☆ 4.5 Article

Study on the Characteristics of Acoustic Emission Quiet Period in Rocks with Different Elastic Modulus

MINERALS (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Multidisciplinary Sciences

Evaluation of the characterization of acoustic emission of brittle rocks from the experiment to numerical simulation

Fengchang Bu et al.

Summary: This study developed a particle-velocity-based model (PVBM) to address the limitations of the moment tensor model (MTM) in acoustic emission (AE) characterization. By using PVBM as a proxy to analyze the discrepancies between MTM and experimental results, and considering the influence of various factors, the AE characteristics of rocks were reasonably and accurately obtained.

SCIENTIFIC REPORTS (2022)

添加到收藏夹

Article Geochemistry & Geophysics

Study on the Effect of Bond Strength on the Failure Mode of Coarse-Grained Sandstone in Weakly Cemented Stratum

Xianda Yang et al.

Summary: This study investigates the influence of bond strength on the peak strength and failure mode of coarse-grained sandstone. The results show a positive correlation between peak strength and bond strength. The research provides insights for guiding ground control in mining operations with weakly cemented lithology.

MINERALS (2022)

添加到收藏夹

Article Engineering, Geological

Effect of the in situ leaching solution of ion-absorbed rare earth on the mechanical behavior of basement rock

Wen Zhong et al.

Summary: Laboratory tests were conducted to investigate the deterioration behavior and failure mechanism of rock under the erosion of leaching solution. The results showed that the erosion of the solution led to a decrease in rock strength, mass, and P-wave velocity, and an increase in porosity. The soaking time also affected the failure pattern of the rock specimens.

JOURNAL OF ROCK MECHANICS AND GEOTECHNICAL ENGINEERING (2022)

添加到收藏夹

Article Engineering, Geological

Prediction of the post-failure behavior of rocks: Combining artificial intelligence and acoustic emission sensing

Negin Yousefpour et al.

Summary: This study investigates the prediction models for residual strength of rocks using AE readings and deep learning methods, showing that pre-failure AE patterns can accurately predict residual strength decay.

INTERNATIONAL JOURNAL FOR NUMERICAL AND ANALYTICAL METHODS IN GEOMECHANICS (2022)

添加到收藏夹

Article Engineering, Geological

Sensitivity Analysis of Macroscopic Mechanical Behavior to Microscopic Parameters Based on PFC Simulation

Guodong Li et al.

Summary: This study conducted a uniaxial compression experiment using PFC and compared the influence of different micro-parameters on the macro-mechanical properties of rock. The results showed that the micro-behavior of the balls had a significant impact on the rock's elastic modulus.

GEOTECHNICAL AND GEOLOGICAL ENGINEERING (2022)

添加到收藏夹

Article Chemistry, Multidisciplinary

Mechanical Properties of Metasandstone under Uniaxial Graded Cyclic Loading and Unloading

Dunwen Liu et al.

Summary: The acoustic emission and wave velocity characteristics of metasandstone under graded cyclic loading and unloading were studied, revealing that the acoustic emission signals are mainly generated during loading and the wave velocity rapidly decreases when the stress exceeds a threshold. These findings can be used to predict the instability and damage of rock masses in engineering.

APPLIED SCIENCES-BASEL (2022)

添加到收藏夹

Article Mathematics, Interdisciplinary Applications

Linearization-based methods for the calibration of bonded-particle models

Kolja Jarolin et al.

Summary: Two methods for calibrating elastic material parameters of bonded-particle models are proposed in this work, based on classical mechanics principles. These methods allow for faster calibration than traditional trial and error strategies and can be used to check the consistency of the models. The first method linearizes the mathematical model and solves it in a matrix-vector formulation, while the second method further linearizes to calculate the elastic stiffness tensor directly, reducing computational costs significantly. Application of these methods in three case studies showed a significant reduction in calculation time.

COMPUTATIONAL PARTICLE MECHANICS (2021)

添加到收藏夹

Article Computer Science, Information Systems

Identification of crack development in granite under triaxial compression based on the acoustic emission signal

Tianzuo Wang et al.

Summary: By combining triaxial compression tests with acoustic emission monitoring and analyzing acoustic emission signals in the time and frequency domain, the development characteristics of cracks in granite samples can be accurately understood, thus determining the time and conditions of producing large cracks efficiently.

INTERNATIONAL JOURNAL OF DISTRIBUTED SENSOR NETWORKS (2021)

添加到收藏夹

Article Mechanics

Experimental and numerical investigation on the effects of bedding plane properties on the mechanical and acoustic emission characteristics of sandy mudstone

Yaoyao Meng et al.

Summary: This study investigates the influence of bedding planes on the mechanical characteristics of rocks using experiments and numerical simulations. It is found that the number and strength of bedding planes play a significant role in shaping the strength, fracture, and crack distributions of rock specimens.

ENGINEERING FRACTURE MECHANICS (2021)

添加到收藏夹

Article Geosciences, Multidisciplinary

Effect of temperature on physical, mechanical and acoustic emission properties of Beishan granite, Gansu Province, China

Yun Wu et al.

Summary: The study found a temperature threshold of 300 degrees C for granite, with increasing temperature leading to a sharp decrease in peak strength, P-wave velocity, and mass loss ratio. Additionally, the growth of thermal cracks at different elevated temperatures resulted in changes to the rock failure mode.

