4.7 Article

Mechanistic insight into the promoting effect of partial substitution of Mn by Ce on N2 selectivity of MnTiOx catalyst for NH3-SCR of NO

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Chemistry, Physical

Low-Temperature Selective Catalytic Reduction of NO with NH3 Over Mn-Ti Oxide Catalyst: Effect of the Synthesis Conditions

Qinglong Liu et al.

Summary: A series of Mn-Ti oxide catalysts were synthesized by the sol-gel method, and the effects of different synthesis conditions on the characteristics and SCR activity of the catalysts were investigated. The results showed that the calcination temperature and metal source significantly influenced the properties and activity of the catalysts, with relatively low calcination temperature and appropriate metal sources leading to high SCR activity.

CATALYSIS LETTERS (2021)

Article Engineering, Environmental

Adjustment of operation temperature window of Mn-Ce oxide catalyst for the selective catalytic reduction of NOx with NH3

Yang Geng et al.

Summary: The introduction of tungsten as a promoter enhanced the catalytic activity of Mn-Ce oxide catalyst for NH3-SCR, increasing the NOx conversion above 150 degrees C while decreasing N2O production. Doped tungsten inhibited charge imbalance and reducibility, leading to higher NOx conversion above 150 degrees C over Mn3CeW0.3Ox compared to Mn3CeOx. Kinetic study showed that nu(SCR) over Mn(3)CeW(0.3)O(x) was higher than over Mn3CeOx, consistent with the SCR activity.

JOURNAL OF HAZARDOUS MATERIALS (2021)

Article Chemistry, Physical

The influence of CNTs addition on Mn-Ce/TiO2 catalyst for low-temperature NH3-SCR of NO

Jae-Rang Youn et al.

Summary: By adding CNTs to Mn-Ce/TiO2 catalyst, the efficiency and N-2 selectivity of low-temperature selective catalytic reduction of NO with NH3 can be significantly improved. The addition of CNTs provides more NOx adsorption sites, making the reaction more efficient.

CATALYSIS COMMUNICATIONS (2021)

Article Materials Science, Ceramics

New Mn-TiO2 aerogel catalysts for the low-temperature selective catalytic reduction of NOx

Jihene Arfaoui et al.

Summary: A new series of Mn-based catalysts prepared by the sol-gel method show high efficiency in converting NO to N2 at low temperatures. The addition of cerium and/or sulfate can adjust the activity of the catalysts and increase the conversion rate.

JOURNAL OF SOL-GEL SCIENCE AND TECHNOLOGY (2021)

Review Energy & Fuels

Cerium Oxide-Based Catalysts for Low-Temperature Selective Catalytic Reduction of NOx with NH3: A Review

Jue Zhou et al.

Summary: This paper reviews the recent progress on Ce-based catalysts for low-temperature SCR de-NOx, including single CeOx, Ce-based multimetal oxide, and Ce-based multimetal oxides with support. For single CeOx, the reasons for significant catalytic activity and the function of CeOx in the reactions are systematically reviewed. In the study of multimetal oxide catalysts, the various roles played by the components of catalysts are summarized from multiple aspects.

ENERGY & FUELS (2021)

Article Green & Sustainable Science & Technology

Thulium modified MnOx/TiO2 catalyst for the low-temperature selective catalytic reduction of NO with ammonia

Cihang Niu et al.

Summary: A new Tm-modified Mn/TiO2 catalyst was developed for low temperature NO removal, showing significantly improved SCR de-NOx performance with NH3 as reducing agent. Introduction of appropriate Tm content enhanced the surface properties and reactivity of the catalyst, leading to enhanced de-NOx capabilities.

JOURNAL OF CLEANER PRODUCTION (2021)

Article Chemistry, Physical

Precursor Effect on Mn-Fe-Ce/TiO2 Catalysts for Selective Catalytic Reduction of NO with NH3 at Low Temperatures

Siva Sankar Reddy Putluru et al.

Summary: Preparation of Mn/TiO2, Mn-Fe/TiO2, and Mn-Fe-Ce/TiO2 by the deposition-precipitation (DP) method result in highly active catalysts for low-temperature NH3-SCR. The choice of precursors for Mn, Fe, and Ce affects the physiochemical properties and resulting SCR activity, with Cerium stabilizing amorphous manganese oxide phases.

