Wire Laser Metal Deposition Additive Manufacturing of Duplex Stainless Steel Components-Development of a Systematic Methodology

A systematic four-stage methodology was developed and applied to the Laser Metal Deposition with Wire (LMDw) of a duplex stainless steel (DSS) cylinder > 20 kg. In the four stages, single-bead passes, a single-bead wall, a block, and finally a cylinder were produced. This stepwise approach allowed the development of LMDw process parameters and control systems while the volume of deposited material and the geometrical complexity of components increased. The as-deposited microstructure was inhomogeneous and repetitive, consisting of highly ferritic regions with nitrides and regions with high fractions of austenite. However, there were no cracks or lack of fusion defects; there were only some small pores, and strength and toughness were comparable to those of the corresponding steel grade. A heat treatment for 1 h at 1100 degrees C was performed to homogenize the microstructure, remove nitrides, and balance the ferrite and austenite fractions compensating for nitrogen loss occurring during LMDw. The heat treatment increased toughness and ductility and decreased strength, but these still matched steel properties. It was concluded that implementing a systematic methodology with a stepwise increase in the deposited volume and geometrical complexity is a cost-effective way of developing additive manufacturing procedures for the production of significantly sized metallic components.

Automated summary

By implementing a systematic four-stage methodology, the Laser Metal Deposition with Wire (LMDw) process for a duplex stainless steel cylinder was developed effectively. The stepwise approach allowed for the optimization of process parameters and control systems while increasing the complexity of components. Heat treatment was used to enhance the microstructure, improve toughness and ductility of the metallic components, maintaining their mechanical properties.