☆ 4.7 Article

Influence of sea wave shock on transient start-up performance of water-lubricated bearing

TRIBOLOGY INTERNATIONAL (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Mechanical

Influences of transient impact and vibration on the lubrication performance of spur gears

Xingbao Huang et al.

Summary: This paper presents a mathematical model of gear elastohydrodynamic lubrication, considering transient impact operating condition and underdamped load condition. The numerical solution shows that transient impact results in significant increases in film pressure and temperature, while thermal effect causes decreases in film thickness. Additionally, vibrational load with high damped frequency leads to greater changes in film thickness and friction coefficient compared to low damped frequency, with a corresponding increase in film temperature.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2021)

添加到收藏夹

Article Engineering, Mechanical

Numerical prediction of the frictional losses in sliding bearings during start-stop operation

Florian Koenig et al.

Summary: With the increasing use of automotive engine start-stop systems, predicting and reducing frictional losses in sliding bearings has become important. The application of statistical asperity contact models with empirical values for necessary inputs leads to large deviations between experiment and simulation, highlighting the importance of utilizing deterministic contact modeling for reliable friction prediction in sliding bearings during start-stop operations.

FRICTION (2021)

添加到收藏夹

Article Engineering, Mechanical

Performance improvement of water-lubricated thrust pad bearing operating with the turbulent flow using a new micro-pocket design

J. C. Atwal et al.

Summary: This paper explores the performance parameters of a sector-shaped pad thrust bearing lubricated with water using a new pocket design, considering the effects of turbulence and cavitation. The study investigates the effects of new pocket attributes and compares the performance behaviors achieved with the new pocketed pad bearing with plain pad and rectangular pocketed bearing.

TRIBOLOGY INTERNATIONAL (2021)

添加到收藏夹

Article Engineering, Mechanical

Investigations on start-up performances of novel hybrid metal rubber-bump foil bearings

Chuanbing Zhang et al.

Summary: This research studied the start-up performances of novel hybrid metal rubber-bump foil bearings (MR-BFBs) based on rough surface contact and ultra-thin film lubrication theory. The results showed that changes in surface roughness affected the parameters significantly, and increased start-up times led to changes in various parameters and characteristics. Additionally, an increase in composite roughness also influenced the critical rotation speed and start-up time.

TRIBOLOGY INTERNATIONAL (2021)

添加到收藏夹

Article Engineering, Mechanical

The Thermal Unbalance Effect Induced by a Journal Bearing in Rigid and Flexible Rotors: Experimental Analysis

Thibaud Plantegenet et al.

TRIBOLOGY TRANSACTIONS (2020)

添加到收藏夹

Article Engineering, Mechanical

A reliability assessment model for journal bearing based on natural degradation and random shocks

Yourui Tao et al.

JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2020)

添加到收藏夹

Article Engineering, Manufacturing

Application of multi-leaf foil bearings in high-speed turbo-machinery

Yu Guo et al.

JOURNAL OF ADVANCED MECHANICAL DESIGN SYSTEMS AND MANUFACTURING (2020)

添加到收藏夹

Article Engineering, Aerospace

Thermoelastohydrodynamic analysis of misaligned bearings with texture on journal surface under high-speed and heavy-load conditions

Yu Zhang et al.

CHINESE JOURNAL OF AERONAUTICS (2019)

添加到收藏夹

Article Engineering, Mechanical

Steady-state performance of a circular journal bearing lubricated with a non-Newtonian fluid considering the elastic deformation of the liner

Boualem Chetti et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2019)

添加到收藏夹

Article Engineering, Mechanical

Influence of polyethylene wax on wear resistance for polyurethane composite material under low speed water-lubricated conditions

Zumin Wu et al.

WEAR (2019)

添加到收藏夹

Article Engineering, Mechanical

Experimental analysis of the hydrodynamic effect during start-up of fixed geometry thrust bearings

Y. Henry et al.

TRIBOLOGY INTERNATIONAL (2018)

添加到收藏夹

Article Engineering, Mechanical

Influence of oil injection methods on the lubrication process of high speed spur gears

Yanzhong Wang et al.

TRIBOLOGY INTERNATIONAL (2018)

添加到收藏夹

Article Engineering, Mechanical

Numerical analysis on the dynamic contact behavior of hydrodynamic journal bearings during start-up

Shuhui Cui et al.

TRIBOLOGY INTERNATIONAL (2018)

添加到收藏夹

Article Engineering, Mechanical

Transient Pressure and Temperature Field Measurements in a Lightly Loaded Circumferential Groove Journal Bearing from Startup to Steady-State Thermal Stabilization

Alex-Florian Cristea et al.

TRIBOLOGY TRANSACTIONS (2017)

添加到收藏夹

Article Engineering, Mechanical

Anti-shock characteristics of water lubricated bearing for fuel cell vehicle air compressor

Tianming Ren et al.

TRIBOLOGY INTERNATIONAL (2017)

添加到收藏夹

Article Engineering, Manufacturing

Open-loop control of elliptical shaft center orbit

Peng Liang et al.