CATALYSTS (2021)

Article Environmental Sciences

Selective catalytic reduction of NO by Fe-Mn nanocatalysts: effect of structure type

Vahid Zabihi et al.

Summary: The crystal structure type plays a significant role in the structural properties and catalytic performance of nanocatalysts, with the perovskite nanocatalyst showing the best performance in NH3-SCR reaction.

ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH (2021)

Article Chemistry, Physical

Mechanism of Ce-Modified Birnessite-MnO2 in Promoting SO2 Poisoning Resistance for Low-Temperature NH3-SCR

Xue Fang et al.

Summary: Ce modification of birnessite-MnO2 catalyst enhances SO2 resistance during NH3-SCR reactions through the formation of sulfates, which play different roles in the reaction mechanism, providing more acid sites for NH4+ adsorption and protecting Mn active centers from deactivation by preferentially adsorbing and oxidizing SO2 on Ce species.

ACS CATALYSIS (2021)

Article Chemistry, Physical

Insight into the Promoting Role of Er Modification on SO2 Resistance for NH3-SCR at Low Temperature over FeMn/TiO2 Catalysts

Huan Du et al.

Summary: The study demonstrated that Er modification could enhance the resistance to sulfur compounds and catalytic performance of FeMn/TiO2 catalysts, promoting NH3-SCR reaction by increasing Mn4+ concentration and surface chemisorbed oxygen ratio, consequently accelerating the catalytic reaction process.

CATALYSTS (2021)

Article Engineering, Environmental

Impact of toluene poisoning on MnCe/HZSM-5 SCR catalyst

Peng Lu et al.

Summary: The study examined the simultaneous removal of toluene in NH3-SCR reactions and found that MnCe/HZSM-5 catalyst with a SiO2/Al2O3 molar ratio of 25 exhibited superior catalytic performance. It was also discovered that toluene induced reversible catalyst deactivation in NH3-SCR reactions.

CHEMICAL ENGINEERING JOURNAL (2021)

Article Engineering, Chemical

CeMn/TiO2 catalysts prepared by different methods for enhanced low-temperature NH3-SCR catalytic performance

Xianlong Zhang et al.

Summary: Ce(1.0)Mn/TiO2 catalysts with the same Ce/Mn molar ratio were prepared by impregnation method and in situ deposition method. The catalyst prepared by in-situ deposition showed better catalytic performance and sulfur resistance compared to that prepared by impregnation. Various characterization methods were used to explore the differences between the two methods, with the catalyst prepared by in-situ deposition method exhibiting higher surface area, better thermal stability, higher concentration of acidic sites, and less agglomeration than the catalyst prepared by impregnation. The in-situ deposition method also enhanced electron mobility effect, thereby improving low-temperature DeNO(x) efficiency.

CHEMICAL ENGINEERING SCIENCE (2021)

Article Engineering, Environmental

N2O inhibition by toluene over Mn-Fe spinel SCR catalyst

Peng Lu et al.

Summary: This study investigated the impact of toluene on the N2O formation mechanism, revealing its inhibitory effect on N2O generation from both NH3 oxidation and NSCR pathways.

JOURNAL OF HAZARDOUS MATERIALS (2021)

Article Engineering, Environmental

Enhancement effects of Er modification on comprehensive performance of FeMn/TiO2 catalysts for selective reduction of NO with NH3 at low temperature

Huan Du et al.

Summary: Er modification significantly enhanced the performance of FeMn/TiO2 catalyst, improving specific surface area, dispersion, reducibility, and resistance to SO2 and H2O.

JOURNAL OF ENVIRONMENTAL CHEMICAL ENGINEERING (2021)

Article Engineering, Environmental

Titania-Samarium-Manganese Composite Oxide for the Low-Temperature Selective Catalytic Reduction of NO with NH3

Qan Xu et al.

ENVIRONMENTAL SCIENCE & TECHNOLOGY (2020)

Article Materials Science, Ceramics

Low-temperature selective catalytic reduction of NO with NH3over Mn-Ce-Ox/TiO2: a comparison between catalyst preparation methods

Mengxi Chao et al.

