☆ 4.3 Article

Radiation Damage Behaviour of a Zirconium Alloy Used in Nuclear Industry

TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Materials Science, Multidisciplinary

The dependence of damage accumulation on irradiation dose rate in zirconium alloys: Rate theory, atomistic simulation and experimental validation

Peyman Saidi et al.

Summary: This study presents an approach to determine the sensitivity of irradiation damage accumulation to the irradiation dose rate, and validates the model through experiments. The results show that the impact of the irradiation rate on damage accumulation varies in different scenarios, depending on the ratio of internal sink strength to the grain boundary sink strength.

JOURNAL OF NUCLEAR MATERIALS (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Evolution of dislocation microstructure in irradiated Zr alloys determined by X-ray peak profile analysis

Istvan Groma et al.

Summary: This article discusses the effects of neutron irradiation on metals, including the significant climb motion of dislocations and the formation of prismatic dislocation loops. It also highlights the use of X-ray peak profile analysis to determine the microstructural parameters of irradiated Zr alloys.

JOURNAL OF APPLIED CRYSTALLOGRAPHY (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Emulation of neutron damage with proton irradiation and its effects on microstructure and microchemistry of Zircaloy-4

Peng Wang et al.

Summary: This study evaluated the potential of proton irradiation to simulate neutron damage in Zircaloy-4, finding that the microstructures and irradiation-induced hardening after proton irradiation were similar to neutron irradiation. The significant amorphization of precipitates and iron redistribution observed in neutron irradiated materials can be effectively emulated using a two-step proton irradiation on Zircaloy-4.

JOURNAL OF NUCLEAR MATERIALS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

An Atomistic Modelling Study of the Properties of Dislocation Loops in Zirconium

R. Hulse et al.

Summary: Neutron irradiation causes changes in the properties of zirconium alloys, including hardening and reduction in lattice parameter ratio with fluence. Atomistic simulations on dislocation loops in Zr reveal insights into their formation and evolution, suggesting that interstitial and vacancy loops are both energetically feasible. These findings provide important information on a phenomenon that is difficult to study experimentally.

JOURNAL OF NUCLEAR MATERIALS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Size-distribution of irradiation-induced dislocation-loops in materials used in the nuclear industry

Tamas Ungar et al.

Summary: This study compares the results of determining irradiation-induced dislocation loop densities using XLPA and TEM analysis, showing discrepancies in some cases. A new methodology for determining the size distribution of irradiation-induced dislocation loops is proposed. The correlation between reciprocal square-root of < a >-loop DDs and the diameter of < a >-loops is also demonstrated. Combining TEM investigations with XLPA provides a better understanding of irradiation-induced loop formation and damage.

JOURNAL OF NUCLEAR MATERIALS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Radiation damage buildup and basal vacancy cluster formation in hcp zirconium: A molecular dynamics study

Jiting Tian et al.

Summary: Investigations on irradiation-induced damage buildup in alpha zirconium using MD simulations reveal that damage accumulates quickly at low dose and stabilizes after reaching around 0.1 dpa; high temperature can significantly reduce steady damage, while recoil energy has a minor effect on defect accumulation. Cascade overlap in hcp Zr naturally creates basal vacancy clusters, which are rarely observed in single cascade simulations.

JOURNAL OF NUCLEAR MATERIALS (2021)

添加到收藏夹

Article Chemistry, Multidisciplinary

Characterizing dislocation loops in irradiated polycrystalline Zr alloys by X-ray line profile analysis of powder diffraction patterns with satellites

Tamas Ungar et al.

Summary: This work extends the CMWP line profile analysis procedure to determine the total dislocation density and character of irradiation-induced dislocation loops in commercial polycrystalline Zr specimens. The procedure is based on the Krivoglaz-Wilkens theory and effectively solves challenges in determining the M values and fitting satellites in powder diffraction patterns of irradiated Zr alloys.

JOURNAL OF APPLIED CRYSTALLOGRAPHY (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Transmission electron microscopy characterization of dislocation loops in irradiated zirconium

Si-Mian Liu et al.

Summary: Characterization of irradiation defects in Zr alloys is crucial for mitigating irradiation damage, reducing irradiation growth, and tuning mechanical properties. A practical method using conventional TEM to characterize dislocation loops in irradiated Zr was described, including determining the nature, habit plane, size, and number of loops. As irradiation damage increases, the number density of TVPs significantly increases due to anisotropic diffusion and accumulation of point defects within the basal plane.

TUNGSTEN (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

The effect of irradiation temperature on damage structures in proton-irradiated zirconium alloys

M. Topping et al.

JOURNAL OF NUCLEAR MATERIALS (2019)

添加到收藏夹

Article Materials Science, Multidisciplinary

Investigating the thermal stability of irradiation-induced damage in a zirconium alloy with novel in situ techniques

M. Topping et al.

ACTA MATERIALIA (2018)

添加到收藏夹

Article Chemistry, Multidisciplinary

Irradiation Induced Defect Clustering in Zircaloy-2

Zhongwen Yao et al.

APPLIED SCIENCES-BASEL (2017)

添加到收藏夹

Article Materials Science, Multidisciplinary

Evolution of dislocation structure in neutron irradiated Zircaloy-2 studied by synchrotron x-ray diffraction peak profile analysis

T. Seymour et al.

ACTA MATERIALIA (2017)

添加到收藏夹

Article Chemistry, Multidisciplinary

Contrast factors of irradiation-induced dislocation loops in hexagonal materials

Levente Balogh et al.

JOURNAL OF APPLIED CRYSTALLOGRAPHY (2016)

添加到收藏夹

Review Materials Science, Multidisciplinary

Challenges to the use of ion irradiation for emulating reactor irradiation

Gary S. Was

JOURNAL OF MATERIALS RESEARCH (2015)

添加到收藏夹

Article Materials Science, Multidisciplinary

Microstructure-mechanical property correlation of cryo rolled Zircaloy-4

Apu Sarkar et al.

JOURNAL OF NUCLEAR MATERIALS (2015)

添加到收藏夹

Article Nanoscience & Nanotechnology

Dislocation density-based modelling of plastic deformation of Zircaloy-4

J. W. Dunlop et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)

添加到收藏夹

Article Materials Science, Multidisciplinary

Deformation characteristics of rolled zirconium alloys: a study by X-ray diffraction line profile analysis

P Mukherjee et al.

ACTA MATERIALIA (2004)

添加到收藏夹

Article Nanoscience & Nanotechnology

Micro structural parameters from X-ray diffraction peak broadening

T Ungár

SCRIPTA MATERIALIA (2004)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.