相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Polydispersed droplet spectrum and exergy analysis in wet steam flows using method of moments
Hongbing Ding et al.
APPLIED THERMAL ENGINEERING (2021)
Simulation of stably stratified turbulent channel flow using residual-based variational multiscale method and isogeometric analysis
H. Cen et al.
COMPUTERS & FLUIDS (2021)
Effect of area ratio of the primary nozzle on steam ejector performance considering nonequilibrium condensations
Yan Yang et al.
ENERGY (2021)
Thermodynamic analysis and optimization of a partial evaporating dual-pressure organic rankine cycle system for low-grade heat recovery
Dantong Li et al.
APPLIED THERMAL ENGINEERING (2021)
Battery thermal management: An optimization study of parallelized conjugate numerical analysis using Cuckoo search and Artificial bee colony algorithm
Asif Afzal et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2021)
Wet steam flow and condensation loss in turbine blade cascades
Chuang Wen et al.
APPLIED THERMAL ENGINEERING (2021)
Computational fluid-dynamic modelling of two-phase compressible flows of carbon dioxide in supercritical conditions
Alessandro Romei et al.
APPLIED THERMAL ENGINEERING (2021)
A blackbox optimization of volumetric heating rate for reducing the wetness of the steam flow through turbine blades
Davood Hoseinzade et al.
ENERGY (2021)
A novel process for coke wastewater gasification quenching: Energy and exergy analysis
Zhen Li et al.
APPLIED THERMAL ENGINEERING (2021)
Investigating the dehumidification characteristics of the low-pressure stage with blade surface heating
Xu Han et al.
APPLIED THERMAL ENGINEERING (2020)
Numerical investigation of effects polydispersed droplets on the erosion rate and condensation loss in the wet steam flow in the turbine blade cascade
Mohammad Ali Faghih Aliabadi et al.
APPLIED THERMAL ENGINEERING (2020)
A comprehensive investigation of finding the best location for hot steam injection into the wet steam turbine blade cascade
Mohammad Ali Faghih Aliabadi et al.
ENERGY (2020)
Improvement of the wet steam ejector performance in a refrigeration cycle via changing the ejector geometry by a novel EEC (Entropy generation, Entrainment ratio, and Coefficient of performance) method
Farzaneh Foroozesh et al.
INTERNATIONAL JOURNAL OF REFRIGERATION (2020)
Investigating the effect of water nano-droplets injection into the convergent-divergent nozzle inlet on the wet steam flow using entropy generation analysis
Mohammad Ali Faghih Aliabadi et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2020)
Optimization of the primary nozzle based on a modified condensation model in a steam ejector
Guojie Zhang et al.
APPLIED THERMAL ENGINEERING (2020)
Symbiotic technology assessment in iron and steel industry based on entropy TOPSIS method
Yihan Wang et al.
JOURNAL OF CLEANER PRODUCTION (2020)
Optimal thermal power plant selection for a tropical region using multi-criteria decision analysis
Ifeanyi Henry Njoku et al.
APPLIED THERMAL ENGINEERING (2020)
Heat transfer and entropy generation analysis of nanofluids thermocapillary convection around a bubble in a cavity
Yanni Jiang et al.
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2019)
Thermodynamic analysis of the steam ejector for desalination applications
Jiapeng Liu et al.
APPLIED THERMAL ENGINEERING (2019)
Entropy generation and exergy destruction in condensing steam flow through turbine blade with surface roughness
Hongbing Ding et al.
ENERGY CONVERSION AND MANAGEMENT (2019)
Entropy generation analysis of wet-steam flow with variation of expansion rate using NURBS-based meshing technique
Amir Ebrahimi-Fizik et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)
Investigating the entropy generation in condensing steam flow in turbine blades with volumetric heating
Masoud Vatanmakan et al.
ENERGY (2018)
Optimization of the rectangular storage tanks for the sloshing phenomena based on the entropy generation minimization
Hassan Saghi et al.
