期刊
SENSORS
卷 22, 期 11, 页码 -出版社
MDPI
DOI: 10.3390/s22114004
关键词
colossal magnetoresistance; low-field magnetoresistance; manganite films; nanostructured thin films; MOCVD technology; magnetic field sensors
资金
- European Regional Development Fund [01.2.2-LMT-K-718-05-0068]
- Research Council of Lithuania (LMTLT)
- Education Exchanges Support Foundation [AM-PL-2016-LT-13]
The results of this study show that the microstructure, resistivity, and magnetoresistive properties of LSMO films grown by the pulsed injection MOCVD technique are strongly influenced by the concentrations of strontium and manganese. The highest metal-insulator transition temperature (T-m) observed was 270 K, while the highest low-field magnetoresistance at room temperature was 0.8%.
The results of colossal magnetoresistance (CMR) properties of La1-xSrxMnyO3 (LSMO) films grown by the pulsed injection MOCVD technique onto an Al2O3 substrate are presented. The grown films with different Sr (0.05 <= x <= 0.3) and Mn excess (y > 1) concentrations were nanostructured with vertically aligned column-shaped crystallites spread perpendicular to the film plane. It was found that microstructure, resistivity, and magnetoresistive properties of the films strongly depend on the strontium and manganese concentration. All films (including low Sr content) exhibit a metal-insulator transition typical for manganites at a certain temperature, T-m. The T-m vs. Sr content dependence for films with a constant Mn amount has maxima that shift to lower Sr values with the increase in Mn excess in the films. Moreover, the higher the Mn excess concentration in the films, the higher the T-m value obtained. The highest T-m values (270 K) were observed for nanostructured LSMO films with x = 0.17-0.18 and y = 1.15, while the highest low-field magnetoresistance (0.8% at 50 mT) at room temperature (290 K) was achieved for x = 0.3 and y = 1.15. The obtained low-field MR values were relatively high in comparison to those published in the literature results for lanthanum manganite films prepared without additional insulating oxide phases. It can be caused by high Curie temperature (383 K), high saturation magnetization at room temperature (870 emu/cm(3)), and relatively thin grain boundaries. The obtained results allow to fabricate CMR sensors for low magnetic field measurement at room temperature.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据