4.7 Article

Mechanical and tribological properties of Ti-Al-Ta-N/TiAl and Ti-Al-Ta-N/Ta multilayer coatings deposited by DC magnetron sputtering

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Physics, Condensed Matter

Insertion and diffusion of N and C in γ-TiAl: Theoretical study and comparison with O

E. Epifano et al.

Summary: This study investigates the role of nitrogen and carbon in the oxidation of Ti-Al intermetallic alloys in air, using first-principle computations to study the insertion and diffusion of these elements in the gamma-TiAl phase. Results show that both carbon and nitrogen prefer Ti-rich environments, and anisotropic diffusion is obtained for all the interstitial species in gamma-TiAl.

PHYSICA B-CONDENSED MATTER (2022)

Article Materials Science, Ceramics

Analysis of the mechanical properties of TiN/Ti multilayer coatings using indentation under a broad load range

Zhanwei Yuan et al.

Summary: The study demonstrates that TiN/Ti multilayer coatings exhibit good hardness and Young's modulus, as well as crack resistance and fracture toughness. Increasing the number of layers in the multilayer coatings reduces the hardness and Young's modulus, but increases equivalent plastic strain.

CERAMICS INTERNATIONAL (2021)

Article Materials Science, Coatings & Films

Residual stresses and tribomechanical behaviour of TiAlN and TiAlCN monolayer and multilayer coatings by DCMS and HiPIMS

Wolfgang Tillmann et al.

Summary: This study deposited ternary nitrides with carbon atoms into tool steel using different techniques, and found that the introduction of carbon significantly reduced residual stresses. The compressive residual stresses in multilayer coatings increased with the addition of TiAlN interlayers, and the wear coefficients of HiPIMS coatings were notably lower than DCMS coatings.

SURFACE & COATINGS TECHNOLOGY (2021)

Review Chemistry, Physical

A review on wear-resistant coating with high hardness and high toughness on the surface of titanium alloy

Haiqiang Bai et al.

Summary: The design and development of high hardness, high toughness and wear-resistant coatings are of great significance for expanding the application of titanium alloy. Current research focuses on the design concept of multi-phase, multi-level and multi-scale hybrid reinforcement to achieve high-performance wear-resistant coatings.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

Article Nanoscience & Nanotechnology

Free volume evolution dominated by glass forming ability determining mechanical performance in ZrxTi65-xBe27.5Cu7.5 metallic glasses

Xiangkui Liu et al.

Summary: The total free volume, consisting of intrinsic and excess free volume, plays a crucial role in determining the plasticity of metallic glasses. Metallic glasses with Zr content ranging from 30 to 45 at% exhibit enhanced plasticity due to their larger content of total free volume.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

Review Materials Science, Multidisciplinary

Characteristics and Wear Mechanisms of TiAlN-Based Coatings for Machining Applications: A Comprehensive Review

Vitor F. C. Sousa et al.

Summary: The machining process is still relevant in today's industry, with the development of tool coatings improving productivity and tool life. Advanced coatings like TiAlN doped with Ru, Mo and Ta show potential for enhanced mechanical properties and wear behavior. Research is focusing on nanolayered and nanocomposite TiAlN coatings for improved properties in machining applications.

METALS (2021)

Article Materials Science, Multidisciplinary

Erosion behavior and failure mechanism of Ti/TiAlN multilayer coatings eroded by silica sand and glass beads

Jintao Shuai et al.

Summary: The research demonstrates that the erosion behavior and rate of Ti/TiAlN multilayer coatings vary under different particle erosion conditions. Increasing the deposition cycles dramatically increases the erosion rate of the coatings, resulting in decreased mechanical properties; the coatings treated by glass beads show a low dependence on the number of cycles, with failure mechanism being piece by piece failure.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2021)

Article Mechanics

Multiscale Fracture of Ti-Al-N Coatings under Uniaxial Tension

A. R. Shugurov et al.

Summary: The fracture behavior of Ti0.45Al0.55N coatings under uniaxial tension is affected by the distribution of aluminum, with macroscopic fracture occurring in four stages determined by competition between different stress relaxation mechanisms. The effect of coating thickness on the development of competing deformation and fracture mechanisms in the coatings is demonstrated.

PHYSICAL MESOMECHANICS (2021)

Article Materials Science, Ceramics

Comparative study on crack resistance of TiAlN monolithic and Ti/TiAlN multilayer coatings

Jintao Shuai et al.

