☆ 4.6 Article

High-Temperature Cycle Deformation and Fracture Behavior of Advanced Austenitic Heat-Resistant Steel Sanicro25 Alloy for A-USC Power Plants

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Engineering, Mechanical

Microstructural evolution during high temperature dwell-fatigue of austenitic stainless steels

Hugo Warner et al.

Summary: The study found that coherent Cu-precipitates and incoherent Nbcarbides in Sanicro 25 hinder dislocation motion, increase hardening, and improve high temperature properties, while sparsely placed intergranular Cr- and Nb-carbides in Esshete 1250 make it susceptible to creep damage and intergranular crack propagation. Dynamic recrystallization of the plastic zone at the crack tip seemed to affect crack propagation of Sanicro 25 by providing an energetically privileged path.

INTERNATIONAL JOURNAL OF FATIGUE (2021)

添加到收藏夹

Article Nanoscience & Nanotechnology

Study on high temperature creep behavior of the accident-resistant cladding Fe-13Cr-4Al-1.85Mo-0.85Nb alloy

Hongying Sun et al.

Summary: The study systematically investigates the creep behaviors of a Fe-13Cr-4Al-1.85Mo-0.85Nb alloy at 400-450 degrees C, showing that the steady-state creep rates increase with loaded stress and vary between different directions. The results provide useful references for the engineering application of the alloy as accident-resistant fuel cladding material.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)

添加到收藏夹

Article Construction & Building Technology

Studies on the experimental and simulated cyclic-plastic response of structural mild steels

Atri Nath et al.

Summary: Experimental investigations were conducted on the cyclic-plastic response of structural mild steel Grade YST210 under varying strain amplitudes. Results were analyzed using a Chaboche isotopic-kinematic hardening model and parameters were optimized with a genetic algorithm. The study revealed cyclic softening in YST210 steel and showed improvements in predictions for other steel grades.

JOURNAL OF CONSTRUCTIONAL STEEL RESEARCH (2021)

添加到收藏夹

Article Construction & Building Technology

Experimental study on the cumulative damage constitutive model of high-performance steel Q345GJ under cyclic loading

Le Shen et al.

Summary: This study investigates the low cycle fatigue performance and cumulative damage behaviors of GJ series steel, proposing a suitable constitutive relationship and cumulative damage model for the steel, which is proven correct through comparison with test data.

JOURNAL OF CONSTRUCTIONAL STEEL RESEARCH (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Creep and Hot Tensile Behavior of AISI 201LN Austenitic Stainless Steel

Gustavo Henrique Pelissari et al.

Summary: AISI 200LN is a low nickel austenitic stainless steel with excellent mechanical properties at room and cryogenic temperatures, and this study aims to assess its mechanical response under hot tensile and creep tests. By conducting tests and analyzing correlations among various factors, the study provides insights into the creep behavior of AISI 201LN alloy, compared to traditional stainless steels in the 300 series.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Creep Deformation Behavior of Inconel 617 Alloy in the Temperature Range of 650 °C to 800 °C

Sumanta Bagui et al.

Summary: The creep behavior of Inconel 617 alloy was investigated under different temperatures and stress conditions. The results show that with increasing temperature, the primary creep rate first decreases to a minimum value, followed by a typical increase. Additionally, the presence of M23C6 and gamma' precipitates obstruct dislocation motion, leading to the development of a steady-state region in the later stages of creep.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Dislocation-particle interactions in magnesium alloys

C. Y. Wang et al.

ACTA MATERIALIA (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Analysis of transient and tertiary creep behavior of Titanium modified 14Cr-15Ni stainless steel after cold working

Hari Krishan Yadav et al.

MATERIALS RESEARCH EXPRESS (2020)

添加到收藏夹

Article Construction & Building Technology

Creep behavior and model of high-strength steels over 500 MPa at elevated temperatures

Guo-Qiang Li et al.

JOURNAL OF CONSTRUCTIONAL STEEL RESEARCH (2020)

添加到收藏夹

Article Nanoscience & Nanotechnology

High-temperature creep deformation in FeCrAl-oxide dispersion strengthened alloy cladding

S. Ukai et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)

添加到收藏夹

Article Engineering, Mechanical

Life, dislocation evolution, and fracture mechanism of a 41Fe-25.5Ni-23.5Cr alloy during low cycle fatigue at 700 °C

Haizhou Li et al.

INTERNATIONAL JOURNAL OF FATIGUE (2019)

添加到收藏夹

Article Engineering, Mechanical

Fatigue behavior, microstructural evolution, and fatigue life model based on dislocation annihilation of an Fe-Ni-Cr alloy at 700 °C

Haizhou Li et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Analysis of creep deformation and damage behaviour of 304HCu austenitic stainless steel

Kanhu Charan Sahoo et al.

