☆ 4.7 Article

Topology optimization of the catalyst distribution of planar methane steam reformers

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2022)

相关参考文献

注意：仅列出部分参考文献，下载原文获取全部文献信息。

Article Chemistry, Physical

A multiobjective optimization of a catalyst distribution in a methane/steam reforming reactor using a genetic algorithm

Marcin Pajak et al.

Summary: The research focused on optimizing the distribution of catalyst inside a small-scale methane/steam reforming reactor using a genetic algorithm for multiobjective optimization. The study found that the optimized catalyst distribution resulted in the best performance under the working conditions of the system.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

添加到收藏夹

Article Energy & Fuels

Topology optimization of microstructure of solid-oxide fuel cell anode to minimize thermal mismatch

Qiangqiang Li et al.

Summary: The thermomechanical reliability and lifetime of solid-oxide fuel cells are significantly affected by thermal mismatch between anode and electrolyte layers. This study presents a numerical analysis of topology optimization of the microstructure of Ni-8YSZ anode to minimize the thermal mismatch. The optimized microstructures show high three-phase boundary density and increased Ni-pore interfacial areas, providing potential for enhancing ion conductivities and aiding in the design of future electrodes.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2021)

添加到收藏夹

Article Engineering, Chemical

Fine three-dimensional simulation of the heterogeneous anode of a solid oxide fuel cell with direct internal reforming

Qiangqiang Li et al.

Summary: The study developed a heterogeneous model for a DIRSOFC anode based on a microstructure reconstructed using X-ray. It found that total overpotential has an insignificant effect on CH4 conversion rate, but operating temperature has a significant impact on both CH4 conversion rate and the electrical performance of the cell. Additionally, a higher prereforming extent of methane is beneficial for increasing electrical performance.

CHEMICAL ENGINEERING SCIENCE (2021)

添加到收藏夹

Article Chemistry, Physical

Modeling and analysis of microchannel autothermal methane steam reformer focusing on thermal characteristic and thermo-mechanically induced stress behavior

Zheng Li et al.

Summary: The application of fuel cells increases the demand for hydrogen, while the microchannel autothermal methane steam reactor operates at high temperature, potentially reducing its stability and lifespan. Research shows that reactors made of different materials exhibit different distributions of hot and cold spot temperatures.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

添加到收藏夹

Article Chemistry, Physical

Modeling of the solid oxide fuel cell anode based on a new analytical model using nonlinear Butler-Volmer expression

Qiangqiang Li et al.

Summary: In this study, a new analytical model of solid oxide fuel cell anode is derived based on the nonlinear BV equation, the error of the analytical solution is analyzed in detail. The results show that the analytical solution can achieve relatively good agreement with the numerical solution, but may cause significant errors when concentration overpotential cannot be neglected. The use of the nonlinear BV equation is important for obtaining more accurate prediction results.

IONICS (2021)

添加到收藏夹

Article Materials Science, Multidisciplinary

Topology optimization of the microstructure of solid oxide fuel cell cathodes

Qiangqiang Li et al.

ACTA MATERIALIA (2020)

添加到收藏夹

Article Multidisciplinary Sciences

Electrified methane reforming: A compact approach to greener industrial hydrogen production

Sebastian T. Wismann et al.

SCIENCE (2019)

添加到收藏夹

Article Chemistry, Physical

Impact of Ni-based catalyst patterning on hydrogen production from MSR: External steam reformer modelling

Abdelhakim Settar et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

添加到收藏夹

Article Engineering, Chemical

Electrified Methane Reforming: Understanding the Dynamic Interplay

Sebastian T. Wismann et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2019)

添加到收藏夹

Article Thermodynamics

A numerical analysis of heat and mass transfer during the steam reforming process of ethane

Marcin Tomiczek et al.

HEAT AND MASS TRANSFER (2018)

添加到收藏夹

Article Chemistry, Physical

Methane steam reforming using a membrane reactor equipped with a Pd-based composite membrane for effective hydrogen production

Chang-Hyun Kim et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2018)

添加到收藏夹

Article Thermodynamics

Numerical analysis of catalytic-coated walls of an indirect internal reforming solid oxide fuel cell: Influence of catalyst coating distribution on the reformer efficiency

Abdelhakim Settar et al.

