4.6 Article

Effects of gas composition and operating pressure on the heat transfer in an oxy-fuel fluidized bed: A CFD-DEM study

相关参考文献

注意:仅列出部分参考文献,下载原文获取全部文献信息。
Article Thermodynamics

Pressurized oxy-fuel combustion of a char particle in the fluidized bed combustor

Lin Li et al.

Summary: In this study, experimental single char combustion was conducted in a visualized pressurized FB combustor, followed by the development of an experimentally verified particle-scale char combustion model. The results showed that char conversion was accelerated with the increase of pressure, mainly due to high oxygen diffusion and char gasification. Gasification played an important role in pressurized oxy-fuel combustion, especially under high oxygen concentration and bed temperature, enhancing char oxidation rate and gasification rate and shortening burnout time. Additionally, a higher fluidization number improved mass and heat transfer, reducing burnout time and peak temperature of char particle.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Thermodynamics

Oxy-coal combustion in a 30 kWth pressurized fluidized bed: Effect of combustion pressure on combustion performance, pollutant emissions and desulfurization

Lei Pang et al.

Summary: Experimental studies on pressurized oxy-coal combustion in fluidized bed combustors/boilers with continuous coal feeding are limited, but have shown that an increase in pressure can significantly improve combustion efficiency and combustion rate of coal particles, with a more pronounced effect on high rank coal and high O2 concentration. Under high pressure oxy-coal combustion conditions, NOx emissions decrease while N2O emissions increase, with SO2 emissions minimally impacted by pressure but direct desulfurization of limestone enhanced with pressure.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2021)

Article Engineering, Chemical

Simulation investigation of heating rate and temperature uniformity in fluidized bed

Jiazhe Xue et al.

Summary: In this study, the hydrodynamics and gas-solid heat transfer characteristics during bed material heating process were investigated using the CFD-DEM method. The results showed that internal circulation behavior weakened the phenomenon of overheating at the bottom of the bed, and with time progression, the bed temperature uniformity was effectively improved.

CHEMICAL ENGINEERING SCIENCE (2021)

Article Engineering, Chemical

CFD-DEM Investigation of Fuel Dispersion Behaviors in a 3D Fluidized Bed

Guoqing Lian et al.

Summary: This paper investigates the dispersion behaviors of continuous-feeding fuel particles in a 3D fluidized bed and identifies key factors influencing the dispersion. The axial dispersion coefficient of fuel particles is found to be significantly larger than the radial dispersion coefficient, with increasing fluidization velocity and initial bed height promoting dispersion. However, using finer bed material enhances fuel dispersion at the same fluidization velocity but weakens dispersion at a similar fluidization number.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2021)

Article Engineering, Chemical

DEM study on the mixed feeding process of coal and cylindroid biomass particles in a screw feeder

Guoqing Lian et al.

Summary: The study focused on the complex mixed feeding process of coal and cylindroid biomass particles in a screw feeder using the discrete element method (DEM). Results show that higher biomass feeding ratio and screw rotational speed can enhance the stability of the mixed feeding process, while too high feeding rate may cause particles to be hindered. The stability of biomass blending ratio is better at higher biomass feeding ratios.

ADVANCED POWDER TECHNOLOGY (2021)

Article Engineering, Chemical

CFD-DEM simulation of heat transfer in fluidized beds: Model verification, validation, and application

Shuai Wang et al.

CHEMICAL ENGINEERING SCIENCE (2019)

Article Engineering, Chemical

Particle-Scale Investigation of Heat Transfer and Erosion Characteristics in a Three-Dimensional Circulating Fluidized Bed

Shuai Wang et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2018)

Article Engineering, Chemical

Effect of elevated pressure on bubble properties in a two-dimensional gas-solid fluidized bed

Jialong Song et al.

CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)

Article Engineering, Chemical

CFD-DEM study on cohesive particles in a spouted bed

Huibin Xu et al.

POWDER TECHNOLOGY (2017)

Review Engineering, Environmental

Effects of temperature, pressure, and interparticle forces on the hydrodynamics of a gas-solid fluidized bed

Jaber Shabanian et al.

CHEMICAL ENGINEERING JOURNAL (2017)

Review Engineering, Chemical

CFD simulation of dense particulate reaction system: Approaches, recent advances and applications

Wenqi Zhong et al.

CHEMICAL ENGINEERING SCIENCE (2016)

Review Energy & Fuels

A review of oxy-fuel combustion in fluidized bed reactors

H. I. Mathekga et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2016)

Article Engineering, Environmental

Comparison of CFD-DEM heat transfer simulations with infrared/visual measurements

A. V. Patil et al.

CHEMICAL ENGINEERING JOURNAL (2015)

Article Engineering, Environmental

A study of heat transfer in fluidized beds using an integrated DIA/PIV/IR technique

Amit V. Patil et al.

CHEMICAL ENGINEERING JOURNAL (2015)

Article Engineering, Chemical

Numerical Investigation on the Effect of Pressure on Fluidization in a 3D Fluidized Bed

Vikrant Verma et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2014)

Proceedings Paper Energy & Fuels

30 MWth CIUDEN Oxy-CFB Boiler - First experiences

Monica Lupion et al.

GHGT-11 (2013)

Article Energy & Fuels

Pressurized Oxy-fuel Combustion: A Study of Selected Parameters

Janusz A. Lasek et al.

ENERGY & FUELS (2012)

Article Engineering, Chemical

Experimental Study of Large Scale Fluidized Beds at Elevated Pressure

Willem Godlieb et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2012)

Article Engineering, Chemical

Computational Study of the Effects of Material Properties on Heat Transfer in Gas Fluidization

Qin-Fu Hou et al.

INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2012)

Article Engineering, Chemical

CFD-DEM simulation of spouting of corn-shaped particles

Bing Ren et al.

PARTICUOLOGY (2012)

Review Green & Sustainable Science & Technology

Oxy-fuel coal combustion-A review of the current state-of-the-art

Guenter Scheffknecht et al.

INTERNATIONAL JOURNAL OF GREENHOUSE GAS CONTROL (2011)

Article Materials Science, Multidisciplinary

Bubble Behaviour in Fluidised Beds at Elevated Pressures

Willem Godlieb et al.

MACROMOLECULAR MATERIALS AND ENGINEERING (2011)

Article Engineering, Chemical

A new computational method for studying heat transfer in fluid bed reactors

Z. Y. Zhou et al.

POWDER TECHNOLOGY (2010)

Review Thermodynamics

Oxy-fuel combustion of solid fuels

Maja B. Toftegaard et al.

PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2010)

Article Engineering, Chemical

Modeling of heat transfer in granular flow in rotating vessels

Bodhisattwa Chaudhuri et al.

CHEMICAL ENGINEERING SCIENCE (2006)

Article Engineering, Chemical

Characterization of the flow patterns in a pressurized circulating fluidized bed

M Richtberg et al.

POWDER TECHNOLOGY (2005)