相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。Comparison of forced convective heat transfer between pillar and real foam structure under high Reynolds number
Mingrui Sun et al.
APPLIED THERMAL ENGINEERING (2021)
Numerical Survey on Performance of Hybrid NePCM for Cooling of Electronics: Effect of Heat Source Position and Heat Sink Inclination
Hamza Faraji et al.
JOURNAL OF THERMAL SCIENCE AND ENGINEERING APPLICATIONS (2021)
Analysis of thermal performance of an improved shell and helically coiled heat exchanger
Azim Dogus Tuncer et al.
APPLIED THERMAL ENGINEERING (2021)
Thermal performance assessment of a thermal energy storage tank: effect of aspect ratio and tilted angle
Xiaohu Yang et al.
INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2021)
Simulation of forced convective heat transfer in Kelvin cells with optimized skeletons
Mingrui Sun et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2021)
Influence of fin parameters on the melting behavior in a horizontal shell-and-tube latent heat storage unit with longitudinal fins
Hongyang Li et al.
JOURNAL OF ENERGY STORAGE (2021)
Simulations of melting performance enhancement for a PCM embedde d in metal periodic structures
Chunrong Zhao et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2021)
Phase change behaviour study of PCM tanks partially filled with graphite foam
Chunrong Zhao et al.
APPLIED THERMAL ENGINEERING (2021)
Different dimensional nanoadditives for thermal conductivity enhancement of phase change materials: Fundamentals and applications
Piao Cheng et al.
NANO ENERGY (2021)
Application of nanofluids for enhanced waste heat recovery: A review
A. G. Olabi et al.
NANO ENERGY (2021)
Effect of perforated fins on the heat-transfer performance of vertical shell-and-tube latent heat energy storage unit
Hongyang Li et al.
JOURNAL OF ENERGY STORAGE (2021)
Three-dimensional graphitic hierarchical porous carbon/stearic acid composite as shape-stabilized phase change material for thermal energy storage
Xialan Zhang et al.
APPLIED ENERGY (2020)
Performance improvements in solar flat plate collectors by integrating with phase change materials and fins: A CFD modeling
Z. Badiei et al.
ENERGY (2020)
Thermal performance of phase change material integrated heat pipe evacuated tube solar collector system: An experimental assessment
K. Chopra et al.
ENERGY CONVERSION AND MANAGEMENT (2020)
Pore-scale simulation of forced convection heat transfer under turbulent conditions in open-cell metal foam
Mingrui Sun et al.
CHEMICAL ENGINEERING JOURNAL (2020)
Influence of cascaded graphite foams on thermal performance of high temperature phase change material storage systems
Michael Opolot et al.
APPLIED THERMAL ENGINEERING (2020)
Pore-scale investigation on the heat-storage characteristics of phase change material in graded copper foam
Chengzhi Hu et al.
APPLIED THERMAL ENGINEERING (2020)
Experimental study of the effect of inclination angle on the paraffin melting process in a square cavity
Abdel Illah Nabil Korti et al.
JOURNAL OF ENERGY STORAGE (2020)
A comprehensive review on latent heat and thermal conductivity of nanoparticle dispersed phase change material for low-temperature applications
Eanest B. Jebasingh et al.
ENERGY STORAGE MATERIALS (2020)
Molten Salt/Metal Foam/Graphene Nanoparticle Phase Change Composites for Thermal Energy Storage
Xin Xiao et al.
ACS APPLIED NANO MATERIALS (2020)
Pore-scale numerical simulation of the thermal performance for phase change material embedded in metal foam with cubic periodic cell structure
Xusheng Hu et al.
APPLIED THERMAL ENGINEERING (2019)
Fast waste heat recovery in 100-150 °C using close-contact charging of nano-enhanced PCM composite
Vikram Soni et al.
JOURNAL OF MOLECULAR LIQUIDS (2019)
Melting process investigation of phase change materials in a shell and tube heat exchanger enhanced with heat pipe
A. Ebrahimi et al.
RENEWABLE ENERGY (2019)
Review of stability and thermal conductivity enhancements for salt hydrates
Navin Kumar et al.
JOURNAL OF ENERGY STORAGE (2019)
Investigation of the effect of inclination angle on the melting enhancement of phase change material in finned latent heat thermal storage units
Ramin Karami et al.
APPLIED THERMAL ENGINEERING (2019)
Experimental investigation of multiwall carbon nanotube/paraffin based heat sink for electronic device thermal management
Amin Farzanehnia et al.
ENERGY CONVERSION AND MANAGEMENT (2019)
Perspectives for short-term thermal energy storage using salt hydrates for building heating
B. C. Zhao et al.
ENERGY (2019)
Full Spectrum Solar Thermal Energy Harvesting and Storage by a Molecular and Phase-Change Hybrid Material
Varun Kashyap et al.
JOULE (2019)
Dynamic of plumes and scaling during the melting of a Phase Change Material heated from below
Santiago Madruga et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
Preparation of Lignosulfonate-Based Carbon Foams by Pyrolysis and Their Use in the Microencapsulation of a Phase Change Material
Martin A. Palazzolo et al.
ACS SUSTAINABLE CHEMISTRY & ENGINEERING (2018)
Enhanced latent heat thermal energy storage in the double tubes using fins
Wei-Biao Ye
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2017)
Pore Scale Investigation of Heat Conduction of High Porosity Open-Cell Metal Foam/Paraffin Composite
Yuanpeng Yao et al.
JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2017)
Experimental and numerical investigations on the thermal performance of building plane containing CaCl2•6H2O/expanded graphite composite phase change material
Rongda Ye et al.
APPLIED ENERGY (2017)
Numerical modeling of heat transfer in open-cell micro-foam with phase change material
Xin Hu et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2015)
Pore-scale and volume-averaged numerical simulations of melting phase change heat transfer in finned metal foam
Shangsheng Feng et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2015)
Thermal management of electronic devices using carbon foam and PCM/nano-composite
W. G. Alshaer et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2015)
Experimental analysis of phase change phenomenon of paraffin waxes embedded in copper foams
Simone Mancin et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2015)
The effect of pore size and porosity on thermal management performance of phase change material infiltrated microcellular metal foams
Sriharsha S. Sundarram et al.
APPLIED THERMAL ENGINEERING (2014)
Effective thermal conductivity of open-cell metal foams' impregnated with pure paraffin for latent heat storage
X. Xiao et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2014)
Experimental investigations on thermal performance enhancement and effect of orientation on porous matrix filled PCM based heat sink
Rajesh Baby et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2013)
A review of materials, heat transfer and phase change problem formulation for latent heat thermal energy storage systems (LHTESS)
Francis Agyenim et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2010)
Simulation of thermal transport in open-cell metal foams: Effect of periodic unit-cell structure
Shankar Krishnan et al.
JOURNAL OF HEAT TRANSFER-TRANSACTIONS OF THE ASME (2008)
Analysis of thermal conduction in carbon foams
AM Druma et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2004)