4.6 Review

A Review of Mechanical and Chemical Sensors for Automotive Li-Ion Battery Systems

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Energy & Fuels

Hierarchical soft measurement of load current and state of charge for future smart lithium-ion batteries

Zhongbao Wei et al.

Summary: This paper proposes a hierarchical soft measurement framework for accurate estimation of SOC and load current in electric vehicles, even without using current measurements. Simulation and experimental results show that the framework can achieve high-fidelity co-estimation even in scenarios of noise corruption and current sensor malfunction.

APPLIED ENERGY (2022)

Article Engineering, Electrical & Electronic

Multistage State of Health Estimation of Lithium-Ion Battery With High Tolerance to Heavily Partial Charging

Zhongbao Wei et al.

Summary: This study proposes a multistage SOH estimation method that can accurately estimate the health status of LIBs even under partial charging conditions. By extracting different sets of health indicators and using artificial neural networks for fusion, the accuracy and robustness of the estimates are improved.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2022)

Article Engineering, Electrical & Electronic

Residual Statistics-Based Current Sensor Fault Diagnosis for Smart Battery Management

Jian Hu et al.

Summary: This article proposes a novel residual statistics-based diagnostic method for current sensor fault diagnosis in lithium-ion batteries. The method utilizes only a small number of samples at the startup phase to accurately detect two typical sensor faults. Experimental validation shows that the method is highly robust and has a low false alarm rate.

IEEE JOURNAL OF EMERGING AND SELECTED TOPICS IN POWER ELECTRONICS (2022)

Review Engineering, Electrical & Electronic

Charging Optimization for Li-Ion Battery in Electric Vehicles: A Review

Cuili Chen et al.

Summary: This article provides a comprehensive review of existing charging optimization techniques for lithium-ion batteries, addressing the challenges of long charging time and degradation caused by fast charging. It discusses the operation and models of lithium-ion batteries and scrutinizes the side effects of unregulated fast charging on battery aging mechanism. The state-of-the-art open- and close-loop charging optimization techniques are systematically reviewed, highlighting their respective merits and shortcomings. The future development of a charging control protocol with real-time affordability and degradation consciousness is also discussed.

IEEE TRANSACTIONS ON TRANSPORTATION ELECTRIFICATION (2022)

Article Chemistry, Physical

In operando measuring circumferential internal strain of 18650 Li-ion batteries by thin film strain gauge sensors

Shengxin Zhu et al.

Summary: A new method for measuring internal strain in the 18650 Li-ion battery has been developed, which shows promise in achieving a better understanding of the internal strain evolution process.

JOURNAL OF POWER SOURCES (2021)

Article Chemistry, Physical

Future smart battery and management: Advanced sensing from external to embedded multi-dimensional measurement

Zhongbao Wei et al.

Summary: With advancements in technology, smart batteries and management systems have emerged as the new focus. Research is shifting towards smart batteries and smart cell management to address the limitations of traditional BMS. Emerging sensing techniques and system integration innovations present new opportunities and challenges for battery management.

JOURNAL OF POWER SOURCES (2021)

Review Chemistry, Analytical

Fiber Optic Sensing Technologies for Battery Management Systems and Energy Storage Applications

Yang D. Su et al.

Summary: The use of fiber optic sensors in battery monitoring is increasing due to the demand for enhanced battery management systems with accurate state estimations. This review explores the advancements in practical implementation of internal and external parameter measurements in batteries, as well as the challenges and future prospects of integrating fiber optics into high-value battery applications.

SENSORS (2021)

Review Chemistry, Physical

Cause and Mitigation of Lithium-Ion Battery Failure-A Review

Muthukrishnan Kaliaperumal et al.

Summary: Lithium-ion batteries are considered a viable option for meeting the increasing demand for energy storage, but their fragility and potential failure modes must be carefully addressed. Mitigation strategies include intrinsic safety measures, additional protection devices, and fire suppression and ventilation methods.

MATERIALS (2021)

Review Electrochemistry

Review-Use of Impedance Spectroscopy for the Estimation of Li-ion Battery State of Charge, State of Health and Internal Temperature

Kieran Mc Carthy et al.

