4.6 Article

Facile Surface Coatings for Performance Improvement of NMC811 Battery Cathode Material

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Chemistry, Physical

An integrated surface coating strategy to enhance the electrochemical performance of nickel-rich layered cathodes

Xingyu Qu et al.

Summary: An integrated surface coating/doping strategy has been developed to improve the structural stability and electrochemical performance of high-nickel layered oxides, leading to enhanced cycling stability and capacity retention of batteries. The strategy involves diffusion of titanium ions from a thin coating layer, formation of a protective layer on the material surface, and Ti4+ doping to enhance lithium ion diffusion and reduce side reactions, ultimately benefiting the cycling stability of the cathode.

NANO ENERGY (2022)

Article Nanoscience & Nanotechnology

Operando Analysis of Gas Evolution in TiNb2O7 (TNO)-Based Anodes for Advanced High-Energy Lithium-Ion Batteries under Fast Charging

Dhrupad Parikh et al.

Summary: TNO is a promising anode material for next-generation lithium-ion batteries due to its high rate capabilities, theoretical capacity, and lithiation voltage, allowing for cycling under extreme fast charging conditions with minimal risk of lithium plating. Gas evolution analysis with TNO-based cells showed the presence of CO2, C2H4, and O-2, with the potential for significantly reduced gas generation and improved capacity under XFC conditions through the application of a protective coating.

ACS APPLIED MATERIALS & INTERFACES (2021)

Article Chemistry, Multidisciplinary

Insight into the Solid Electrolyte Interphase Formation in Bis(fluorosulfonyl)Imide Based Ionic Liquid Electrolytes

Charl J. Jafta et al.

Summary: The formation of the solid electrolyte interphase (SEI) in an ionic liquid electrolyte of 0.5 M lithium bis(fluorosulfonyl)imide (LiFSI) in 1-ethyl-3-methylimidazolium bis(fluorosulfonyl)imide at high cell voltages (1.7-1.9 V) was investigated in ordered mesoporous carbon (OMC) based Li metal cells using an operando small-angle neutron scattering (SANS) technique coupled with electrochemical impedance spectroscopy and ex situ X-ray photoelectron spectroscopy (XPS). It was demonstrated that discharging the OMC Li metal cells to approximately 2 V and holding the cell voltage constant induces a rapid current increase with time, confirming extensive reduction and SEI formation. XPS analysis revealed that LiF is formed at open cell voltage (OCV), attributed to the carbenes generated at the lithium negative electrode reacting with EMIm cation diffusing to and initiating the reaction with FSI- anions at the carbon positive electrode. It was confirmed that the chemical reaction at OCV and electrochemical reduction at high cell voltage of the FSI- anion plays a protective role against EMIm cation co-intercalation into the carbon positive electrode during the initial discharge. Operando SANS studies also suggest that slight differences occur in the surface composition and reaction mechanism as a function of cell voltage.

ADVANCED FUNCTIONAL MATERIALS (2021)

Article Chemistry, Physical

The surface triple-coupling on single crystalline cathode for lithium ion batteries

Qingqing Zhang et al.

Summary: The utilization of concentration-gradient Na+, F- co-doping and surface NaF coating on SC LiNi0.5Co0.2Mn0.3O2 cathode has successfully regulated the external structure of materials, leading to outstanding electrochemical performances. Multiple characterizations revealed the detailed interface transformation mechanism and suggested that the superior results are mainly attributed to the overall structure integrity of SC material and the thin cathode electrolyte interface. This work provides a new approach to construct a benign interface for high-performance lithium ion batteries.

NANO ENERGY (2021)

Article Chemistry, Physical

Core-shell Ni-rich NMC-Nanocarbon cathode from scalable solvent-free mechanofusion for high-performance 18650 Li-ion batteries

Nutthaphon Phattharasupakun et al.

Summary: A surface coating approach using carbon nanosphere shell was introduced to improve the drawbacks of Ni-rich LiNi0.8Mn0.1Co0.1O2 (NMC811) cathode, showing higher Li utilization and better stability. The in operando XRD analysis revealed the smooth phase transition of NMC811cs, while the online Differential Electrochemical Mass Spectrometry demonstrated extended onset potential of CO2 and H-2 evolution. Overall, the NMC811cs prototype battery exhibited higher specific capacity, energy, and cycling stability compared to pristine NMC811.

ENERGY STORAGE MATERIALS (2021)

Article Nanoscience & Nanotechnology

Role of Residual Li and Oxygen Vacancies in Ni-rich Cathode Materials

Lingjun Li et al.

Summary: By adjusting the oxygen flow during high-temperature sintering, the content of residual Li and oxygen vacancies in Ni-rich cathode materials can be controlled, which in turn influences the electrochemical performance of the batteries.

ACS APPLIED MATERIALS & INTERFACES (2021)

Article Chemistry, Physical

Conditioning the Surface and Bulk of High-Nickel Cathodes with a Nb Coating: An In Situ X-ray Study

Fengxia Xin et al.

Summary: Surface coating with niobium has been shown to stabilize high-nickel transition metal layered cathodes in lithium-ion batteries, with the electrochemical performance of the final products depending on postprocessing. In this study, in situ synchrotron X-ray diffraction was used to investigate the kinetic processes and structural evolution in Nb-coated cathodes upon heat treatment. The findings highlight new opportunities for controlling the structure and surface properties of high-nickel cathodes through surface coating combined with postprocessing.

