4.7 Article

Aerodynamic design and multi-dimensional performance optimization of supercritical CO2 centrifugal compressor

期刊

ENERGY CONVERSION AND MANAGEMENT
卷 248, 期 -, 页码 -

出版社

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.enconman.2021.114810

关键词

SCO2 centrifugal compressor; One-dimensional design; Optimization; CFD; Genetic algorithm; Particle swarm optimization

资金

  1. National Natural Science Foundation of China [51976145]

向作者/读者索取更多资源

This paper presents a systematic approach for designing and optimizing a SCO2 compressor, which results in an improvement of isentropic efficiency through simulations and experimental validations.
This paper dedicates to develop a systematic approach of design and multi-dimensional performance optimization of the Supercritical carbon dioxide (SCO2) compressor. A 5 MW SCO2 simple regenerative cycle used in small scale lead-cooled fast reactor (SLFR) was firstly proposed and simulated to define the operation condition of SCO2 compressor. Under the inlet and outlet condition of 305.15 K/7.56 MPa and 22 MPa, isentropic efficiency and mass flow rate of 80% and 69.88 kg center dot s(-1) respectively was obtained. Secondly, a single stage centrifugal compressor was applied as the SCO2 compressor and one-dimensional (1D) design based on self-developed code was conducted to determine the basic geometry of the compressor, the code was verified with experiments and shows satisfactory accuracy. Additionally, CFD analysis was carried out to validate the results of 1D design and also shows good agreement. Then, three one-dimensional optimizations, two single objective optimizations using Particle Swarm Optimization (PSO) and one multi-objective optimization using Genetic Algorithm (GA), on aerodynamic efficiency of the SCO2 centrifugal compressor were performed based on 1D design code, five crucial parameters with +/- 5% variation range were optimized. The 1D optimization results show that the isentropic efficiency received an improvement of about 5 percentage points compared to that of 1D design. Lastly, three-dimensional optimization concentrated on the blade profile of impeller were conducted on a fully automatic optimization platform to further improve the isentropic efficiency of SCO2 centrifugal compressor. Wrap angle and the leading and trailing edge of the main blade were optimized. Two optimal impellers with wrap angle in the range of + 5% and 5% were obtained respectively, the former impeller got the highest pressure ratio, while the latter one gained a higher isentropic efficiency but the lowest pressure ratio over the whole operation range.

作者

我是这篇论文的作者
点击您的名字以认领此论文并将其添加到您的个人资料中。

评论

主要评分

4.7
评分不足

次要评分

新颖性
-
重要性
-
科学严谨性
-
评价这篇论文

推荐

暂无数据
暂无数据