CERAMICS INTERNATIONAL (2020)

Article Materials Science, Coatings & Films

Tuning of mechanical properties of Ti1-xAlxN coatings through Ta alloying

A. R. Shugurov et al.

SURFACE & COATINGS TECHNOLOGY (2020)

Article Materials Science, Coatings & Films

Chemical bonding analysis in Ti1-x-yAlxTayN solid solutions

S. Eremeev et al.

SURFACE & COATINGS TECHNOLOGY (2020)

Article Materials Science, Coatings & Films

Enhanced thermal stability and fracture toughness of TiAlN coatings by Cr, Nb and V-alloying

Y. H. Chen et al.

SURFACE & COATINGS TECHNOLOGY (2018)

Article Materials Science, Coatings & Films

High-temperature tribology and oxidation of Ti1-x-yAlxTayN hard coatings

Birgit Grossmann et al.

SURFACE & COATINGS TECHNOLOGY (2018)

Article Materials Science, Multidisciplinary

Mechanical and tribological behavior of Ti/TiN and TiAl/TiAlN coated austempered ductile iron

Diego A. Colombo et al.

THIN SOLID FILMS (2018)

Article Materials Science, Multidisciplinary

Influence of Ta on the fracture toughness of arc evaporated Ti-Al-N

W. M. Seidl et al.

VACUUM (2018)

Article Materials Science, Coatings & Films

Mechanical properties and tribological behavior of magnetron sputtered TiAlN/TiAl multilayer coatings

Artur R. Shugurov et al.

SURFACE & COATINGS TECHNOLOGY (2018)

Article Materials Science, Coatings & Films

Experimental and computational studies on toughness enhancement in Ti-Al-Ta-N quaternaries

Marian Mikula et al.

JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A (2017)

Article Materials Science, Coatings & Films

Influence of Mo on the structure and the tribomechanical properties of arc evaporated Ti-Al-N

S. A. Glatz et al.

SURFACE & COATINGS TECHNOLOGY (2017)

Article Materials Science, Coatings & Films

Improved surface quality of layered architecture TiAlTaN/Ta coatings for high precision micromachining

Xudong Sui et al.

SURFACE & COATINGS TECHNOLOGY (2017)

Article Materials Science, Coatings & Films

Arc evaporated W-alloyed Ti-Al-N coatings for improved thermal stability, mechanical, and tribological properties

S. A. Glatz et al.

SURFACE & COATINGS TECHNOLOGY (2017)

Article Multidisciplinary Sciences

Fracture toughness and structural evolution in the TiAlN system upon annealing

M. Bartosik et al.

SCIENTIFIC REPORTS (2017)

Article Materials Science, Multidisciplinary

Toughness enhancement in highly NbN-alloyed Ti-Al-N hard coatings

Marian Mikula et al.

ACTA MATERIALIA (2016)

Article Engineering, Mechanical

Advanced analysis of crack tip plastic zone under cyclic loading

Michael Besel et al.

INTERNATIONAL JOURNAL OF FATIGUE (2016)

Article Chemistry, Physical

Deposition and characterization of titanium aluminum nitride coatings prepared by RF magnetron sputtering

Amina Zouina Ait-Djafer et al.

APPLIED SURFACE SCIENCE (2015)

Article Nanoscience & Nanotechnology

Influence of Temperature on Oxidation Mechanisms of Fiber-Textured AlTiTaN Coatings

Vishal Khetan et al.

ACS APPLIED MATERIALS & INTERFACES (2014)

Article Chemistry, Physical

Effect of microstructure and phase constitution on mechanical properties of Ti1-xAlxN coatings

Sai Pramod Pemmasani et al.

APPLIED SURFACE SCIENCE (2014)

Article Materials Science, Coatings & Films

Origin of high temperature oxidation resistance of Ti-Al-Ta-N coatings

R. Hollerweger et al.

SURFACE & COATINGS TECHNOLOGY (2014)

Article Materials Science, Coatings & Films

The effect of droplets in arc evaporated TiAlTaN hard coatings on the wear behavior

M. Tkadletz et al.

SURFACE & COATINGS TECHNOLOGY (2014)

Review Materials Science, Coatings & Films

Lubricious oxide coatings for extreme temperature applications: A review

S. M. Aouadi et al.

SURFACE & COATINGS TECHNOLOGY (2014)

Article Engineering, Mechanical

Monitoring of Wear Characteristics of TiN and TiAlN Coatings at Long Sliding Distances

Halil Caliskan et al.

TRIBOLOGY TRANSACTIONS (2014)

Article Materials Science, Multidisciplinary

Effect of interlayers on the structure and properties of TiAlN based coatings on WC-Co cemented carbide substrate

Hao Du et al.

INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2013)

Article Materials Science, Multidisciplinary

Friction and wear properties of TiN, TiAIN, AlTiN and CrAlN PVD nitride coatings

Liu Aihua et al.

INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2012)

Article Materials Science, Coatings & Films

Increased thermal stability of Ti-Al-N thin films by Ta alloying

R. Rachbauer et al.

SURFACE & COATINGS TECHNOLOGY (2012)

Article Materials Science, Multidisciplinary

Toughness enhancement in TiAlN-based quarternary alloys

D. G. Sangiovanni et al.

THIN SOLID FILMS (2012)

Article Materials Science, Multidisciplinary

Supertoughening in B1 transition metal nitride alloys by increased valence electron concentration

D. G. Sangiovanni et al.

ACTA MATERIALIA (2011)

Article Chemistry, Physical

Influence of Ti/TiAlN-multilayer designs on their residual stresses and mechanical properties

E. Vogli et al.

APPLIED SURFACE SCIENCE (2011)

Article Materials Science, Multidisciplinary

The effect of increasing V content on structure, mechanical and tribological properties of arc evaporated Ti-Al-V-N coatings

M. Heiler et al.

INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2009)

Article Materials Science, Coatings & Films

On the effect of Ta on improved oxidation resistance of Ti-Al-Ta-N coatings

M. Pfeiler et al.

JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A (2009)

Article Materials Science, Multidisciplinary

Compositional and structural evolution of sputtered Ti-Al-N

Li Chen et al.

THIN SOLID FILMS (2009)

Article Materials Science, Multidisciplinary

Mechanical and tribological properties of Ti/TiAlN duplex coatings on high and low alloy tool steels

Wolfgang Tillmann et al.

VACUUM (2009)

Article Materials Science, Coatings & Films

Stress and preferred orientation in nitride-based PVD coatings

G. Abadias

SURFACE & COATINGS TECHNOLOGY (2008)

Article Multidisciplinary Sciences

Ductile crystalline-amorphous nanolaminates

Yinmin Wang et al.

PROCEEDINGS OF THE NATIONAL ACADEMY OF SCIENCES OF THE UNITED STATES OF AMERICA (2007)

Review Materials Science, Multidisciplinary

Overview No.144 - Mechanical behavior of amorphous alloys

Christopher A. Schuh et al.

ACTA MATERIALIA (2007)

Article Materials Science, Coatings & Films

Microstructure and physical properties of arc ion plated TiAlN/Cu thin film

Ming-Sheng Leu et al.

SURFACE & COATINGS TECHNOLOGY (2006)

Article Materials Science, Coatings & Films

Multifunctional multi-component PVD coatings for cutting tools

M Kathrein et al.

SURFACE & COATINGS TECHNOLOGY (2005)

Article Materials Science, Coatings & Films

Optimization and thermal stability of TiAlN/Mo multilayers

CJ Tavares et al.

SURFACE & COATINGS TECHNOLOGY (2005)

Article Materials Science, Coatings & Films

Influence of bias variation on residual stress and texture in TiAIN PVD coatings

M Ahlgren et al.

SURFACE & COATINGS TECHNOLOGY (2005)

Article Materials Science, Coatings & Films

Toughening of hard nanostructural thin films: a critical review

S Zhang et al.

SURFACE & COATINGS TECHNOLOGY (2005)

Article Materials Science, Coatings & Films

Comparative study of the tribological behaviour of superhard nanocomposite coatings nc-TiN/a-Si3N4 with TiN

S Ma et al.

SURFACE & COATINGS TECHNOLOGY (2005)

Article Engineering, Industrial

Effect of ductile layers in mechanical behaviour of TiAlN thin coatings

JM Castanho et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2003)

Review Nanoscience & Nanotechnology

Single layer and multilayer wear resistant coatings of (Ti,Al)N: a review

S PalDey et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2003)

Article Engineering, Chemical

Influence of surface morphology on the adhesion strength of epoxy-aluminum interfaces

S Zhang et al.

JOURNAL OF ADHESION SCIENCE AND TECHNOLOGY (2003)

Article Materials Science, Coatings & Films

Effect of contact geometry on the failure modes of thin coatings in the scratch adhesion test

Y Xie et al.

SURFACE & COATINGS TECHNOLOGY (2002)

Article Materials Science, Multidisciplinary

Effects of the substrate on the determination of thin film mechanical properties by nanoindentation

R Saha et al.

ACTA MATERIALIA (2002)

Article Materials Science, Multidisciplinary

A structural and mechanical analysis on PVD-grown (Ti,Al)N/Mo multilayers

CJ Tavares et al.

THIN SOLID FILMS (2000)