4.7 Article

A novel corrosion transformation process in aluminum alloy/galvanized steel welded joint

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Engineering, Environmental

Biobased self-healing polyurethane coating with Zn micro-flakes for corrosion protection of AA7475

Jessica V. Nardeli et al.

Summary: The study demonstrates that bio-based organic polyurethane coatings prepared from vegetable oils and incorporating zinc micro-flakes provide effective corrosion protection for AA7475, with the highest content of 7.5% zinc micro-flakes showing significantly improved protective ability. Various electrochemical techniques were used to confirm the corrosion inhibition process and the homogeneity of the coatings.

CHEMICAL ENGINEERING JOURNAL (2021)

Article Materials Science, Multidisciplinary

Effect of micro-alloying element La on corrosion behavior of Al-Mg-Si alloys

Qiuju Zheng et al.

Summary: The study found that micro-alloying element La can improve the corrosion resistance of Al-Mg-Si alloys by forming Mg2Si particles with a La-rich surface shell and isolated Si particles, which slows down the corrosion rate and inhibits localized corrosion.

CORROSION SCIENCE (2021)

Article Engineering, Manufacturing

Corrosion behavior and failure mechanism of electromagnetic pulse welded joints between galvanized steel and aluminum alloy sheets

Shaoluo Wang et al.

Summary: In this study, the corrosion behavior and mechanism of aluminum/galvanized steel and aluminum/ungalvanized steel magnetic pulse welding (MPW) joints were compared and discussed systematically. It was found that the mechanical performance of the two joints deteriorated with aging time, with the aluminum/ungalvanized steel joint showing lower degree of degradation and higher strength than the aluminum/galvanized steel joint. Different corrosion mechanisms led to different failure modes and fracture mechanisms in the two joints.

JOURNAL OF MANUFACTURING PROCESSES (2021)

Article Engineering, Manufacturing

Microstructure inhomogeneity of dissimilar steel/Al butt joints produced by laser offset welding

Li Cui et al.

JOURNAL OF MANUFACTURING PROCESSES (2020)

Article Engineering, Industrial

Influence of energy ratio on dual-spot laser welded-brazed Al/steel butt joint

Hongbo Xia et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2020)

Article Engineering, Manufacturing

Influence of wire feed rate on mechanical and microstructure characteristics of aluminum to galvanized steel laser brazed joint

D. Narsimhachary et al.

JOURNAL OF MANUFACTURING PROCESSES (2019)

Article Chemistry, Physical

Microstructural influence on corrosion behavior of MgZnGe alloy in NaCl solution

Pingli Jiang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Article Engineering, Industrial

Formability behavior of Al/steel MIG arc brazed-fusion welded joint

Guoliang Qin et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2019)

Article Engineering, Industrial

Integrity of 5052 Al-mild steel dissimilar welds fabricated using MIG-brazing and cold metal transfer in nitric acid medium

S. S. Sravanthi et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2019)

Article Engineering, Industrial

Butt welding-brazing of steel to aluminum by hybrid laser-CMT

Shuhai Chen et al.

JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2019)

Article Chemistry, Physical

Effect of Microstructure on the Corrosion Resistance of TIG Welded 1579 Alloy

Andrey S. Gnedenkov et al.

MATERIALS (2019)

Article Materials Science, Multidisciplinary

Laser welding introduced segregation and its influence on the corrosion behaviour of Al-Cu-Li alloy

Xinxin Zhang et al.

CORROSION SCIENCE (2018)

Article Materials Science, Multidisciplinary

Effect of repetitious non-isothermal heat treatment on corrosion behavior of Al-Zn-Mg alloy

Shuai Li et al.

CORROSION SCIENCE (2018)

Article Materials Science, Multidisciplinary

Effect of Welding Parameters on the Corrosion Behavior of Dissimilar Alloy Welds of T6 AA6061 Al-Galvanized Mild Steel

S. S. Sravanthi et al.

JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2018)

Article Materials Science, Multidisciplinary

Corrosion behavior of refilled friction stir spot welded joint between aluminum alloy and galvanized steel

Peng Li et al.

MATERIALS RESEARCH EXPRESS (2018)

Article Chemistry, Physical

Application of electroless Ni-P coating on magnesium alloy via CrO3/HF free titanate pretreatment

Z. Rajabalizadeh et al.

APPLIED SURFACE SCIENCE (2017)

Article Materials Science, Multidisciplinary

Corrosion behaviour of hot-dip Al-Zn-Si and Al-Zn-Si-3Mg coatings in NaCl solution

Wei Liu et al.

CORROSION SCIENCE (2017)

Article Materials Science, Multidisciplinary

Corrosion Behavior of Aluminum-Steel Weld-Brazing Joint

Yu Shi et al.

JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2016)

Article Chemistry, Physical

The Al-Rich Part of the Fe-Al Phase Diagram

Xiaolin Li et al.

JOURNAL OF PHASE EQUILIBRIA AND DIFFUSION (2016)

Article Metallurgy & Metallurgical Engineering

Joint Characteristics and Corrosion Properties of Bypass-Current Double-Sided Arc-Welded Aluminum 6061 Alloy with Al-Si Filler Metal

Yu-Gang Miao et al.

ACTA METALLURGICA SINICA-ENGLISH LETTERS (2016)

Article Materials Science, Multidisciplinary

Effects of zirconium and oxygen plasma ion implantation on the corrosion behavior of ZK60 Mg alloy in simulated body fluids

Mohammed Ibrahim Jamesh et al.

CORROSION SCIENCE (2014)

Article Electrochemistry

Electrochemical Characterization of Intermetallic Phases Common to Aluminum Alloys as a Function of Solution Temperature

M. K. Cavanaugh et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2014)

Article Materials Science, Multidisciplinary

Corrosion inhibition by anionic surfactants of AA2198 Li-containing aluminium alloy in chloride solutions

Andrea Balbo et al.

CORROSION SCIENCE (2013)

Article Materials Science, Multidisciplinary

Corrosion of AA6061 Brazed with an Al-Si Alloy: Effects of Si on Metallurgical and Corrosion Behavior

K. M. Fleming et al.

CORROSION (2012)

Proceedings Paper Materials Science, Multidisciplinary

Stability analysis of the Mg2Si phase in AA 6061 aluminum alloy.

E. Linardi et al.

11TH INTERNATIONAL CONGRESS ON METALLURGY & MATERIALS SAM/CONAMET 2011 (2012)

Article Materials Science, Multidisciplinary

Corrosion properties of laser beam joints of aluminium with zinc-coated steel

J. Wloka et al.

CORROSION SCIENCE (2007)

Article Materials Science, Multidisciplinary

SVET and SECM imaging of cathodic protection of aluminium by a Mg-rich coating

A. M. Simoes et al.

CORROSION SCIENCE (2007)

Article Electrochemistry

Electrochemical study on magnesium anodes in NaCl and CaSO4Mg(OH)2 aqueous solutions

F Guadarrama-Muñoz et al.

ELECTROCHIMICA ACTA (2006)

Article Electrochemistry

Electrochemical characteristics of intermetallic phases in aluminum alloys - An experimental survey and discussion

N Birbilis et al.

JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2005)

Article Materials Science, Multidisciplinary

Evaluation of the BEASY program using linear and piecewise linear approaches for the boundary conditions

JX Jia et al.

MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION (2004)

Article Materials Science, Multidisciplinary

Localized corrosion of 6056 T6 aluminium alloy in chloride media

V Guillaumin et al.

CORROSION SCIENCE (2000)