☆ 4.6 Article

Numerical Analysis on the Spatiotemporal Characteristics of the Portevin-Le Chatelier Effect in Ti-12Mo Alloy

METALS AND MATERIALS INTERNATIONAL (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Nanoscience & Nanotechnology

Fracture behavior of novel biomedical Ti-based high entropy alloys under impact loading

S. Gurel et al.

Summary: The research found that the TiTaHfNb alloy demonstrated significant ductility and energy absorption capacity, while the TiTaHfNbZr and TiTaHfMoZr alloys exhibited lower ductility under impact loading. The reduced ductility and energy absorption capacity were attributed to the addition of Zr and Mo, which caused lattice distortion and formation of additional dislocations.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

添加到收藏夹

Article Chemistry, Physical

Mechanical properties of solution heat treated Al-Zn-Mg-Cu (7075) alloy under different cooling conditions: Analysis with full field measurement and finite element modeling

Chanmi Moon et al.

Summary: The effect of W-temper heat treatment on the mechanical properties and fracture of high strength aluminum alloy 7075 sheet was studied experimentally and numerically. Different cooling conditions were considered, and the mechanical properties were measured along with the analysis of strain and strain rate distributions using DIC technique. The simulation of LDH formability test shows good agreement with experiments when the PLC effect and planar anisotropy are properly implemented.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

添加到收藏夹

Article Chemistry, Physical

Microstructural evolution and mechanical properties of bulk and porous low-cost Ti-Mo-Fe alloys produced by powder metallurgy

Shima Ehtemam-Haghighi et al.

Summary: The study shows that Ti-Mo-Fe alloys offer significant cost savings on raw materials compared to current commercial biomedical Ti alloys, with excellent mechanical properties achieved through compositional adjustments. Porous Ti-10Mo-5Fe alloys with increased porosity through space holder additions exhibited decreased compressive strength and elastic modulus but are promising for hard tissue engineering applications due to their optimal pore sizes.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

添加到收藏夹

Article Engineering, Industrial

Effect of plastic anisotropy and Portevin-Le Chatelier bands on hole-expansion in AA7075 sheets in-T6 and -W tempers

Yumi Choi et al.

Summary: This study investigates the influence of tempers on the hole-expansion formability of an AA7075 aluminum sheet. The findings show that the hole can expand by 70% more in -W temper compared to -T6 temper with lower forming force. The thickness strain distribution around the hole is similar in both tempers, but the observation of the Portevin-Le Chatelier (PLC) effect in -W temper causes inhomogeneous deformation.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

A method for determining r-value of aluminum sheets with the Portevin-Le Chatelier effect

Kangcai Yu et al.

Summary: The study investigated the PLC bands of AA3104-H19 sheet and found that the inclination of the PLC band and r-value remain constant during tensile testing. The stability of these parameters is a result of texture evolution limitations, leading to a newly proposed method for determining r-value based on PLC bands.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

添加到收藏夹

Article Chemistry, Physical

On the mechanisms of nucleation and subsequent development of the PLC bands in an AlMg alloy

D. Yuzbekova et al.

Summary: The nucleation and subsequent development of Portevin-Le Chatelier bands during tensile deformation in a binary AlMg alloy were investigated using digital image correlation techniques. Different material states were analyzed to reveal specific spatiotemporal patterns of the alloy, indicating that the nucleation of deformation bands follows a mixed mechanism.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

On temperature and strain-rate dependence of flow serration in HfNbTaTiZr high-entropy alloy

Shuying Chen et al.

Summary: The study investigates the flow serration in the HfNbTaTiZr alloy at different temperatures and strain rates, successfully modeling the transition of the onset strain behavior with a theoretical framework. The model's success in predicting the onset strain as a function of temperature and strain rate represents the possibility of constructing a process window for the alloy theoretically.

SCRIPTA MATERIALIA (2021)

添加到收藏夹

Article Engineering, Manufacturing

Investigation of Portevin-Le Chatelier effect during Erichsen test

L. Z. Mansouri et al.

INTERNATIONAL JOURNAL OF MATERIAL FORMING (2020)

添加到收藏夹

Review Engineering, Mechanical

Stress-strain curves of metallic materials and post-necking strain hardening characterization: A review

Shengwen Tu et al.

FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2020)

添加到收藏夹

Article Chemistry, Physical

Portevin-Le Chatelier effect in a wrought Ni-Co based superalloy

Rui Zhang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effects of Mo content on corrosion and tribocorrosion behaviours of Ti-Mo orthopaedic alloys fabricated by powder metallurgy

Wei Xu et al.

