4.8 Article

Over 18% ternary polymer solar cells enabled by a terpolymer as the third component

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Physics, Condensed Matter

18.69% PCE from organic solar cells

Ke Jin et al.

JOURNAL OF SEMICONDUCTORS (2021)

Review Chemistry, Multidisciplinary

Fused-Ring Electron Acceptors for Photovoltaics and Beyond

Jiayu Wang et al.

Summary: The emerging solar cell technologies, such as organic solar cells (OSCs) and perovskite solar cells (PSCs), are attracting attention due to advantages like easy fabrication, low cost, flexibility, and short energy payback time. The development of fused-ring electron acceptors (FREAs) has led to significant improvements in power conversion efficiencies (PCEs) of OSCs, reaching up to 18%, and has initiated a shift from fullerene-based systems to nonfullerene systems within the field.

ACCOUNTS OF CHEMICAL RESEARCH (2021)

Article Multidisciplinary Sciences

Approaching 18% efficiency of ternary organic photovoltaics with wide bandgap polymer donor and well compatible Y6:Y6-1O as acceptor

Xiaoling Ma et al.

Summary: A series of ternary organic photovoltaics have been successfully fabricated by incorporating Y6-1O, which leads to an increase in open-circuit voltage and power conversion efficiency of the devices. By finely adjusting the content of Y6-1O, the optimal device with 30% Y6-1O achieves a conversion efficiency of 17.91%, with significantly improved short-circuit current density and fill factor.

NATIONAL SCIENCE REVIEW (2021)

Article Energy & Fuels

Ternary Organic Photovoltaic Cells Exhibiting 17.59% Efficiency with Two Compatible Y6 Derivations as Acceptor

Xuelin Wang et al.

Summary: Efficient organic photovoltaic cells were fabricated using two structurally similar Y6 derivations as acceptor and PM6 as donor. By optimizing the composition of acceptors, higher power conversion efficiency and photovoltaic performance can be achieved. The good compatibility between acceptors plays a key role in improving the fill factor and short-circuit current density of the photovoltaic cells.

SOLAR RRL (2021)

Review Materials Science, Multidisciplinary

Ternary organic solar cells based on non-fullerene acceptors: A review

Lichun Chang et al.

Summary: Organic solar cells have entered a second golden age with increased focus on non-fullerene acceptor materials and the ternary strategy, leading to improvements in efficiency and potential for further advancements in the field.

ORGANIC ELECTRONICS (2021)

Article Energy & Fuels

Efficient Ternary Polymer solar cells based ternary active layer consisting of conjugated polymers and non-fullerene acceptors with power conversion efficiency approaching near to 15.5%

Ganesh D. Sharma et al.

Summary: Ternary polymer solar cells with two polymers and one non-fullerene small molecule acceptor showed improved efficiency compared to binary active layers. Optimization of weight ratios between donors, solvent vapor annealing, and balanced charge transport contributed to increased power conversion efficiency.

SOLAR ENERGY (2021)

Article Chemistry, Physical

Achieving Efficient Ternary Organic Solar Cells Using Structurally Similar Non-Fullerene Acceptors with Varying Flanking Side Chains

Yuan Chang et al.

Summary: This study systematically investigated the steric and electronic effects of three structurally similar non-fullerene acceptors on the blend morphology and device performance. By incorporating non-fullerene acceptors with better molecular packing into the PTQ10 donor polymer, a novel ternary strategy was explored, resulting in enhanced photon response, improved charge transport, and suppressed charge recombination, ultimately achieving an outstanding power conversion efficiency of 17.6% with a fill factor of 78.8% in the ternary device.

ADVANCED ENERGY MATERIALS (2021)

Article Chemistry, Multidisciplinary

Multi-Selenophene-Containing Narrow Bandgap Polymer Acceptors for All-Polymer Solar Cells with over 15 % Efficiency and High Reproducibility

Qunping Fan et al.

Summary: The newly developed multi-selenophene-containing PSMA material PFY-3Se shows outstanding performance in all-polymer solar cells, with high efficiency, low energy loss, and good batch-to-batch reproducibility, indicating great potential for practical applications.

ANGEWANDTE CHEMIE-INTERNATIONAL EDITION (2021)

Article Engineering, Environmental

18.02% Efficiency ternary organic solar cells with a small-molecular donor third component

Xianjie Chen et al.

