☆ 4.7 Article

Achieving high strength in a Mg-Li-Zn-Y alloy by α-Mg precipitation

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Nanoscience & Nanotechnology

Developing a low-alloyed fine-grained Mg alloy with high strength-ductility based on dislocation evolution and grain boundary segregation

Zhi Zhang et al.

Summary: A new low-alloyed Mg-2Sm-0.8Mn-0.6Ca-0.5Zn alloy is prepared by low-temperature and low-speed extrusion, which exhibits high strength but low ductility. After annealing, the alloy shows both high strength and high ductility due to the effective inhibition of grain growth by grain boundary co-segregation and decreased dislocation density. The evolution of immovable long dislocations towards new grain boundaries is a key factor for the remarkable increase of ductility in the annealed alloy.

SCRIPTA MATERIALIA (2022)

添加到收藏夹

Review Metallurgy & Metallurgical Engineering

Towards developing Mg alloys with simultaneously improved strength and corrosion resistance via RE alloying

Jinshu Xie et al.

Summary: Magnesium alloys have great application potential, but improvements in both strength and corrosion resistance are still needed. The addition of rare earth elements can enhance the performance of magnesium alloys, but further research is necessary to improve both strength and anti-corrosion properties.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Microstructure and mechanical properties of high-strength high-pressure die-cast Mg-4Al-3La-1Ca-0.3Mn alloy

Peng-Fei Qin et al.

Summary: The new high-pressure die-cast (HPDC) Mg-4Al-3La-1Ca-0.3Mn (ALaX431) alloy achieves higher strength than existing HPDC Mg alloys, mainly due to the formation of fine grained structure, semi-continuous reticular structure, and nanoscale precipitates. Consequently, it has great potential for wide application.

RARE METALS (2021)

添加到收藏夹

Article Engineering, Manufacturing

Interface behavior and tensile properties of Mg-14Li-3Al-2Gd sheets prepared by four-layer accumulative roll bonding

Zhen Wei et al.

Summary: Mg-14Li-3Al-2Gd sheets were prepared using four-layer accumulative roll bonding (ARB) with two-step rolling in one cycle. The study found that in the ARB process, the number of grains in the normal direction decreased rapidly while the grain size decreased gradually. As the ARB cycle increased, the microstructure evolution shifted from single-layer to multi-layer, leading to increased strength and interfacial bond strength, but a decrease in plasticity.

JOURNAL OF MANUFACTURING PROCESSES (2021)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of Ca addition on the microstructure and mechanical properties of heat-treated Mg-6.0Zn-1.2Y-0.7Zr alloy

Young-Gil Jung et al.

Summary: The addition of Ca improved the ignition resistance and refined the grains of the ZWK611 alloy, leading to enhanced mechanical properties at both room temperature and 150 degrees C. The presence of Tau- and W-phases, as well as the more uniform distribution of MgZn' precipitates in the Ca-added alloys, contributed to the improved performance of the T6-treated alloys.

JOURNAL OF MAGNESIUM AND ALLOYS (2021)

添加到收藏夹

Article Chemistry, Physical

Effects of content and distribution of Zn and Gd on formation ability of I phase and W phase in Mg-Zn-Gd-Zr alloy

Feng Guo et al.

Summary: The solid solution and compounds in Mg-Zn-Gd-Zr magnesium alloy semicontinuous casting ingots were effectively separated by phase separation technique. It was found that increasing the Zn/Gd ratio in the as-cast alloys increases the ratio of I and W phases, while increasing the content of Zn and Gd under a certain Zn/Gd ratio increases the amount of I and W phases simultaneously.

JOURNAL OF ALLOYS AND COMPOUNDS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Effect of Heat Treatment on Low-Cycle Fatigue Performance of LZ91 Mg-Li Alloy

Yang Li et al.

Summary: The effects of heat treatment on the microstructure, tensile properties, and low-cycle fatigue properties of the LZ91 Mg-Li alloy were investigated. The results showed that heat treatment led to spheroidization of the alpha-phase and redistribution of a portion of the needle-like alpha-phase at the beta-phase grain boundary. The ultimate tensile strength and elongation of the material increased by 9.6% and 20% respectively, while the low-cycle fatigue life was improved. The initiation of fatigue cracks on the surface of specimens, mainly in the beta-phase, was suppressed by the needle-like alpha-phase, and the increased alpha-phase microhardness decelerated the crack growth rate, enhancing the low-cycle fatigue life of the alloy.

ADVANCED ENGINEERING MATERIALS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Unveiling the underlying mechanism of forming edge cracks upon high strain-rate rolling of magnesium alloy

Biwu Zhu et al.

JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY (2020)

添加到收藏夹

Article Engineering, Electrical & Electronic

Improvement of electromagnetic shielding properties for Mg-8Li-6Y-2Zn alloy by heat treatment and hot rolling

Jiahao Wang et al.

JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS (2020)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of heat treatment on LPSO morphology and mechanical properties of Mg-Zn-Y-Gd alloys

Hongxin Liao et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2020)

添加到收藏夹

Article Materials Science, Multidisciplinary

Nanoscale precipitations in deformed dilute alloying Mg-Zn-Gd alloy

Hongwei Miao et al.