MATERIALS AT HIGH TEMPERATURES (2019)

添加到收藏夹

Article Engineering, Mechanical

Creep-fatigue endurance of a superheater tube plate under non-isothermal loading and multi-dwell condition

Nak-Kyun Cho et al.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2019)

添加到收藏夹

Article Engineering, Mechanical

Cyclic damage behavior of Sanicro 25 alloy at 700 °C: Dispersed damage and concentrated damage

Haizhou Li et al.

INTERNATIONAL JOURNAL OF PLASTICITY (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Creep Behavior and Microstructural Evolution of a Fe-20Cr-25Ni (Mass Percent) Austenitic Stainless Steel (Alloy 709) at Elevated Temperatures

Abdullah S. Alomari et al.

METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2019)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Formation of Laves Phase in Sanicro 25 Austenitic Steel During Creep-Rupture Test at 700°C

Jiao Suo et al.

METALLOGRAPHY MICROSTRUCTURE AND ANALYSIS (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of Yb microadditions on creep resistance of a dilute Al-Er-Sc-Zr alloy

Nhon Q. Vo et al.

MATERIALIA (2018)

添加到收藏夹

Article Materials Science, Multidisciplinary

Microstructure and texture study on an advanced heat-resistant alloy during creep

Yu Zhang et al.

MATERIALS CHARACTERIZATION (2017)

添加到收藏夹

Article Nanoscience & Nanotechnology

High-temperature deformation and fracture mechanisms of an advanced heat resistant Fe-Cr-Ni alloy

Yu Zhang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

Phenomenological and microstructural analysis of intermediate temperatures creep in a Ni-Fe-based alloy for advanced ultra-supercritical fossil power plants

F. Sun et al.

ACTA MATERIALIA (2016)

添加到收藏夹

Article Materials Science, Multidisciplinary

Microstructure and chemical composition of the oxide scale formed on the sanicro 25 steel tubes after fireside corrosion

Bogdan Rutkowski et al.

CORROSION SCIENCE (2016)

添加到收藏夹

Article Engineering, Mechanical

Evolution of the cyclic plastic response of Sanicro 25 steel cycled at ambient and elevated temperatures

Jaroslav Polak et al.

INTERNATIONAL JOURNAL OF FATIGUE (2016)

添加到收藏夹

Article Nanoscience & Nanotechnology

First-principles evaluation of the effect of alloying elements on the lattice parameter of a 23Cr25NiWCuCo austenitic stainless steel to model solid solution hardening contribution to the creep strength

P. A. Korzhavyi et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Steady-State Creep Behavior of Super304H Austenitic Steel at Elevated Temperatures

Ping Ou et al.

ACTA METALLURGICA SINICA-ENGLISH LETTERS (2015)

添加到收藏夹

Article Materials Science, Multidisciplinary

High-temperature creep behavior and microstructural evolution of an 18Cr9Ni3CuNbVN austenitic stainless steel

Dae-Bum Park et al.

MATERIALS CHARACTERIZATION (2014)

添加到收藏夹

Article Nanoscience & Nanotechnology

Low cycle fatigue behavior of Sanicro25 steel at room and at elevated temperature

Jaroslav Polak et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)

添加到收藏夹

Article Nanoscience & Nanotechnology

Microstructural evolution and compressive deformation of a new Ni-Fe base superalloy after long term thermal exposure at 700 °C

Y. Yuan et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)

添加到收藏夹

Article Nanoscience & Nanotechnology

Constitutive description of high temperature flow behavior of Sanicro-28 super-austenitic stainless steel

A. Mirzaei et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)

添加到收藏夹

Article Materials Science, Multidisciplinary

A new wrought NiFe-base superalloy for advanced ultra-supercritical power plant applications beyond 700 °C

Z. H. Zhong et al.

MATERIALS LETTERS (2013)

添加到收藏夹

Article Construction & Building Technology

Creep effect on buckling of axially restrained steel columns in real fires

Guo-Qiang Li et al.

JOURNAL OF CONSTRUCTIONAL STEEL RESEARCH (2012)

添加到收藏夹

Article Materials Science, Multidisciplinary

Creep deformation mechanisms in modified 9Cr-1Mo steel

Triratna Shrestha et al.

JOURNAL OF NUCLEAR MATERIALS (2012)

添加到收藏夹

Article Nanoscience & Nanotechnology

Creep behaviour of 14Cr-15Ni-Ti stainless steel at 923 K

S. Latha et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)

添加到收藏夹

Article Engineering, Mechanical

High-temperature low cycle fatigue, creep-fatigue and thermomechanical fatigue of steels and their welds

SL Mannan et al.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2006)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of temperature on transitions in creep mechanisms in class-A alloys

KL Murty et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.