相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。Modelling damage evolution in composite laminates subjected to low velocity impact
Y. Shi et al.
COMPOSITE STRUCTURES (2012)
Modeling of machining of composite materials: A review
Chinmaya R. Dandekar et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2012)
Delamination prediction in orthogonal machining of carbon long fiber-reinforced polymer composites
C. Santiuste et al.
JOURNAL OF REINFORCED PLASTICS AND COMPOSITES (2012)
Influence of tool geometry and numerical parameters when modeling orthogonal cutting of LFRP composites
X. Soldani et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2011)
Macro and micro process modeling of the cutting of carbon fiber reinforced plastics using FEM
R. Rentsch et al.
11TH INTERNATIONAL CONFERENCE ON THE MECHANICAL BEHAVIOR OF MATERIALS (ICM11) (2011)
Machining FEM model of long fiber composites for aeronautical components
Carlos Santiuste et al.
COMPOSITE STRUCTURES (2010)
Modelling of chip separation in machining unidirectional FRP composites by stiffness degradation concept
L. Lasri et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2009)
Finite element analysis when machining UGF-reinforced PMCs plates: Chip formation, crack propagation and induced-damage
Ali Mkaddem et al.
MATERIALS & DESIGN (2009)
A micro-macro combined approach using FEM for modelling of machining of FRP composites: Cutting forces analysis
Ali Mkaddem et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2008)
Modeling of three-dimensional cutting forces in micro-end-milling
Chengfeng Li et al.
JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2007)
Progressive damage modeling in fiber-reinforced materials
Ireneusz Lapczyk et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2007)
Machining studies of UD-FRP composites part 2: Finite element analysis
D Nayak et al.
MACHINING SCIENCE AND TECHNOLOGY (2005)
Coefficient of friction and wear of a carbon fiber epoxy matrix composite
J Schön
WEAR (2004)
An experimental investigation into the orthogonal cutting of unidirectional fibre reinforced plastics
XM Wang et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2003)
Finite element modeling of edge trimming fiber reinforced plastics
D Arola et al.
JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME (2002)
Process simulation using finite element method -: prediction of cutting forces, tool stresses and temperatures in high-speed flat end milling
T Özel et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2000)