Summary: The ternary strategy using deep-lying HOMO energy level small molecule donor BPR-SCl in the PM6:BTP-eC9 host binary blend has successfully enhanced the power conversion efficiency of organic solar cells. The addition of BPR-SCl improved crystallinity of the photoactive layers and slightly reduced donor/acceptor phase separation scale, resulting in higher PCE, enhanced V-oc and J(sc) in the TOSCs. This study provides new insights into achieving high-performance TOSCs with the highest reported PCE using a small molecule donor as the third component.

CHEMICAL ENGINEERING JOURNAL (2021)

Article Chemistry, Multidisciplinary

18.4 % Organic Solar Cells Using a High Ionization Energy Self-Assembled Monolayer as Hole-Extraction Interlayer

Yuanbao Lin et al.

Summary: Self-assembled monolayers based on Br-2PACz, 2PACz, and MeO-2PACz were investigated as hole-extracting interlayers in organic photovoltaics. OPV cells using ITO/Br-2PACz anodes exhibited the highest power conversion efficiency due to the significantly higher work function of the ITO/Br-2PACz electrode, leading to improved hole transport and longer carrier lifetimes.

CHEMSUSCHEM (2021)

Article Chemistry, Physical

Using Two Compatible Donor Polymers Boosts the Efficiency of Ternary Organic Solar Cells to 17.7%

Wenhong Peng et al.

Summary: The use of ternary organic semiconducting blends is an effective strategy for enhancing the performance of polymer solar cells by increasing photocurrent and minimizing voltage losses. Challenges arise from the scarcity of suitable donors with deep HOMO levels, but a new donor polymer (PM7-Si) has been synthesized to address this issue, leading to significant improvements in efficiency, open-circuit voltage, and fill factor when incorporated into a binary system. These enhancements are attributed to improved carrier transport, stacking order, and morphology, highlighting the promise of using two polymer donors for high-performance ternary PSCs.

CHEMISTRY OF MATERIALS (2021)

Article Chemistry, Applied

Ternary polymer solar cells by employing two well-compatible donors with cascade energy levels

Zhiyong Liu et al.

Summary: In this study, a ternary polymer solar cell was fabricated using two well-compatible donors and one acceptor, achieving a higher power conversion efficiency. The use of two donors with similar HOMO energy levels and cascade LUMO energy levels is an efficient method to improve the performance of PSCs.

DYES AND PIGMENTS (2021)

Article Chemistry, Applied

Over 16.5% efficiency in ternary organic solar cells by adding an alloyed acceptor with energy transfer process

Zhenying Su et al.

Summary: Adding 5 wt% ITIC to the PM6:Y6 binary system successfully achieved a PCE of 16.6% for the PM6:Y6:ITIC ternary OSC, compared to 15.5% and 9.2% for the PM6:Y6 and PM6:ITIC binary OSCs. The enhanced photovoltaic performance of ternary OSCs resulted from extended absorption, enhanced fluorescence resonance energy transfer, balanced carrier transport, and reduced energy loss.

DYES AND PIGMENTS (2021)

Article Energy & Fuels

Ternary solar cells via ternary polymer donors and third component PC71BM to optimize morphology with 13.15% efficiency

Xingpeng Liu et al.

Summary: The study utilized a ternary polymer donor and organic small molecule acceptor, introducing a third component PC71BM to enhance the morphology of the photoactive layer and improve device performance. The introduction of PC71BM not only improved morphology and promoted more efficient exciton transport, but also influenced molecular arrangement for better crystallization performance.

SOLAR ENERGY (2021)

Article Chemistry, Physical

Reduced non-radiative charge recombination enables organic photovoltaic cell approaching 19% efficiency

Pengqing Bi et al.

Summary: Introducing HDO-4Cl increased the exciton diffusion length in the acceptor phase, reducing non-radiative charge recombination and improving photon utilization efficiency in PBDB-TF: eC9-based OPV cells. This led to achieving a high-efficiency OPV cell with outstanding power conversion efficiency, demonstrating the effectiveness of regulating exciton behaviors in reducing energy loss.
Article Chemistry, Multidisciplinary

Rational compatibility in a ternary matrix enables all-small-molecule organic solar cells with over 16% efficiency

Mengyun Jiang et al.

Summary: In this study, ternary small-molecule organic solar cells were fabricated by incorporating a small molecule acceptor Y7 as a morphology modulator into a B1:BO-4Cl matrix, enabling fine-tuning of molecular arrangement to facilitate charge extraction and achieving top-ranked power conversion efficiency.