ENERGY CONVERSION AND MANAGEMENT (2018)

添加到收藏夹

Article Engineering, Chemical

Microkinetic Analysis of the Methane Steam Reforming on a Ru-Supported Catalytic Wall Reactor

Jose Mauro Vasquez Castillo et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2017)

添加到收藏夹

Article Chemistry, Physical

Catalytic properties of a pure Ni coil catalyst for methane steam reforming

Toshiyuki Hirano et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

添加到收藏夹

Article Thermodynamics

Towards a Thermal Optimization of a Methane/Steam Reforming Reactor

M. Mozdzierz et al.

FLOW TURBULENCE AND COMBUSTION (2016)

添加到收藏夹

Article Chemistry, Physical

Two-dimensional micro/macroscale model for intermediate-temperature solid oxide fuel cells considering the direct internal reforming of methane

Sangho Sohn et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2016)

添加到收藏夹

Article Chemistry, Physical

Catalytic evaluation of nickel nanoparticles in methane steam reforming

Sardar Ali et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2016)

添加到收藏夹

Article Chemistry, Physical

Catalytic properties of pure Ni honeycomb catalysts for methane steam reforming

Yusuke Hiramitsu et al.

APPLIED CATALYSIS A-GENERAL (2015)

添加到收藏夹

Article Chemistry, Physical

A systematic parametric study on the effect of a catalyst coating microstructure on its performance in methane steam reforming

Alireza T. Naseri et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2015)

添加到收藏夹

Article Chemistry, Physical

The limiting process in steam methane reforming with gas diffusion into a porous catalytic wall in a flow reactor

Motohiro Saito et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2015)

添加到收藏夹

Article Chemistry, Physical

Experimental study of methane dry reforming in an electrically heated reactor

Martin Rieks et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2015)

添加到收藏夹

Article Chemistry, Physical

Operational characteristics of a planar steam reformer thermally coupled with a catalytic burner

Kanghun Lee et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2013)

添加到收藏夹

Article Chemistry, Physical

Steam reforming of methane over Ni catalyst in micro-channel reactor

Xuli Zhai et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2011)

添加到收藏夹

Article Chemistry, Physical

Random-packing model for solid oxide fuel cell electrodes with particle size distributions

Yanxiang Zhang et al.

JOURNAL OF POWER SOURCES (2011)

添加到收藏夹

Article Chemistry, Applied

Steam Reforming of Methane Over Nickel: Development of a Multi-Step Surface Reaction Mechanism

L. Maier et al.

TOPICS IN CATALYSIS (2011)

添加到收藏夹

Article Engineering, Chemical

Methane steam reforming in large pore catalyst

Eduardo L. G. Oliveira et al.

CHEMICAL ENGINEERING SCIENCE (2010)

添加到收藏夹

Article Thermodynamics

Analysis of parameter effects on chemical reaction coupled transport phenomena in SOFC anodes

Jinliang Yuan et al.

HEAT AND MASS TRANSFER (2009)

添加到收藏夹

Article Chemistry, Physical

Investigation of a novel porous anodic alumina plate for methane steam reforming: Hydrothermal stability, electrical heating possibility and reforming reactivity

Lu Zhou et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2009)

添加到收藏夹

Article Chemistry, Physical

Numerical modelling and experimental validation of a planar type pre-reformer in SOFC technology

Murat Peksen et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2009)

添加到收藏夹

Article Chemistry, Physical

A three-dimensional numerical model of a single-chamber solid oxide fuel cell

Naveed Akhtar et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2009)

添加到收藏夹

Article Chemistry, Physical

Performance and effective kinetic models of methane steam reforming over Ni/YSZ anode of planar SOFC

Yuzhang Wang et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2009)

添加到收藏夹

Review Chemistry, Physical

Modeling of solid-oxide fuel cells

Vinod M. Janardhanan et al.

ZEITSCHRIFT FUR PHYSIKALISCHE CHEMIE-INTERNATIONAL JOURNAL OF RESEARCH IN PHYSICAL CHEMISTRY & CHEMICAL PHYSICS (2007)

添加到收藏夹

Article Chemistry, Physical

Cobalt catalysts prepared from hydrotalcite precursors and tested in methane steam reforming

Alessandra Fonseca Lucredio et al.

JOURNAL OF POWER SOURCES (2006)

添加到收藏夹

Article Electrochemistry

Modeling elementary heterogeneous chemistry and electrochemistry in solid-oxide fuel cells

HY Zhu et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2005)

添加到收藏夹

Article Chemistry, Physical

Thermodynamic and transport properties of gases for use in solid oxide fuel cell modelling

B Todd et al.

JOURNAL OF POWER SOURCES (2002)

添加到收藏夹

Article Computer Science, Interdisciplinary Applications

An alternative interpolation scheme for minimum compliance topology optimization

M Stolpe et al.

STRUCTURAL AND MULTIDISCIPLINARY OPTIMIZATION (2001)

添加到收藏夹

Article Engineering, Environmental

The kinetics of methane steam reforming over a Ni/α-Al2O catalyst

KH Hou et al.

CHEMICAL ENGINEERING JOURNAL (2001)

添加到收藏夹

© Peeref 2019-2024. All rights reserved.