相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Oxygen balance during laser powder bed fusion of Alloy 718
Camille Pauzon et al.
MATERIALS & DESIGN (2021)
Degradation of AlSi10Mg powder during laser based powder bed fusion processing
Ahmad Raza et al.
MATERIALS & DESIGN (2021)
Influence of gas atmosphere (Ar or He) on the laser powder bed fusion of a Ni-based alloy
S. Traore et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2021)
Numerical modeling and Schlieren visualization of the gas-assisted laser cutting under various operating stagnation pressures
Mohamed Darwish et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)
Transient dynamics of powder spattering in laser powder bed fusion additive manufacturing process revealed by in-situ high-speed high-energy x-ray imaging
Qilin Guo et al.
ACTA MATERIALIA (2018)
Fluid and particle dynamics in laser powder bed fusion
P. Bidare et al.
ACTA MATERIALIA (2018)
Laser powder bed fusion at sub-atmospheric pressures
P. Bidare et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2018)
The Effect of Oxygen on Phase Equilibria in the Ti-V System: Impacts on the AM Processing of Ti Alloys
Greta Lindwall et al.
JOM (2018)
Spatter and oxide formation in laser powder bed fusion of Inconel 718
A. N. D. Gasper et al.
ADDITIVE MANUFACTURING (2018)
TrackMate: An open and extensible platform for single-particle tracking
Jean-Yves Tinevez et al.
METHODS (2017)
Comparison of the microstructures and mechanical properties of Ti-6Al-4V fabricated by selective laser melting and electron beam melting
Xiaoli Zhao et al.
MATERIALS & DESIGN (2016)
Formation and control of martensite in Ti-6Al-4V alloy produced by selective laser melting
Jingjing Yang et al.
MATERIALS & DESIGN (2016)
Additive manufacturing of strong and ductile Ti-6Al-4V by selective laser melting via in situ martensite decomposition
W. Xu et al.
ACTA MATERIALIA (2015)
Effect of the build orientation on the mechanical properties and fracture modes of SLM Ti-6A1-4V
M. Simonelli et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Microstructure and tensile properties of selectively laser-melted and of HIPed laser-melted Ti-6Al-4V
Chunlei Qiu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Fatigue Life of Titanium Alloys Fabricated by Additive Layer Manufacturing Techniques for Dental Implants
Kwai S. Chan et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2013)
A study of the micro structural evolution during selective laser melting of Ti-6Al-4V
Lore Thijs et al.
ACTA MATERIALIA (2010)
Heat transfer and fluid flow during keyhole mode laser welding of tantalum, Ti-6Al-4V, 304L stainless steel and vanadium
R. Rai et al.
JOURNAL OF PHYSICS D-APPLIED PHYSICS (2007)
分享论文