JOURNAL OF SOL-GEL SCIENCE AND TECHNOLOGY (2020)

Article Chemistry, Multidisciplinary

Aluminium-induced component engineering of mesoporous composite materials for low-temperature NH3-SCR

Ge Li et al.

COMMUNICATIONS CHEMISTRY (2020)

Article Chemistry, Multidisciplinary

Ce regulated surface properties of Mn/SAPO-34 for improved NH3-SCR at low temperature

Qizhi Chen et al.

RSC ADVANCES (2020)

Article Chemistry, Multidisciplinary

Catalytic Performances of Cu/MCM-22 Zeolites with Different Cu Loadings in NH3-SCR

Jialing Chen et al.

NANOMATERIALS (2020)

Article Engineering, Environmental

Effect of hierarchical element doping on the low-temperature activity of manganese-based catalysts for NH3-SCR

Xiaolong Tang et al.

JOURNAL OF ENVIRONMENTAL CHEMICAL ENGINEERING (2020)

Article Chemistry, Physical

Effect of oxygen vacancies on ceria catalyst for selective catalytic reduction of NO with NH3

Bolin Zhang et al.

APPLIED SURFACE SCIENCE (2020)

Article Engineering, Chemical

The enhanced performance of Ti doped MnOx for the removal of NO with NH3

Song Shu et al.

JOURNAL OF THE TAIWAN INSTITUTE OF CHEMICAL ENGINEERS (2019)

Article Materials Science, Multidisciplinary

Thermal stability of Si-doped V2O5/WO3-TiO2 for selective catalytic reduction of NOx by NH3

Xun-Zhe Shao et al.

RARE METALS (2019)

Article Engineering, Environmental

Polytetrafluoroethylene modifying: A low cost and easy way to improve the H2O resistance ability over MnOx for low-temperature NH3-SCR

Ningqiang Zhang et al.

JOURNAL OF ENVIRONMENTAL CHEMICAL ENGINEERING (2019)

Article Energy & Fuels

N2O and NO formation from NH3 oxidation over MnOx/TiO2 catalysts

Denghui Wang et al.

Article Chemistry, Physical

Ni-Ce-Ti as a superior catalyst for the selective catalytic reduction of NOx with NH3

Zhiming Liu et al.

MOLECULAR CATALYSIS (2018)

Article Chemistry, Physical

Mesoporous Mn-Ti amorphous oxides: a robust low-temperature NH3-SCR catalyst

Yanran Yang et al.

CATALYSIS SCIENCE & TECHNOLOGY (2018)

Article Chemistry, Physical

CeO2 supported on reduced TiO2 for selective catalytic reduction of NO by NH3

Yiqing Zeng et al.

JOURNAL OF COLLOID AND INTERFACE SCIENCE (2017)

Article Chemistry, Multidisciplinary

Mechanistic study of Ce-modified MnO x /TiO2 catalysts with high NH3-SCR performance and SO2 resistance at low temperatures

Fengxiang Li et al.

RESEARCH ON CHEMICAL INTERMEDIATES (2017)

Article Chemistry, Multidisciplinary

Improved low temperature NH3-SCR performance of FeMnTiOx mixed oxide with CTAB-assisted synthesis

Shiguo Wu et al.

CHEMICAL COMMUNICATIONS (2015)

Article Engineering, Environmental

Manganese-niobium mixed oxide catalyst for the selective catalytic reduction of NOx with NH3 at low temperatures

Zhihua Lian et al.

CHEMICAL ENGINEERING JOURNAL (2014)

Article Engineering, Chemical

Effect of the addition of Ce to MnOx/Ti catalyst on reduction of N2O in low-temperature SCR

Tong Shang et al.

ASIA-PACIFIC JOURNAL OF CHEMICAL ENGINEERING (2014)

Article Engineering, Environmental

Effect of the Mn oxidation state and lattice oxygen in Mn-based TiO2 catalysts on the low-temperature selective catalytic reduction of NO by NH3

Sang Moon Lee et al.

JOURNAL OF THE AIR & WASTE MANAGEMENT ASSOCIATION (2012)

Article Chemistry, Physical

Origination of N2O from NO reduction by NH3 over β-MnO2 and α-Mn2O3

Xingfu Tang et al.

APPLIED CATALYSIS B-ENVIRONMENTAL (2010)