Summary: The rapid adoption of electric vehicles and portable electronic devices has increased the demand for enhanced state diagnosis of Li-ion batteries. To meet these requirements, improvements in battery state monitoring must be made, with electrochemical impedance spectroscopy becoming a gradually recognized diagnostic tool.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2021)

Review Engineering, Multidisciplinary

Review of Battery Management Systems (BMS) Development and Industrial Standards

Hossam A. Gabbar et al.

Summary: The increasing demand for energy storage systems (ESS) due to evolving global landscape for electrical distribution has made them one of the fastest growing electrical power system products. A key element in ESS is the battery management system (BMS) which monitors, controls, and optimizes battery performance, ensuring safety within the system. This report provides a detailed analysis of BMS for electric transportation and large-scale energy storage, offering recommendations for improvement in safety and performance across different aspects of BMS.

TECHNOLOGIES (2021)

Article Electrochemistry

Early Detection of Failing Automotive Batteries Using Gas Sensors

Christiane Essl et al.

Summary: The study investigated gases produced during battery failure, before and during thermal runaway, and tested different gas sensors as early detectors of battery incidents. Several commercially available gas sensors were tested in four battery failure cases, showing that gas sensors can detect battery failures depending on the specific case. The chosen gas sensor was able to detect hydrogen from unwanted electrolysis, electrolyte vapor, and gases released from state-of-the-art LIBs, contributing significantly to improving battery safety.

BATTERIES-BASEL (2021)

Article Energy & Fuels

Detection of Li-ion battery failure and venting with Carbon Dioxide sensors

Ting Cai et al.

Summary: This study addresses the critical safety issue of Li-ion battery thermal runaway in Electric Vehicles and proposes a 5-minute advanced warning requirement prior to thermal runaway. By evaluating gas venting and selecting CO2 as the target gas species, along with using the NDIR CO2 sensor, sensitive detection of thermal runaway can be achieved.

ETRANSPORTATION (2021)

Article Materials Science, Multidisciplinary

Detection of electrolyte leakage from lithium-ion batteries using a miniaturized sensor based on functionalized double-walled carbon nanotubes

Xiaowen Du et al.

Summary: The study introduced a miniaturized sensor based on functionalized double-walled carbon nanotubes to detect DMC vapours and monitor electrolyte leakage from lithium-ion batteries, showing high sensitivity and fast response/recovery speed.

JOURNAL OF MATERIALS CHEMISTRY C (2021)

Article Computer Science, Information Systems

Protection Devices in Commercial 18650 Lithium-Ion Batteries

Bin Xu et al.

Summary: 18650 Lithium-ion batteries are widely used for portable electronics due to their standardized format and low manufacturing cost. Commercial 18650 cells vary in designs with different protection devices. This paper disassembles and compares four representative commercial 18650 batteries in terms of protection devices, providing recommendations on battery selection and future trends.

IEEE ACCESS (2021)

Article Green & Sustainable Science & Technology

High-Precision Monitoring of Volume Change of Commercial Lithium-Ion Batteries by Using Strain Gauges

Lisa K. Willenberg et al.

SUSTAINABILITY (2020)

Article Energy & Fuels

Battery Models for Battery Powered Applications: A Comparative Study

Nicola Campagna et al.

ENERGIES (2020)

Review Chemistry, Analytical

Development and Application of Resistance Strain Force Sensors

Yinming Zhao et al.

SENSORS (2020)

Article Computer Science, Information Systems

State of Charge Estimation in Lithium-Ion Batteries: A Neural Network Optimization Approach

M. S. Hossain Lipu et al.

ELECTRONICS (2020)

Article Engineering, Electrical & Electronic

A Review of Battery State of Health Estimation Methods: Hybrid Electric Vehicle Challenges

Nassim Noura et al.

WORLD ELECTRIC VEHICLE JOURNAL (2020)

Review Chemistry, Analytical

Structural Health Monitoring Using Fibre Optic Acoustic Emission Sensors

James Owen Willberry et al.

