☆ 4.3 Article

Design and Implementation of a Thin Film Tensile Testing Apparatus for Cryogenic Applications

EXPERIMENTAL TECHNIQUES (2023)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Ceramics

Mechanical properties and thermal shock in thin ZrO2-Y2O3-Al2O3 films obtained by the sol-gel method

Antonio Diaz-Parralejo et al.

Summary: This study prepared thin multilayer coatings of ZrO2-Y2O3-Al2O3 using the sol-gel method and dip-coating technique, investigating the influence of Al2O3 incorporation on the films. It was found that increasing alumina content improved the toughness and resistance to thermal shock of the coatings.

CERAMICS INTERNATIONAL (2021)

添加到收藏夹

Article Polymer Science

Interfacial interactions and properties of cellular structured polyurethane nanocomposite based on carbonaceous nano-fillers

Subhash Mandal et al.

Summary: This study investigated the impact of different carbonaceous nanofillers on the tensile properties of thermoplastic polyurethane cellular structures. Results showed that 2D and 3D fillers significantly improved tensile strength and modulus, while 0D fillers performed poorly and 1D fillers showed marginal enhancement. The interfacial adhesion of the fillers was found to be significantly higher for 2D and 3D compared to 0D fillers, as calculated using experimental and predictive models.

JOURNAL OF APPLIED POLYMER SCIENCE (2021)

添加到收藏夹

Article Chemistry, Physical

Experimental and Numerical Analysis of High-Temperature Superconducting Tapes Modified by Composite Thermal Stabilization Subjected to Thermomechanical Loading

Eva Cuninkova et al.

Summary: The study focused on the strain behavior of SiC/Stycast 2850 FT composites under thermomechanical loading, indicating their potential use as thermal stabilizers for HTS tapes. Experimental and FEA analysis showed that the SB11-SiC20 composite coating demonstrated good resistance to temperature changes.

MATERIALS (2021)

添加到收藏夹

Article Engineering, Electrical & Electronic

Temperature-Dependent Dielectric Properties of Polyimide (PI) and Polyamide (PA) Nanocomposites

Jordan Cook et al.

Summary: This study found that polyimide and polyamide nanocomposites exhibit exceptional dielectric performance at cryogenic temperatures, with polyimide being the stronger material. Samples tested in cryogenic environments showed significant improvement in dielectric strength compared to those tested at room temperature. Various factors such as free charge carriers, heat generation, material degradation, thermal contraction, and interfacial changes were found to influence the performance of these dielectrics at cryogenic temperatures.

IEEE TRANSACTIONS ON NANOTECHNOLOGY (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

Delamination and current-carrying degradation behavior of epoxy-impregnated superconducting coil winding with 2G HTS tape caused by thermal stress

Yujie Duan et al.

AIP ADVANCES (2020)

添加到收藏夹

Proceedings Paper Physics, Applied

Ultimate Tensile Strengths of 3D Printed Carbon-fiber Reinforced Thermoplastics in Liquid Nitrogen

M. Hunt et al.

ADVANCES IN CRYOGENIC ENGINEERING (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Atomic Oxygen Adaptability of Flexible Kapton/Al2O3 Composite Thin Films Prepared by Ion Exchange Method

Donghua Jiang et al.

COATINGS (2019)

添加到收藏夹

Article Engineering, Chemical

A study of mechanical properties of foil materials for the GEM detector proposed for the CMS muon system upgrade at LHC

G. Saviano et al.

POLYMER ENGINEERING AND SCIENCE (2018)

添加到收藏夹

Article Materials Science, Multidisciplinary

High-Temperature Superconducting Cable Design Based on Individual Insulated Conductors

Peter Cheetham et al.

ADVANCES IN MATERIALS SCIENCE AND ENGINEERING (2018)

添加到收藏夹

Article Optics

Experimental determination of Representative Volume Element (RVE) size in woven composites

Behrad Koohbor et al.

OPTICS AND LASERS IN ENGINEERING (2017)

添加到收藏夹

Proceedings Paper Thermodynamics

Tensile strengths of polyamide based 3D printed polymers in liquid nitrogen

P. Cruz et al.

ADVANCES IN CRYOGENIC ENGINEERING - MATERIALS: PROCEEDINGS OF THE INTERNATIONAL CRYOGENIC MATERIALS CONFERENCE (ICMC) 2015 (2015)

添加到收藏夹

Article Materials Science, Multidisciplinary

Interaction between cracking, delamination and buckling in brittle elastic thin films

W. P. Vellinga et al.

INTERNATIONAL JOURNAL OF FRACTURE (2008)

添加到收藏夹

Article Physics, Applied

Advanced tensile testing methods for bulk superconductors at cryogenic temperatures

K. Kasaba et al.

PHYSICA C-SUPERCONDUCTIVITY AND ITS APPLICATIONS (2006)

添加到收藏夹

Article Biophysics

A simple cryogenic holder for tensile testing of soft biological tissues

J Lepetit et al.

JOURNAL OF BIOMECHANICS (2004)

添加到收藏夹

Article Physics, Applied

The yield strength of thin copper films on Kapton

DYW Yu et al.

JOURNAL OF APPLIED PHYSICS (2004)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.