ENERGY (2017)
Comprehensive investigations into thermal and flow phenomena occurring, in the atmospheric air two-phase flow through nozzles
Siawomir Dykas et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)
A NUMERICAL RESEARCH ON ENERGY LOSS EVALUATION IN A CENTRIFUGAL PUMP SYSTEM BASED ON LOCAL ENTROPY PRODUCTION METHOD
Hucan Hou et al.
THERMAL SCIENCE (2017)
Multi-step ahead electricity price forecasting using a hybrid model based on two-layer decomposition technique and BP neural network optimized by firefly algorithm
Deyun Wang et al.
APPLIED ENERGY (2017)
Application of TOPSIS method in evaluating the effects of supply vane angle of a task/ambient air conditioning system on energy utilization and thermal comfort
Mao Ning et al.
APPLIED ENERGY (2016)
Shape optimization of nucleating wet-steam flow nozzle
Saeed Jamali Keisari et al.
APPLIED THERMAL ENGINEERING (2016)
Nozzle arrangement effect on cooling performance of saline water spray cooling
M. H. Sadafi et al.
APPLIED THERMAL ENGINEERING (2016)
Performance evaluation of steam injected gas turbine based power plant with inlet evaporative cooling
Anoop Kumar Shukla et al.
APPLIED THERMAL ENGINEERING (2016)
Thermal balance of wet-steam turbines in nuclear power plants: A case study
Mario Alvarez-Fernandez et al.
APPLIED THERMAL ENGINEERING (2016)
Development of Energy Efficiency Design Map based on acoustic resonance frequency of suction muffler in compressor
Seungjae Oh et al.
APPLIED ENERGY (2015)
Effects of surface roughness on deviation angle and performance losses in wet steam turbines
H. Bagheri Esfe et al.
APPLIED THERMAL ENGINEERING (2015)
Non-equilibrium condensation of wet steam flow within high-pressure thermo-compressor
S. M. A. Noori Rahim Abadi et al.
APPLIED THERMAL ENGINEERING (2015)
Turbocharger heat transfer and mechanical losses influence in predicting engines performance by using one-dimensional simulation codes
Jose Ramon Serrano et al.
ENERGY (2015)
Experimental and numerical studies on self-excited periodic oscillation of vapor condensation in a sonic nozzle
Hongbing Ding et al.
EXPERIMENTAL THERMAL AND FLUID SCIENCE (2015)
Non-equilibrium condensation of water vapor in sonic nozzle
Hongbing Ding et al.
APPLIED THERMAL ENGINEERING (2014)
Ejector primary nozzle steam condensation: Area ratio effects and mixing layer development
Kavous Ariafar et al.
APPLIED THERMAL ENGINEERING (2014)
Numerical assessment of steam nucleation on thermodynamic performance of steam ejectors
Navid Sharifi et al.
APPLIED THERMAL ENGINEERING (2013)
Performance prediction of an air-cooled steam condenser using UDF method
W. F. He et al.
APPLIED THERMAL ENGINEERING (2013)
Non-equilibrium spontaneous condensation in transonic steam flow
Assim H. Yousif et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2013)
Wet steam flow energy analysis within thermo-compressors
Navid Sharifi et al.
ENERGY (2012)
A general model for evaluation of vapor ejectors performance for application in refrigeration
Jose M. Cardemil et al.
ENERGY CONVERSION AND MANAGEMENT (2012)
Group decision making based on novel fuzzy modified TOPSIS method
Behnam Vandani et al.
APPLIED MATHEMATICAL MODELLING (2011)
Exergy analysis of two-phase steam-water injector
Marian Trela et al.
APPLIED THERMAL ENGINEERING (2010)
Effects of Hot Steam Injection from the Slot at the Trailing Edge on Turbine Nozzle Vane Flow Field
Liang Xu et al.
JOURNAL OF THERMAL SCIENCE (2008)
On the performance of a cascade of turbine rotor tip section blading in wet steam. Part 5: theoretical treatment
F. Bakhtar et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2006)
Classical nucleation theory and its application to condensing steam flow calculations
F Bakhtar et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2005)
A general formula for the evaluation of thermodynamic and aerodynamic losses in nucleating steam flow
MJ Kermani et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2003)
分享论文
