☆ 4.7 Article

Fatigue behavior of CFRP/Al adhesive joints - Failure mechanisms study using digital image correlation (DIC) technique

THIN-WALLED STRUCTURES (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Review Engineering, Civil

Lightweight hybrid materials and structures for energy absorption: A state-of-the-art review and outlook

Guangyong Sun et al.

Summary: This article provides a critical review on the advances in hybrid materials and structures for crashworthiness and energy absorption performance. It discusses the hybridization of different materials to maximize their functional roles in lightweight structures. The evaluation and comparison of various hybridized materials in terms of crashworthiness and energy absorption are also discussed.

THIN-WALLED STRUCTURES (2022)

添加到收藏夹

Article Engineering, Civil

On failure mechanisms in CFRP/Al adhesive joints after hygrothermal aging degradation following by mechanical tests

Gang Zheng et al.

Summary: This study investigates the failure mechanisms of CFRP/Aluminum adhesive joints after hygrothermal degradation, revealing a decrease in strength after aging but a noticeable increase after 40 days. Different failure processes and modes were observed, with a total of three different types of failure modes identified, including two uncommon ones. The residual mechanical properties of the adhesive material were affected by water plasticization and temperature post-curing, with moisture absorption characteristics impacting the residual mechanical properties.

THIN-WALLED STRUCTURES (2021)

添加到收藏夹

Article Engineering, Civil

On multiaxial failure behavior of closed-cell aluminum foams under medium strain rates

Erdong Wang et al.

Summary: This study investigates the dynamic failure behavior of closed-cell aluminium foams under different strain rates. It reveals that the uniaxial failure strength's hardening is rate-dependent on the foam cell-wall base material at low and medium strain rates. The failure surface in the von Mises mean stress plane significantly expands with increasing strain rates, but is almost independent of loading or strain rates when normalized by the uniaxial failure strength at the corresponding strain rates. The study suggests modified rate-dependent constitutive models for foam materials under quasi-static and dynamic loadings.

THIN-WALLED STRUCTURES (2021)

添加到收藏夹

Article Engineering, Mechanical

Ultra-high three-point bending fatigue performance of nano-silica-reinforced CFRP

Junliang Ding et al.

Summary: The addition of silica nano-particles significantly extended the fatigue life of CFRP by enhancing the connection strength between polymer and carbon fiber, and by passivating and even blocking the growth of fatigue cracks. The fatigue damage morphologies of the nano-particles modified CFRP were closely related to stress magnitude, and stiffness degradation exhibited staged change characteristics with the evolution of damage morphologies.

INTERNATIONAL JOURNAL OF FATIGUE (2021)

添加到收藏夹

Article Engineering, Civil

On quasi-static behaviors of different joint methods for connecting carbon fiber reinforce plastic (CFRP) laminate and aluminum alloy

Guangyong Sun et al.

Summary: This study experimentally investigated mechanical behaviors and failure mechanisms of different joint methods for dissimilar materials. The results indicated that the hybrid connection exhibited the best mechanical characteristics among the three types of joints, with an interactive enhancement effect between the rivet and adhesive. Filling adhesive in a preformed hole of the substrate can effectively disperse stress and reduce stress concentration.

THIN-WALLED STRUCTURES (2021)

添加到收藏夹

Article Engineering, Civil

Effect of staggered holes with multi-site damage on fatigue performance based on tests, DIC technique and numerical calculations

Yajun Chen et al.

THIN-WALLED STRUCTURES (2020)

添加到收藏夹

Article Mechanics

Revealing the competitive fatigue failure behaviour of CFRP-aluminum two-bolt, double-lap joints

Meijuan Shan et al.

COMPOSITE STRUCTURES (2020)

添加到收藏夹

Article Engineering, Manufacturing

Directing helical CNT into chemically-etched micro-channels on aluminum substrate for strong adhesive bonding with carbon fiber composites

Fei Cheng et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2020)

添加到收藏夹

Article Engineering, Civil

Experimental investigation of fatigue behavior for adhesively-bonded GFRP/steel joints

Zhengwen Jiang et al.

ENGINEERING STRUCTURES (2020)

添加到收藏夹

Article Engineering, Mechanical

Fabrication and curing conditions effects on the fatigue behavior of a structural adhesive

Andrea I. M. Foletti et al.

INTERNATIONAL JOURNAL OF FATIGUE (2020)

添加到收藏夹

Article Mechanics

Experimental and numerical failure analyses of dissimilar material joints between aluminium and thermoplastic

N. Wannapa et al.

COMPOSITE STRUCTURES (2020)

添加到收藏夹

Article Engineering, Multidisciplinary

Failure mechanisms in carbon fiber reinforced plastics (CFRP)/aluminum (Al) adhesive bonds subjected to low-velocity transverse pre-impact following by axial post-tension

Xinglong Liu et al.

COMPOSITES PART B-ENGINEERING (2019)

添加到收藏夹

Article Engineering, Mechanical

Numerical and experimental investigation of the effect of the cold expansion process on the fatigue behavior of hybrid (bonded-bolted) double shear lap aluminum joints

Z. Emami Geiglou et al.

INTERNATIONAL JOURNAL OF FATIGUE (2019)

添加到收藏夹

Review Engineering, Multidisciplinary

Review on techniques to improve the strength of adhesive joints with composite adherends

X. Shang et al.

COMPOSITES PART B-ENGINEERING (2019)

添加到收藏夹

Article Engineering, Multidisciplinary

NaOH etching and resin pre-coating treatments for stronger adhesive bonding between CFRP and aluminium alloy

Yunsen Hu et al.

