Fabrication of 3D hierarchical Fe2O3/SnO2 photoanode for enhanced photoelectrochemical performance

Exploring and fabricating a suitable photoanode with high catalytic activity is critical for enhancing photoelectrochemical (PEC) performance. Herein, a novel 3D hierarchical Fe2O3/SnO2 photoanode was fabricated by a hydrothermal route, combining with an annealing process. The morphology, crystal structure were studied by scanning electron microscopy, transmission electron microscopy, x-ray photon spectroscopy, and x-ray diffraction, respectively. The results reveal the successful preparation of Fe2O3 nanothorns on the surface of SnO2 nanosheets. The as-fabricated 3D Fe2O3/SnO2 photoanode yields obviously promoted PEC performance with a photocurrent density of approximate 5.85 mA cm(-2), measured in a mixture of Na2S (0.25 M) and Na2SO3 (0.35 M) aqueous solution at 1.23 V (versus reversible hydrogen electrode, RHE). This value of photocurrent is about 53 times higher than that of the bare SnO2 photoanode. The obvious improved PEC properties can be attributed to the 3D Fe2O3/SnO2 heterostructures that offer outstanding light harvesting ability as well as improved charge transport and separation. These results suggest that exploring a suitable 3D hierarchical photoanode is an effective approach to boost PEC performance.

Automated summary

A novel 3D hierarchical Fe2O3/SnO2 photoanode with improved photoelectrochemical performance was fabricated by a hydrothermal route and annealing process. The 3D Fe2O3/SnO2 heterostructures exhibited outstanding light harvesting ability, improved charge transport and separation, resulting in a significantly higher photocurrent density compared to the bare SnO2 photoanode.