Effect of construction angles on microstructure and mechanical properties of AlSi10Mg alloy fabricated by selective laser melting

In this study, seven AlSi10Mg bulks with different construction angles (0 degrees, 15 degrees, 30 degrees, 45 degrees, 60 degrees, 75 degrees, and 90 degrees) were fabricated by selective laser melting (SLM). The effects of different construction angles on the microstructure and mechanical properties of AlSi10Mg alloys were investigated. Increasing the construction angle changed the laser track segments from an ellipse to a semi-ellipse and then to fish-scale, specifically again from a semi-ellipse to an ellipse, due to the decrease of the laser radiation area. Meanwhile, the grains in the vertical planes changed from columnar grains to irregularly arranged grains, and then to equiaxed grains. The 45 degrees sample exhibited the highest hardness of 154.44 HV0.1. The 60 degrees sample had a good combination of strength and plasticity with a tensile strength of 463.54 MPa, yield strength of 283.37 MPa, and elongation of 9.25%. The observed mechanical property anisotropy of the current AlSi10Mg alloy was a result of the pores, equiaxed grain structure, ultra-fine equiaxed sub-grains, and working hardening. In addition, the difference in the sample microstructures was attributed to the construction angles and deposited layer area. (C) 2021 Elsevier B.V. All rights reserved.

Automated summary

This study investigated the effects of different construction angles on the microstructure and mechanical properties of AlSi10Mg alloys by fabricating seven bulks with different angles using selective laser melting. The results showed that increasing the construction angle changed the laser track segments and affected the grain structure in the vertical planes. The mechanical property anisotropy of the alloy was attributed to various factors such as pores, equiaxed grain structure, ultra-fine equiaxed sub-grains, and working hardening.