NATURAL HAZARDS (2021)

添加到收藏夹

Article Engineering, Geological

Influence of grain size on strength of polymineralic crystalline rock: New insights from DEM grain-based modeling

Jun Peng et al.

Summary: The research shows that the strength of rock increases with the grain size in the rock model, as larger grain size reduces the number of grain interfaces leading to higher rock strength. By degrading grain boundary parameters with increasing grain size, a plausible explanation is provided for the grain size effect on rock strength.

JOURNAL OF ROCK MECHANICS AND GEOTECHNICAL ENGINEERING (2021)

添加到收藏夹

Article Mechanics

Nondestructive testing on cumulative damage of watery fractured rock mass under multiple cycle blasting

Dunwen Liu et al.

Summary: Field and rock-like materials model tests were conducted to analyze the cumulative damage of tunnel surrounding rock and watery fractured rock under multiple cycle blasting. The influence range of blasting on tunnel surrounding rock was found to be within 1.2 m, and nonlinear variations of cumulative damage were observed in watery fractured rock mass.

ENGINEERING FRACTURE MECHANICS (2021)

添加到收藏夹

Article Geochemistry & Geophysics

An Experimental and Numerical Study on Acoustic Emission in the Process of Rock Damage at Different Stress Paths

Dongxu Liang et al.

Summary: The study found that the damage process of rock is influenced by stress paths, with fractures occurring at the peak of stress. Prior to fracture formation, there is a quiet period of acoustic emissions. Minor damage to the rock is accompanied by the appearance of bright white spots, and as the external load increases, fractures develop and damage the specimen.

GEOFLUIDS (2021)

添加到收藏夹

Article Engineering, Mechanical

Crack propagation process and acoustic emission characteristics of rock-like specimens with double parallel flaws under uniaxial compression

Zhiheng Wang et al.

Summary: This study investigated the initiation mechanism of microcracks in fractured rock mass from the perspective of micromechanics, establishing macro-micro criteria to determine and distinguish the properties and types of cracks. It was found that the stress state of rock particles determines the type and propagation direction of cracks, allowing for an effective analysis of the initiation mechanism of different types of cracks and their propagation trends.

THEORETICAL AND APPLIED FRACTURE MECHANICS (2021)

添加到收藏夹

Article Engineering, Geological

Investigating the crack initiation and propagation mechanism in brittle rocks using grain-based finite-discrete element method

X. F. Li et al.

INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2020)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Acoustic emission precursors of static and dynamic instability for coarse-grained hard rock

Guo-shao Su et al.

JOURNAL OF CENTRAL SOUTH UNIVERSITY (2020)

添加到收藏夹

Review Energy & Fuels

Investigation of the relationship between dynamic and static deformation moduli of rocks

Seyed Morteza Davarpanah et al.

GEOMECHANICS AND GEOPHYSICS FOR GEO-ENERGY AND GEO-RESOURCES (2020)

添加到收藏夹

Article Energy & Fuels

On the Kaiser Effect of Rock under Cyclic Loading and Unloading Conditions: Insights from Acoustic Emission Monitoring

Qingbin Meng et al.

ENERGIES (2019)

添加到收藏夹

Article Geosciences, Multidisciplinary

Multi-scale effect of acoustic emission characteristics of 3D rock damage

Wan-rong Liu et al.

ARABIAN JOURNAL OF GEOSCIENCES (2019)

添加到收藏夹

Article Engineering, Mechanical

A cohesive damage-plasticity model for DEM and its application for numerical investigation of soft rock fracture properties

Nhu H. T. Nguyen et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2017)

添加到收藏夹

Article Engineering, Geological

Calibration and Verification of Two Bonded-Particle Models for Simulation of Intact Rock Behavior

Javier Andres Vallejos et al.

INTERNATIONAL JOURNAL OF GEOMECHANICS (2017)

添加到收藏夹

Article Engineering, Geological

Simulation of unstable rock failure under unloading conditions

Amin Manouchehrian et al.

CANADIAN GEOTECHNICAL JOURNAL (2016)

添加到收藏夹

Review Geosciences, Multidisciplinary

The bonded-particle model as a tool for rock mechanics research and application: current trends and future directions

David Oskar Potyondy

GEOSYSTEM ENGINEERING (2015)

添加到收藏夹

Article Engineering, Civil

A bonded particle model for analysis of the flaw orientation effect on crack propagation mechanism in brittle materials under compression

A. Manouchehrian et al.

ARCHIVES OF CIVIL AND MECHANICAL ENGINEERING (2014)

添加到收藏夹

Article Engineering, Geological

A bonded-particle model for rock

DO Potyondy et al.

INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2004)

添加到收藏夹

Article Geochemistry & Geophysics

Moment tensors and micromechanical models

JF Hazzard et al.

TECTONOPHYSICS (2002)

添加到收藏夹

Article Construction & Building Technology

Detection and evaluation of AE waves due to rock deformation

T Shiotani et al.

CONSTRUCTION AND BUILDING MATERIALS (2001)

添加到收藏夹

Article Engineering, Geological

Simulating acoustic emissions in bonded-particle models of rock

JF Hazzard et al.

INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2000)

添加到收藏夹

Article Engineering, Geological

Laboratory studies of acoustic emission prior to uniaxial compressive rock failure

V Rudajev et al.

INTERNATIONAL JOURNAL OF ROCK MECHANICS AND MINING SCIENCES (2000)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.