☆ 4.6 Article

Effect of Tension Temperature on the Anisotropy of Tensile Behavior for Az31 Alloys: A Visco-Plastic Self-Consistent Analysis

METALS AND MATERIALS INTERNATIONAL (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Multidisciplinary

Investigation on Slip Activity and Plastic Heterogeneity of Aged Mg-10Y Sheets During Compression

R. Ni et al.

Summary: The study investigated the effects of precipitates on individual slip activities and plastic heterogeneity during room temperature compression of Mg-10Y sheets. It was found that after peak-aged treatment, the frequency of basal slip increased while pyramidal slips significantly decreased. Most activated slip systems had large normalized Schmid factors, but there were also hard-oriented slip systems, indicating local stress deviation.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2022)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Research on deformation mechanism of AZ31 magnesium alloy sheet with non-basal texture during uniaxial tension at room temperature: A visco-plastic self-consistent analysis

Li Hu et al.

Summary: The relationship between the activities of different deformation mechanisms and the evolution of microstructure and texture in the uniaxial tension of AZ31 magnesium alloy with a rare non-basal texture was investigated using electron backscattered diffraction (EBSD) measurement and visco-plastic self-consistent (VPSC) modeling. The results showed that both basal and prismatic slip, as well as extension twin, played significant roles in plastic deformation. The activity of the extension twin decreased with the increasing angle between the loading and rolling directions, and its role shifted from sustaining plastic strain to accommodating local strain between grains. The different roles of the extension twin resulted in the formation of different texture components. The competition between basal and pyramidal slip was responsible for the concentration of tilted basal poles towards the normal direction. VPSC modeling overestimated the volume fractions of the extension twin, and the predicted results were smaller when compatible deformation between grains was not considered.

JOURNAL OF MAGNESIUM AND ALLOYS (2022)

添加到收藏夹

Article Engineering, Mechanical

Tension-compression asymmetry and the underlying slip/twinning activity in extruded Mg - Y sheets

D. D. Yin et al.

Summary: The addition of different concentrations of Y significantly affected the mechanical properties, grain-scale slip activity, and orientation heterogeneity of extruded Mg alloys during tension and compression. Increasing Y content led to noticeable changes in slip activity, while tension-compression asymmetry also showed variations.

INTERNATIONAL JOURNAL OF PLASTICITY (2021)

添加到收藏夹

Review Metallurgy & Metallurgical Engineering

Towards developing Mg alloys with simultaneously improved strength and corrosion resistance via RE alloying

Jinshu Xie et al.

Summary: Magnesium alloys have great application potential, but improvements in both strength and corrosion resistance are still needed. The addition of rare earth elements can enhance the performance of magnesium alloys, but further research is necessary to improve both strength and anti-corrosion properties.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Anomalous Tension Twinning Activity in Extruded Mg Sheet During Hard-Orientation Loading at Room Temperature

Y. Q. Chai et al.

Summary: The study found that surface twins in a strongly basal-textured Mg sheet deformed under tension exhibit tension twins, with a significant number showing negative Schmid factor and Luster-Morris parameter values. The twinning behavior was more dependent on local conditions than globally applied stress, limiting correlations between m and m'.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2021)

添加到收藏夹

Article Engineering, Mechanical

{10(1)over-bar2} twinning behavior under biaxial tension of Mg-3Al-1Zn plate

Yao Cheng et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Quantitative prediction of texture effect on Hall-Fetch slope for magnesium alloys

Bo Guan et al.

ACTA MATERIALIA (2019)

添加到收藏夹

Article Chemistry, Physical

Effects of precipitate type on twin/slip activity in ZK60 alloys and yield asymmetry

Weijie Ren et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

添加到收藏夹

Article Engineering, Mechanical

An analytical model to predict strain-hardening behaviour and twin volume fraction in a profoundly twinning magnesium alloy

Sudeep K. Sahoo et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Crystal plasticity FEM study of twinning and slip in a Mg single crystal by Erichsen test

C. S. Hyun et al.

ACTA MATERIALIA (2018)

添加到收藏夹

Review Materials Science, Multidisciplinary

Hall-Petch relationship in Mg alloys: A review

Huihui Yu et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2018)

添加到收藏夹

Article Materials Science, Multidisciplinary

Weakened anisotropy of mechanical properties in rolled ZK60 magnesium alloy sheets with elevated deformation temperature

Wenke Wang et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Evolution of microstructure, texture and mechanical properties of ZK60 magnesium alloy in a single rolling pass

Wenke Wang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Investigating the temperature dependency of plastic deformation in a Mg-3Al-1Zn alloy

Adrien Chapuis et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Role of one direction strong texture in stretch formability for ZK60 magnesium alloy sheet

Wenke Wang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Engineering, Mechanical

Anisotropy, tension-compression asymmetry and texture evolution of a rare-earth-containing magnesium alloy sheet, ZEK100, at different strain rates and temperatures: Experiments and modeling

Saadi A. Habib et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2017)

添加到收藏夹

Article Chemistry, Physical

Improvement of planar isotropy, mechanical properties and corrosion resistance of extruded Mg-3A1-1Zn alloy sheet by special grain re-orientation

Xin Li et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

Improved stretch formability of AZ31 sheet via grain size control

Joong Won Park et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effects of tensile twinning on the stretch formability of Mg

Joong Won Park et al.

METALS AND MATERIALS INTERNATIONAL (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

On the rapid hardening and exhaustion of twinning in magnesium alloy

P. D. Wu et al.

ACTA MATERIALIA (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

Nucleation and preferential growth mechanism of recrystallization texture in high purity binary magnesium-rare earth alloys

Aidin Imandoust et al.

ACTA MATERIALIA (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

Microstructural evolution of pure magnesium under high strain rate loading

Neha Dixit et al.

ACTA MATERIALIA (2015)

添加到收藏夹

Article Engineering, Mechanical

Visco-plastic modeling of mechanical responses and texture evolution in extruded AZ31 magnesium alloy for various loading conditions

Farhoud Kabirian et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2015)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of texture on Hall-Petch relationships in an Mg alloy

Yi Wang et al.

ACTA MATERIALIA (2014)

添加到收藏夹

Article Mechanics

Study of lattice strains in magnesium alloy AZ31 based on a large strain elastic-viscoplastic self-consistent polycrystal model

H. Wang et al.

INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2012)

添加到收藏夹

Article Engineering, Industrial

Influence of initial texture on formability of AZ31B magnesium alloy sheets at different temperatures

Hua Zhang et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2011)

添加到收藏夹

Article Materials Science, Multidisciplinary

Role of {10-12} twinning characteristics in the deformation behavior of a polycrystalline magnesium alloy

Seong-Gu Hong et al.

ACTA MATERIALIA (2010)

添加到收藏夹

Article Nanoscience & Nanotechnology

Enhanced ductility in strongly textured magnesium produced by equal channel angular processing

SR Agnew et al.

SCRIPTA MATERIALIA (2004)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.