ENERGY & ENVIRONMENTAL SCIENCE (2021)

Article Chemistry, Physical

Structural similarity induced improvement in the performance of organic solar cells based on novel terpolymer donors†

Yujun Cheng et al.

Summary: This study reports the construction of terpolymers by introducing Si and Cl functionalized benzodithiophene (BDT-SiCl) and F functionalized benzodithiophene (BDT-2F) through random copolymerization, with the structural similarity between the two units helping to minimize disturbance, improve charge transport, and broaden light absorption. The terpolymer-based OSCs achieve the best efficiency of 16.22% and have overall improved device parameters compared to PM6-based devices, demonstrating the promising strategy of structural similarity in constructing terpolymers for high-performance OSCs.

JOURNAL OF MATERIALS CHEMISTRY A (2021)

Article Chemistry, Multidisciplinary

High-Performance Pseudoplanar Heterojunction Ternary Organic Solar Cells with Nonfullerene Alloyed Acceptor

Ji Wan et al.

ADVANCED FUNCTIONAL MATERIALS (2020)

Article Nanoscience & Nanotechnology

Employing a Narrow-Band-Gap Mediator in Ternary Solar Cells for Enhanced Photovoltaic Performance

Liangang Xiao et al.

ACS APPLIED MATERIALS & INTERFACES (2020)

Article Chemistry, Physical

A Simple n-Dopant Derived from Diquat Boosts the Efficiency of Organic Solar Cells to 18.3%

Yuanbao Lin et al.

ACS ENERGY LETTERS (2020)

Article Chemistry, Multidisciplinary

Two compatible polymer donors contribute synergistically for ternary organic solar cells with 17.53% efficiency

Qiaoshi An et al.

ENERGY & ENVIRONMENTAL SCIENCE (2020)

Article Chemistry, Multidisciplinary

Over 17% efficiency ternary organic solar cells enabled by two non-fullerene acceptors working in an alloy-like model

Lingling Zhan et al.

ENERGY & ENVIRONMENTAL SCIENCE (2020)

Article Chemistry, Physical

Ternary Organic Solar Cells with Small Nonradiative Recombination Loss

Yuanpeng Xie et al.

ACS ENERGY LETTERS (2019)

Article Chemistry, Multidisciplinary

Ternary Polymer Solar Cells with High Efficiency of 14.24% by Integrating Two Well-Complementary Nonfullerene Acceptors

Huanxiang Jiang et al.

ADVANCED FUNCTIONAL MATERIALS (2019)

Review Chemistry, Multidisciplinary

Fluorinated Photovoltaic Materials for High-Performance Organic Solar Cells

Qunping Fan et al.

CHEMISTRY-AN ASIAN JOURNAL (2019)

Article Chemistry, Multidisciplinary

16.67% Rigid and 14.06% Flexible Organic Solar Cells Enabled by Ternary Heterojunction Strategy

Tingting Yan et al.

ADVANCED MATERIALS (2019)

Article Chemistry, Multidisciplinary

17% Efficient Organic Solar Cells Based on Liquid Exfoliated WS2 as a Replacement for PEDOT:PSS

Yuanbao Lin et al.

ADVANCED MATERIALS (2019)

Article Chemistry, Physical

Stable large area organic solar cells realized by using random terpolymers donors combined with a ternary blend

Xiaopeng Xu et al.

JOURNAL OF MATERIALS CHEMISTRY A (2019)

Article Chemistry, Physical

Design rules for minimizing voltage losses in high-efficiency organic solar cells

Deping Qian et al.

NATURE MATERIALS (2018)

Article Chemistry, Physical

Optical Gaps of Organic Solar Cells as a Reference for Comparing Voltage Losses

Yuming Wang et al.

ADVANCED ENERGY MATERIALS (2018)

Article Chemistry, Physical

Ternary Organic Solar Cells with Minimum Voltage Losses

Chuanfei Wang et al.

ADVANCED ENERGY MATERIALS (2017)

Review Chemistry, Multidisciplinary

Versatile ternary organic solar cells: a critical review

Qiaoshi An et al.

ENERGY & ENVIRONMENTAL SCIENCE (2016)

Review Multidisciplinary Sciences

Photovoltaic materials: Present efficiencies and future challenges

Albert Polman et al.

SCIENCE (2016)

Review Chemistry, Multidisciplinary

Bulk Heterojunction Solar Cells: Morphology and Performance Relationships

Ye Huang et al.

CHEMICAL REVIEWS (2014)