2013)

添加到收藏夹

Article Engineering, Mechanical

The tribological properties and mechanism of wear of Cu-based sintered powder materials containing molybdenum disulfide and molybdenum diselenite under unlubricated sliding against copper

A. M. Kovalchenko et al.

WEAR (2012)

添加到收藏夹

Article Engineering, Mechanical

Effect of the ratio of graphite/pitch coke on the mechanical and tribological properties of copper-carbon composites

Huijun Yang et al.

WEAR (2010)

添加到收藏夹

Article Engineering, Mechanical

Friction and wear behaviour of stainless steel rubbing against copper-impregnated metallized carbon

G. X. Chen et al.

TRIBOLOGY INTERNATIONAL (2009)

添加到收藏夹

Article Nanoscience & Nanotechnology

Synthesis of Ti2SnC at low-temperature using mechanically activated sintering process

Shi-Bo Li et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

添加到收藏夹

Article Nanoscience & Nanotechnology

Fabrication and properties of Ti3AlC2 particulates reinforced copper composites

Liangming Peng

SCRIPTA MATERIALIA (2007)

添加到收藏夹

Article Materials Science, Ceramics

Bimodal microstructure and reaction mechanism of Ti2SnC synthesized by a high-temperature reaction using Ti/Sn/C and Ti/Sn/TiC powder compacts

Shi-Bo Li et al.

JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2006)

添加到收藏夹

Article Nanoscience & Nanotechnology

Tribological behavior of Ti2SnC particulate reinforced copper matrix composites

J. Y. Wu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.