COMPOSITES PART B-ENGINEERING (2019)

添加到收藏夹

Article Mechanics

On fracture characteristics of adhesive joints with dissimilar materials - An experimental study using digital image correlation (DIC) technique

Guangyong Sun et al.

COMPOSITE STRUCTURES (2018)

添加到收藏夹

Article Engineering, Mechanical

A cohesive zone element for mode I modelling of adhesives degraded by humidity and fatigue

M. Costa et al.

INTERNATIONAL JOURNAL OF FATIGUE (2018)

添加到收藏夹

Article Engineering, Mechanical

Analysis of aluminum sheets with multiple sites damage based on fatigue tests and DIC technique

Yajun Chen et al.

INTERNATIONAL JOURNAL OF FATIGUE (2018)

添加到收藏夹

Article Engineering, Chemical

Environmental effect on the fatigue degradation of adhesive joints: A review

M. Costa et al.

JOURNAL OF ADHESION (2017)

添加到收藏夹

Article Engineering, Mechanical

Fatigue performance of a cold-curing structural epoxy adhesive subjected to moist environments

Maria Savvilotidou et al.

INTERNATIONAL JOURNAL OF FATIGUE (2017)

添加到收藏夹

Article Engineering, Mechanical

Recent progress on damage mechanisms in polymeric adhesively bonded high-performance composite joints under fatigue

Sheriff O. Olajide et al.

INTERNATIONAL JOURNAL OF FATIGUE (2017)

添加到收藏夹

Article Engineering, Civil

Effect of Humidity on The Fatigue Behaviour of Adhesively Bonded Aluminium Joints

M. Costa et al.

LATIN AMERICAN JOURNAL OF SOLIDS AND STRUCTURES (2017)

添加到收藏夹

Article Mechanics

Static and fatigue testing bolted, bonded and hybrid step lap joints of thick carbon fibre/epoxy laminates used on aircraft structures

Nabil M. Chowdhury et al.

COMPOSITE STRUCTURES (2016)

添加到收藏夹

Article Engineering, Multidisciplinary

Experimental and finite element studies of thin bonded and hybrid carbon fibre double lap joints used in aircraft structures

Nabil M. Chowdhury et al.

COMPOSITES PART B-ENGINEERING (2016)

添加到收藏夹

Article Engineering, Multidisciplinary

Experimental and finite element studies of bolted, bonded and hybrid step lap joints of thick carbon fibre/epoxy panels used in aircraft structures

Nabil M. Chowdhury et al.

COMPOSITES PART B-ENGINEERING (2016)

添加到收藏夹

Article Engineering, Civil

Using digital image correlation to evaluate fatigue behavior of strengthened reinforced concrete beams

Mohammed Mahal et al.

ENGINEERING STRUCTURES (2015)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of mixed adhesive joints and tapered plate on stresses in retrofitted beams bonded with a fiber-reinforced polymer plate

A. S. Bouchikhi et al.

MATERIALS & DESIGN (2013)

添加到收藏夹

Article Engineering, Manufacturing

A hybrid S-N formulation for fatigue life modeling of composite materials and structures

Roohollah Sarfaraz et al.

COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2012)

添加到收藏夹

Article Engineering, Chemical

An experimental study of Flat-Joggle-Flat bonded joints in composite laminates

A. Nanda Kishore et al.

INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES (2012)

添加到收藏夹

Article Engineering, Mechanical

Identification of a crack propagation law by digital image correlation

Florent Mathieu et al.

INTERNATIONAL JOURNAL OF FATIGUE (2012)

添加到收藏夹

Article Engineering, Mechanical

Experimental investigation of the fatigue behavior of adhesively-bonded pultruded GFRP joints under different load ratios

Roohollah Sarfaraz et al.

INTERNATIONAL JOURNAL OF FATIGUE (2011)

添加到收藏夹

Article Mechanics

Biaxial High Cycle Fatigue of a type 304L stainless steel: Cyclic strains and crack initiation detection by digital image correlation

M. Poncelet et al.

EUROPEAN JOURNAL OF MECHANICS A-SOLIDS (2010)

添加到收藏夹

Article Engineering, Mechanical

Predicting fatigue damage in adhesively bonded joints using a cohesive zone model

H. Khoramishad et al.

INTERNATIONAL JOURNAL OF FATIGUE (2010)

添加到收藏夹

Article Materials Science, Composites

Environmental effects on fatigue behavior of adhesively-bonded pultruded structural joints

Ye Zhang et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2009)

添加到收藏夹

Article Engineering, Chemical

An investigation into the crack initiation and propagation behaviour of bonded single-lap joints using backface strain

V. Shenoy et al.

INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES (2009)

添加到收藏夹

Article Engineering, Mechanical

Life prediction of bonded joints in composite materials

M. Quaresimin et al.

INTERNATIONAL JOURNAL OF FATIGUE (2006)

添加到收藏夹

Article Materials Science, Composites

Fatigue behaviour and damage evolution of single lap bonded joints in composite material

M Quaresimin et al.

COMPOSITES SCIENCE AND TECHNOLOGY (2006)

添加到收藏夹

Article Engineering, Chemical

Investigating fatigue damage evolution in adhesively bonded structures using backface strain measurement

AD Crocombe et al.

JOURNAL OF ADHESION (2002)

添加到收藏夹

Article Engineering, Chemical

Mode I fracture of epoxy bonded composite joints - 2. Fatigue loading

IA Ashcroft et al.

INTERNATIONAL JOURNAL OF ADHESION AND ADHESIVES (2002)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.