CORROSION SCIENCE (2020)

添加到收藏夹

Article Chemistry, Physical

Microstructural and mechanical properties of β-type Ti-Mo-Nb biomedical alloys with low elastic modulus

Peiyou Li et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

添加到收藏夹

Review Materials Science, Multidisciplinary

Portevin-Le Chatelier effect in wrought Ni-based superalloys: Experiments and mechanisms

Chuanyong Cui et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Experimental investigation of a Portevin-Le Chatelier band in Ni-Co-based superalloys in relation to γ' precipitates at 500 °C

Yanke Liu et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Influence of forging velocity on temperature and phases of forged Ti-6Al-4V turbine blade

Shiyuan Luo et al.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)

添加到收藏夹

Article Nanoscience & Nanotechnology

Macroscopic consequences of Piobert-Luders and Portevin-Le Chatelier bands during tensile deformation in Al-Mg alloys

Baptiste Reyne et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Spatiotemporal correlations in the Portevin-Le Chatelier band dynamics during the type B - type C transition

M. Mehenni et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Article Nanoscience & Nanotechnology

Microstructure, thermo-mechanical properties and Portevin-Le Chatelier effect in metastable β Ti-xMo alloys

Shiyuan Luo et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)

添加到收藏夹

Article Chemistry, Physical

Microstructure and tensile properties of Ti-Mo alloys manufactured via using laser powder bed fusion

Nan Kang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

添加到收藏夹

Article Engineering, Civil

Experimental study of Portevin-Le Chatelier bands on tensile and plane strain tensile tests

Ndeye Awa Sene et al.

ARCHIVES OF CIVIL AND MECHANICAL ENGINEERING (2018)

添加到收藏夹

Article Nanoscience & Nanotechnology

Spatiotemporal characteristics of Portevin-Le Chatelier effect in Ti-Mo alloys under thermo-mechanical loading

Shiyuan Luo et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)

添加到收藏夹

Article Engineering, Mechanical

Effect of microstructure on continuous propagation of the Portevin-Le Chatelier deformation bands

D. Yuzbekova et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

Coincidence of strain-induced TRIP and propagative PLC bands in Medium Mn steels

Michael Callahan et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)

添加到收藏夹

Article Engineering, Mechanical

Thermo-mechanical modeling of Portevin-Le Chatelier instabilities under various loading paths

L. Z. Mansouri et al.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2016)

添加到收藏夹

Article Engineering, Mechanical

Kinematics of Portevin-Le Chatelier bands in simple shear

P. Y. Manach et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2014)

添加到收藏夹

Article Nanoscience & Nanotechnology

High-strength nanostructured Ti-12Mo alloy from ductile metastable beta state precursor

F. Sun et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)

添加到收藏夹

Article Nanoscience & Nanotechnology

Mechanical behavior and crack tip plasticity of a strain aging sensitive steel

J. Belotteau et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)

添加到收藏夹

Article Engineering, Mechanical

An experimental and numerical investigation of the behaviour of AA5083 aluminium alloy in presence of the Portevin-Le Chatelier effect

A. Benallal et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2008)

添加到收藏夹

Article Materials Science, Multidisciplinary

Finite element simulations of the Portevin-Le Chatelier effect in metal-matrix composites

S. Graff et al.

PHILOSOPHICAL MAGAZINE (2008)

添加到收藏夹

Article Mechanics

Numerical modelling of the Portevin-Le Chatelier effect

Matthieu Maziere et al.

EUROPEAN JOURNAL OF COMPUTATIONAL MECHANICS (2008)

添加到收藏夹

Article Materials Science, Multidisciplinary

Portevin-LeChatelier effect in Al-Mg alloys:: Influence of obstacles -: experiments and modelling

H. Dierke et al.

COMPUTATIONAL MATERIALS SCIENCE (2007)

添加到收藏夹

Article Nanoscience & Nanotechnology

Spatiotemporal aspects of jerky flow in Al-Mg alloys, in relation with the Mg content

H Ait-Amokhtar et al.

SCRIPTA MATERIALIA (2006)

添加到收藏夹

Article Materials Science, Multidisciplinary

The morphology of Portevin-Le Chatelier bands: Finite element simulation for Al-Mg-Si

S Zhang et al.

ACTA MATERIALIA (2001)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.