MATERIALS & DESIGN (2020)

添加到收藏夹

Article Chemistry, Physical

Balance of mechanical properties of Mg-8Li-3Al-2Zn-0.5Y alloy by solution and low-temperature aging treatment

Hao Ji et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

添加到收藏夹

Article Multidisciplinary Sciences

Precipitation strengthening in an ultralight magnesium alloy

Song Tang et al.

NATURE COMMUNICATIONS (2019)

添加到收藏夹

Review Metallurgy & Metallurgical Engineering

Recent developments in high-strength Mg-RE-based alloys: Focusing on Mg-Gd and Mg-Y systems

Jinghuai Zhang et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2018)

添加到收藏夹

Article Chemistry, Physical

Two-dimensional SiS as a potential anode material for lithium-based batteries: A first-principles study

H. R. Jiang et al.

JOURNAL OF POWER SOURCES (2016)

添加到收藏夹

Article Materials Science, Multidisciplinary

Microstructure evolution during heat treatment and mechanical properties of Mg-2.49Nd-1.82Gd-0.19Zn-0.4Zr cast alloy

S. J. Liu et al.

MATERIALS CHARACTERIZATION (2015)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Influence of I-phase and W-phase on microstructure and mechanical properties of Mg-8Li-3Zn alloy

Guo-bing Wei et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2015)

添加到收藏夹

Article Chemistry, Physical

Mechanical properties of the icosahedral phase reinforced duplex Mg-Li alloy both at room and elevated temperatures

D. K. Xu et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2014)

添加到收藏夹

Article Chemistry, Physical

Microstructure and mechanical properties of Mg-xLi-3Al-1Sn-0.4Mn alloys (x=5, 8 and 11 wt%)

Yong-Ho Kim et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2014)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effects of heat treatment on microstructure, mechanical properties and damping capacity of Mg-Zn-Y-Zr alloy

Bangsong Yan et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of heat treatment on microstructures and mechanical properties of high vacuum die casting Mg-8Gd-3Y-0.4Zr magnesium alloy

Zhi-qin Wang et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2014)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of heat treatment on the microstructures and mechanical properties of the sand-cast Mg-2.7Nd-0.6Zn-0.5Zr alloy

D. Wu et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2014)

添加到收藏夹

Article Chemistry, Physical

Microstructure transformations in the heat-treated Mg-Zn-Y alloy

Jiwei Geng et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2013)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of quasicrystal phase on mechanical properties and damping capacities of Mg-Zn-Y-Zr alloys

Rong Ma et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Influence of heat treatment on microstructures and mechanical properties of gravity cast Mg-4.2Zn-1.5RE-0.7Zr magnesium alloy

Ying-dong Wang et al.

TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2013)

添加到收藏夹

Article Metallurgy & Metallurgical Engineering

Effect of Ca addition on grain refinement of Mg-9Li-1Al alloy

Ying Zeng et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2013)

添加到收藏夹

Article Engineering, Biomedical

Influence of ageing treatment on microstructure, mechanical and bio-corrosion properties of Mg-Dy alloys

Lei Yang et al.

JOURNAL OF THE MECHANICAL BEHAVIOR OF BIOMEDICAL MATERIALS (2012)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effects of cold rolling and solid solution treatments on mechanical properties of β-phase Mg-14.3Li-0.8Zn alloy

S. K. Wu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effects of heat treatments on microstructures and mechanical properties of Mg-4Y-2.5Nd-0.7Zr alloy

Lu Xu et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)

添加到收藏夹

Article Electrochemistry

Study on the preparation of Mg-Li-Ag Alloys by electrochemical deposition from LiCl-KCl-MgCl2-AgCl Melts

Mi Lin Zhang et al.

RUSSIAN JOURNAL OF ELECTROCHEMISTRY (2012)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effects of Zn on the microstructure, mechanical properties, and damping capacity of Mg-Zn-Y-Zr alloys

Jingfeng Wang et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)

添加到收藏夹

Article Materials Science, Multidisciplinary

A Study of Aging Treatment on the Mg-10Li-0.5Zn Alloy

P. C. Wang et al.

MATERIALS TRANSACTIONS (2009)

添加到收藏夹

Article Materials Science, Multidisciplinary

Mechanical and anisotropic behaviors of Mg-Li-Zn alloy thin sheets

Ying-Nan Lin et al.

MATERIALS & DESIGN (2008)

添加到收藏夹

Article Materials Science, Multidisciplinary

Tensile fracture behavior of aging hardened Mg-1Ca and Mg-1Ca-1Zn alloys

Y. Ortega et al.

MATERIALS LETTERS (2008)

添加到收藏夹

Article Nanoscience & Nanotechnology

The relationship between macro-fracture modes and roles of different deformation mechanisms for the as-extruded Mg-Zn-Zr alloy

D. K. Xu et al.

SCRIPTA MATERIALIA (2008)

添加到收藏夹

Article Nanoscience & Nanotechnology

The strengthening effect of icosahedral phase on as-extruded Mg-Li alloys

D. K. Xu et al.

SCRIPTA MATERIALIA (2007)

添加到收藏夹

Article Nanoscience & Nanotechnology

Effect of volume fraction of qusicrystal on the mechanical properties of quasicrystal-reinforced Mg-Zn-Y alloys

Ju Youn Lee et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

添加到收藏夹

Article Materials Science, Multidisciplinary

Mechanical properties and microstructures of various Mg-Li alloys

Tien-Chan Chang et al.

MATERIALS LETTERS (2006)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.