SENSORS (2020)

Article Chemistry, Analytical

Gas Leakage Source Detection for Li-Ion Batteries by Distributed Sensor Array

Valentin Mateev et al.

SENSORS (2019)

Article Engineering, Electrical & Electronic

Temperature Sensing and Evaluation of Thermal Effects on Battery Packs for Automotive Applications

Filippo Ruffa et al.

IEEE SENSORS JOURNAL (2019)

Article Chemistry, Physical

Internal strain and temperature discrimination with optical fiber hybrid sensors in Li-ion batteries

Micael Nascimento et al.

JOURNAL OF POWER SOURCES (2019)

Review Chemistry, Analytical

Chemical Sensor Systems and Associated Algorithms for Fire Detection: A Review

Jordi Fonollosa et al.

SENSORS (2018)

Review Chemistry, Physical

Chemical Sensing Applications of ZnO Nanomaterials

Savita Chaudhary et al.

MATERIALS (2018)

Article Electrochemistry

Simultaneous Sensing of Temperature and Bi-Directional Strain in a Prismatic Li-Ion Battery

Micael Nascimento et al.

BATTERIES-BASEL (2018)

Article Chemistry, Multidisciplinary

Thermal runaway of large automotive Li-ion batteries

Andrey W. Golubkov et al.

RSC ADVANCES (2018)

Article Chemistry, Physical

Determination of the core temperature of a Li-ion cell during thermal runaway

M. Parhizi et al.

JOURNAL OF POWER SOURCES (2017)

Article Engineering, Electrical & Electronic

Low concentration CO gas sensing properties of hybrid ZnO architecture

A. Tamvakos et al.

MICROELECTRONIC ENGINEERING (2016)

Article Materials Science, Multidisciplinary

In Situ Measurements of Strains in Composite Battery Electrodes during Electrochemical Cycling

E. M. C. Jones et al.

EXPERIMENTAL MECHANICS (2014)

Article Chemistry, Physical

In-situ characterization of strain in lithium battery working electrodes

Jubin Chen et al.

JOURNAL OF POWER SOURCES (2014)

Article Chemistry, Physical

Battery internal temperature estimation by combined impedance and surface temperature measurement

Robert R. Richardson et al.

JOURNAL OF POWER SOURCES (2014)

Article Materials Science, Multidisciplinary

Measurement and modeling of the mechanical and electrochemical response of amorphous Si thin film electrodes during cyclic lithiation

Giovanna Bucci et al.

JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2014)

Review Materials Science, Multidisciplinary

SnO2: A comprehensive review on structures and gas sensors

Soumen Das et al.

PROGRESS IN MATERIALS SCIENCE (2014)

Review Materials Science, Multidisciplinary

Deformation and stress in electrode materials for Li-ion batteries

Amartya Mukhopadhyay et al.

PROGRESS IN MATERIALS SCIENCE (2014)

Article Engineering, Electrical & Electronic

A Modularized Charge Equalizer Using a Battery Monitoring IC for Series-Connected Li-Ion Battery Strings in Electric Vehicles

Chol-Ho Kim et al.

IEEE TRANSACTIONS ON POWER ELECTRONICS (2013)

Review Chemistry, Analytical

Fiber Bragg Grating Sensors for Harsh Environments

Stephen J. Mihailov

SENSORS (2012)

Article Electrochemistry

In situ measurement of biaxial modulus of Si anode for Li-ion batteries

V. A. Sethuraman et al.

ELECTROCHEMISTRY COMMUNICATIONS (2010)

Article Electrochemistry

In Situ Observation of Strains during Lithiation of a Graphite Electrode

Yue Qi et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2010)

Review Chemistry, Analytical

Metal Oxide Gas Sensors: Sensitivity and Influencing Factors

Chengxiang Wang et al.

SENSORS (2010)

Article Electrochemistry

Lithium methyl carbonate as a reaction product of metallic lithium and dimethyl carbonate

GV Zhuang et al.

ELECTROCHEMICAL AND SOLID STATE LETTERS (2006)

Review Instruments & Instrumentation

Review of temperature measurement

PRN Childs et al.

REVIEW OF SCIENTIFIC INSTRUMENTS (2000)