相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Thermodynamic analysis and comparison of different absorption cycles driven by evacuated tube solar collector utilizing hybrid nanofluids
Muhammad Abid et al.
ENERGY CONVERSION AND MANAGEMENT (2021)
Moisture transport analysis for integrated structures of flat plate solar collector and building envelope
Guoqing Yu et al.
SOLAR ENERGY (2021)
Heat transfer and flow characteristics of Fe3O4 -water nanofluids under magnetic excitation
Xilong Zhang et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2021)
Heat transfer analysis and thermal performance investigation on an evacuated tube solar collector with inner concentrating by reflective coating
Shaowei Chai et al.
SOLAR ENERGY (2021)
Thermal Performance of Facades Based on Experimental Monitoring of Outdoor Test Cells in Tropical Climate
Letzai Ruiz-Valero et al.
CIVIL ENGINEERING JOURNAL-TEHRAN (2021)
Improvement of photo-thermal energy conversion performance of MWCNT/Fe3O4 hybrid nanofluid compared to Fe3O4 nanofluid
Yijie Tong et al.
ENERGY (2020)
Energetic and exergetic analysis of a heat pipe evacuated tube solar collector using MWCNT/water nanofluid
Mahmoud Eltaweel et al.
CASE STUDIES IN THERMAL ENGINEERING (2020)
Modeling of the Solar Thermal Energy Use in Urban Areas
Drita Qerimi et al.
CIVIL ENGINEERING JOURNAL-TEHRAN (2020)
Efficiency of evacuated tube solar collector using WO3/Water nanofluid
M. A. Sharafeldin et al.
RENEWABLE ENERGY (2019)
Energy and exergy comparison of a flat-plate solar collector using water, Al2O3 nanofluid, and CuO nanofluid
Yijie Tong et al.
APPLIED THERMAL ENGINEERING (2019)
Optimum number and arrangement of evacuated-tube solar collectors under various operating conditions
Amr Kotb et al.
ENERGY CONVERSION AND MANAGEMENT (2019)
Carbon nanotube nanofluid in enhancing the efficiency of evacuated tube solar collector
I. M. Mahbubul et al.
RENEWABLE ENERGY (2018)
Photo-thermal conversion characteristics of MWCNT-H2O nanofluids for direct solar thermal energy absorption applications
Jian Qu et al.
APPLIED THERMAL ENGINEERING (2017)
Thermal and exergy optimization of a nanofluid-based direct absorption solar collector
Tahereh B. Gorji et al.
RENEWABLE ENERGY (2017)
Theoretical investigation of the efficiency of a U-tube solar collector using various nanofluids
Hyeongmin Kim et al.
ENERGY (2016)
Theoretical investigation of the thermal performance of evacuated heat pipe solar collector with optimum tilt angle under various operating conditions
Y. Tong et al.
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2016)
Exergy efficiency investigation and optimization of an Al2O3-water nanofluid based Flat-plate solar collector
Ehsan Shojaeizadeh et al.
ENERGY AND BUILDINGS (2015)
Effects of thermal performance of enclosed-type evacuated U-tube solar collector with multi-walled carbon nanotube/water nanofluid
Yijie Tong et al.
RENEWABLE ENERGY (2015)
High temperature and long-term stability of carbon nanotube nanofluids for direct absorption solar thermal collectors
Nathan Hordy et al.
SOLAR ENERGY (2014)
Analytical models for the computation and optimization of single and double glazing flat plate solar collectors with normal and small air gap spacing
Alison Subiantoro et al.
APPLIED ENERGY (2013)
A new solution for reduced sedimentation flat panel solar thermal collector using nanofluids
Gianpiero Colangelo et al.
APPLIED ENERGY (2013)
Energetic and exergetic evaluation of flat plate solar collectors
Farzad Jafarkazemi et al.
RENEWABLE ENERGY (2013)
Study of a new solar adsorption refrigerator powered by a parabolic trough collector
A. El Fadar et al.
APPLIED THERMAL ENGINEERING (2009)
Thermal and exergy analysis of solar air collectors with passive augmentation techniques
A. Ucar et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2006)
Enhancement of thermal conductivity with carbon nanotube for nanofluids
MS Liu et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2005)
分享论文
