期刊
METALS
卷 11, 期 11, 页码 -出版社
MDPI
DOI: 10.3390/met11111822
关键词
severe plastic deformation (SPD); ultrafine grain structure; cryogenic temperature; dynamic restoration; grain boundary dislocation
资金
- EPSRC Future LiME Hub [EP/N007638/1]
- EPSRC [EP/N007638/1] Funding Source: UKRI
Research has shown that in an Al-0.1Mg single-phase aluminum alloy, after equal channel angular extrusion, the minimum grain size reached during plane strain compression at low temperatures cannot be further reduced, leading to the formation of a microstructure with thin ribbon grains. It has also been found that a high boundary migration rate is required to maintain a constant boundary spacing, which exceeds the rate justified by conventional diffusion-controlled grain growth.
The deformation structures formed in an Al-0.1Mg single-phase aluminium alloy have been studied during plane strain compression (PSC) down to liquid nitrogen temperature, following prior equal channel angular extrusion (ECAE) to a strain of ten. Under constant deformation conditions a steady state was approached irrespective of the temperature, where the rate of grain refinement stagnated and a minimum grain size was reached which could not be further reduced. A 98% reduction at 77 K (-196 & DEG;C) only transformed the ECAE processed submicron grain structure into a microstructure with thin ribbon grains, where a nanoscale high angle boundary (HAB) spacing was only approached in the sheet normal direction. It is shown that the minimum grain size achievable in severe deformation processing is controlled by a balance between the rate of compression of the HAB structure and dynamic recovery. The required boundary migration rate to maintain a constant boundary spacing is found far higher than can be justified from conventional diffusion-controlled grain growth and at low temperatures, a constant boundary spacing can only be maintained by invoking an athermal mechanism and is considered to be dominated by the operation of grain boundary dislocations.
作者
我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。
推荐
暂无数据