期刊
CONSTRUCTION AND BUILDING MATERIALS
卷 340, 期 -, 页码 -出版社
ELSEVIER SCI LTD
DOI: 10.1016/j.conbuildmat.2022.127827
关键词
3D concrete printing; Additive manufacturing; Bonding strength; Pull-out test; Reinforcement
资金
- Basque Government [ERRAIL ZL-2020/00940, ZL-2021/00181, KK-2021/00059]
This study tests the bonding strength of passive rebars within a 3D-printed mortar structure by inserting the rebars into interior hollow channels and bonding them with filling mortar. Test results show that the bonding strengths range from 16.75 MPa to 18 MPa, depending on the rebar diameter, and the bonding mortar exhibits good early strength development of at least 14 MPa during the first week. No specimen failed due to debonding between the filling mortar and the 3D-printed cylinder, or between the cylinder and the concrete poured around its exterior.
Passive rebars are inserted into interior hollow channels within a 3D-printed mortar geometry and then bonded with a wet joint of filling mortar, in order to test the bonding strength of the rebars within the mortar structure. Standardized test procedures are adapted for the test procedure. The test results revealed bonding strengths with shear stresses within an interval between 16.75 MPa and 18 MPa, dependent upon rebar diameter, and good early strength development of the bonding mortar of at least 14 MPa during the first week. No specimen failed because of debonding between the filling mortar and the 3D-printed cylinder, nor because of debonding of the cylinder and the concrete poured around its exterior.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据