JOURNAL OF PHYSICAL CHEMISTRY LETTERS (2021)

Article Electrochemistry

Effect of Amorphous LiPON Coating on Electrochemical Performance of LiNi0.8Mn0.1Co0.1O2 (NMC811) in All Solid-State Batteries

Sushovan Shrestha et al.

Summary: High nickel layered oxide LiNi0.8Mn0.1Co0.1O2 (NMC811) coated with a nanometer layer of lithium ion conducting solid electrolyte LiPON using RF-magnetron sputtering shows improved cycling performance and rate capability in all solid-state batteries. Thicker LiPON coatings negatively impact performance due to increased electronic resistance, while the LiPON layer provides interfacial stability and enhances Li+ transport.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2021)

Article Electrochemistry

A Systematic Study of Electrolyte Additives in Single Crystal and Bimodal LiNi0.8Mn0.1 Co0.1O2/Graphite Pouch Cells

Wentao Song et al.

Summary: A systematic study was conducted on the impact of electrolyte additives on the performance and lifetime of lithium-ion batteries, providing a reference for the development of NMC811/graphite cells and valuable insights for future electrolyte additive research.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2021)

Article Multidisciplinary Sciences

Comprehensive Study of Li+/Ni2+ Disorder in Ni-Rich NMCs Cathodes for Li-Ion Batteries

Elena D. Orlova et al.

Summary: The study investigated the disordering of Li+ and Ni2+ in LiNi(x)Mn yCo(z)O(2) materials, finding that the I-003/I-104 integral intensity ratio can serve as a quantitative measure, while the c/(2 root 6a) ratio is not reliable for quantitative estimates.

SYMMETRY-BASEL (2021)

Article Chemistry, Physical

Improving the Structure Stability of LiNi0.8Co0.15Al0.05O2 by Double Modification of Tantalum Surface Coating and Doping

Xiaoyun Zhang et al.

Summary: The study applied a one-step high-temperature solid-phase sintering method to form a Ta2O5 protective layer on the surface of high-nickel materials, significantly enhancing the structural stability and improving the cycling performance of NCA at high rates.

ACS APPLIED ENERGY MATERIALS (2021)

Article Nanoscience & Nanotechnology

Synthesis and Mechanism of High Structural Stability of Nickel-Rich Cathode Materials by Adjusting Li-Excess

Zhenlu Yu et al.

ACS APPLIED MATERIALS & INTERFACES (2020)

Article Chemistry, Multidisciplinary

Simultaneously Dual Modification of Ni-Rich Layered Oxide Cathode for High-Energy Lithium-Ion Batteries

Huiping Yang et al.

ADVANCED FUNCTIONAL MATERIALS (2019)

Article Chemistry, Multidisciplinary

Pushing the limit of layered transition metal oxide cathodes for high-energy density rechargeable Li ion batteries

U. -H. Kim et al.

ENERGY & ENVIRONMENTAL SCIENCE (2018)

Article Chemistry, Physical

Hydrolysis of LiPF6 in Carbonate-Based Electrolytes for Lithium-Ion Batteries and in Aqueous Media

Michael Stich et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2018)

Article Materials Science, Ceramics

Environment-friendly synthesis of high-voltage LiNi0.5Mn1.5O4 nanorods with excellent electrochemical properties

Hongyuan Zhao et al.

CERAMICS INTERNATIONAL (2018)

Article Electrochemistry

Oxygen Release and Its Effect on the Cycling Stability of LiNixMnyCozO2 (NMC) Cathode Materials for Li-Ion Batteries

Roland Jung et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2017)

Article Nanoscience & Nanotechnology

From Coating to Dopant: How the Transition Metal Composition Affects Alumina Coatings on Ni-Rich Cathodes

Binghong Han et al.

ACS APPLIED MATERIALS & INTERFACES (2017)

Article Electrochemistry

Study of the Failure Mechanisms of LiNi0.8Mn0.1Co0.1O2 Cathode Material for Lithium Ion Batteries

Jing Li et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2015)

Article Electrochemistry

Effect of Residual Lithium Compounds on Layer Ni-Rich Li[Ni0.7Mn0.3]O2

Dae-Hyun Cho et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2014)

Article Chemistry, Multidisciplinary

Improved Performances of Nanosilicon Electrodes Using the Salt LiFSI: A Photoelectron Spectroscopy Study

Bertrand Philippe et al.

JOURNAL OF THE AMERICAN CHEMICAL SOCIETY (2013)

Review Chemistry, Physical

Advanced Electrodes for High Power Li-ion Batteries

Karim Zaghib et al.

MATERIALS (2013)

Review Chemistry, Physical

Challenges for Rechargeable Li Batteries

John B. Goodenough et al.

CHEMISTRY OF MATERIALS (2010)

Article Chemistry, Physical

Thermal Behavior of Ionic Liquids Containing the FSI Anion and the Li+ Cation

Junhua Huang et al.

JOURNAL OF PHYSICAL CHEMISTRY C (2010)

Article Chemistry, Physical

Minimization of the cation mixing in Li1-x(NMC)1-xO2 as cathode material

Xiaoyu Zhang et al.

JOURNAL OF POWER SOURCES (2010)

Article Electrochemistry

Doped sulfone electrolytes for high voltage Li-ion cell applications

Xiaoguang Sun et al.

ELECTROCHEMISTRY COMMUNICATIONS (2009)

Article Chemistry, Physical

The LixNi1-yMgyO2 (y=0.05, 0.10) system:: structural modifications observed upon cycling

C Pouillerie et al.

SOLID STATE IONICS (2000)