相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。Directly Deposited Thin-Film Strain Gauges on Curved Metallic Surfaces
Rico Ottermann et al.
2021 IEEE SENSORS (2021)
Development, Characterisation and High-Temperature Suitability of Thin-Film Strain Gauges Directly Deposited with a New Sputter Coating System
Daniel Klaas et al.
SENSORS (2020)
Direct Deposition of Thin-Film Strain Gauges with a New Coating System for Elevated Temperatures
Rico Ottermann et al.
2020 IEEE SENSORS (2020)
Novel Eddy-Current Sensor for Industrial Deep-Drawing Applications
Matthias Arndt et al.
2019 IEEE SENSORS (2019)
Calibration Coefficients Determination Through Fem Simulations for the Hole-Drilling Method Considering the Real Hole Geometry
R. Blodorn et al.
EXPERIMENTAL TECHNIQUES (2017)
Uncertainty analysis for non-uniform residual stresses determined by the hole drilling strain gauge method
D. Peral et al.
MEASUREMENT (2017)
Application of the Incremental Hole-Drilling Method on Thick Film Systems-An Approximate Evaluation Approach
E. Held et al.
EXPERIMENTAL MECHANICS (2015)
Influence of the interfacial roughness on residual stress analysis of thick film systems by incremental hole drilling
Esther Obelode et al.
INTERNATIONAL CONFERENCE ON RESIDUAL STRESSES 9 (ICRS 9) (2014)
Evaluation of the High-Speed Drilling Technique for the Incremental Hole-Drilling Method
A. Nau et al.
EXPERIMENTAL MECHANICS (2013)
Improved Calibration Coefficients for the Hole-Drilling Method Considering the Influence of the Poisson Ratio
A. Nau et al.
EXPERIMENTAL MECHANICS (2013)
Error and Uncertainty Analysis of the Residual Stresses Computed by Using the Hole Drilling Method
M. Scafidi et al.
STRAIN (2011)
Residual Stress Analysis Using the Hole-Drilling Method and Geometry-Specific Calibration Functions
Enrique Garcia Sobolevski et al.
MATERIALS TESTING-MATERIALS AND COMPONENTS TECHNOLOGY AND APPLICATION (2010)
Electrical insulation properties of sputter-deposited SiO2, Si3N4 and Al2O3 films at room temperature and 400 °C
Hagen Bartzsch et al.
PHYSICA STATUS SOLIDI A-APPLICATIONS AND MATERIALS SCIENCE (2009)
Implementation and development of the incremental hole drilling method for the measurement of residual stress in thermal spray coatings
T Valente et al.
JOURNAL OF THERMAL SPRAY TECHNOLOGY (2005)