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2016)

添加到收藏夹

Article Engineering, Mechanical

Load carrying capacity of misaligned hydrodynamic water-lubricated plain journal bearings with rigid bush materials

Xiuli Zhang et al.

TRIBOLOGY INTERNATIONAL (2016)

添加到收藏夹

Article Engineering, Mechanical

Dynamic characteristics of compliant journal bearings considering thermal effects

Evgeny Kuznetsov et al.

TRIBOLOGY INTERNATIONAL (2016)

添加到收藏夹

Article Engineering, Mechanical

Influence of local bush wear on water lubricated sliding bearing load carrying capacity

Wojciech Litwin

TRIBOLOGY INTERNATIONAL (2016)

添加到收藏夹

Article Engineering, Mechanical

Wear simulation for the journal bearings operating under aligned shaft and steady load during start-up and coast-down conditions

Sang Myung Chun et al.

TRIBOLOGY INTERNATIONAL (2016)

添加到收藏夹

Article Engineering, Chemical

Thermal Characteristics of Water-Lubricated Ceramic Hydrostatic Hydrodynamic Hybrid Bearings

Dun Lu et al.

TRIBOLOGY LETTERS (2016)

添加到收藏夹

Article Engineering, Mechanical

Influence of particles on the loading capacity and the temperature rise of water film in Ultra-high speed hybrid bearing

Zhu Aibin et al.

CHINESE JOURNAL OF MECHANICAL ENGINEERING (2015)

添加到收藏夹

Article Engineering, Mechanical

Analysis of elasto-hydrodynamic lubrication of journal bearing based on different numerical methods

Fanming Meng et al.

INDUSTRIAL LUBRICATION AND TRIBOLOGY (2015)

添加到收藏夹

Article Engineering, Mechanical

Determination of stiffness coefficients of hydrodynamic water-lubricated plain journal bearings

Xiuli Zhang et al.

TRIBOLOGY INTERNATIONAL (2015)

添加到收藏夹

Article Engineering, Mechanical

Static characteristics of a water-lubricated hydrostatic thrust bearing using a membrane restrictor

Makoto Gohara et al.

TRIBOLOGY INTERNATIONAL (2014)

添加到收藏夹

Article Engineering, Mechanical

A new method for calculating the static performance of hydrostatic journal bearing

Peng Liang et al.

TRIBOLOGY INTERNATIONAL (2014)

添加到收藏夹

Article Engineering, Electrical & Electronic

Optimal design of fluid dynamic bearings to develop a robust disk-spindle system in a hard disk drive utilizing modal analysis

Jihoon Lee et al.

MICROSYSTEM TECHNOLOGIES-MICRO-AND NANOSYSTEMS-INFORMATION STORAGE AND PROCESSING SYSTEMS (2013)

添加到收藏夹

Article Engineering, Mechanical

The effect of surface defects on the wear of Nylon 66 under dry and water lubricated sliding

A. Abdelbary et al.

TRIBOLOGY INTERNATIONAL (2013)

添加到收藏夹

Article Engineering, Mechanical

A method for measuring the hydrodynamic effect on the bearing land

Peng Liang et al.

TRIBOLOGY INTERNATIONAL (2013)

添加到收藏夹

Article Engineering, Mechanical

Start-Stop Characteristics and Thermal Behavior of a Large Hybrid Airfoil Bearing For Aero-Propulsion Applications

Daejong Kim et al.

JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2012)

添加到收藏夹

Article Engineering, Electrical & Electronic

Robust design of a HDD spindle system supported by fluid dynamic bearings utilizing the stability analysis of five degrees of freedom of a general rotor-bearing system

Myunggyu Kim et al.

MICROSYSTEM TECHNOLOGIES-MICRO-AND NANOSYSTEMS-INFORMATION STORAGE AND PROCESSING SYSTEMS (2011)

添加到收藏夹

Article Engineering, Mechanical

Experimental measurement of the friction torque on hydrodynamic plain journal bearings during start-up

J. Bouyer et al.

TRIBOLOGY INTERNATIONAL (2011)

添加到收藏夹

Article Engineering, Electrical & Electronic

Dynamics of a Hard Disk Drive Spindle System Due to Its Structural Design Variables and the Design Variables of Fluid Dynamic Bearings

K. Y. Park et al.

IEEE TRANSACTIONS ON MAGNETICS (2009)

添加到收藏夹

Article Engineering, Electrical & Electronic

Dynamic characteristics of micro air bearings for microsystems

Q. D. Zhang et al.

MICROSYSTEM TECHNOLOGIES-MICRO-AND NANOSYSTEMS-INFORMATION STORAGE AND PROCESSING SYSTEMS (2008)

添加到收藏夹

Article Engineering, Mechanical

Mixed elastohydrodynamic lubrication in a partial journal bearing-comparison between deterministic and Stochastic models

Mihai B. Dobrica et al.

JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2006)

添加到收藏夹

Article Engineering, Mechanical

Nonlinear dynamic analysis of a hydrodynamic journal bearing considering the effect of a rotating or stationary herringbone groove

GH Jang et al.

JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2002)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.