相关参考文献
注意:仅列出部分参考文献,下载原文获取全部文献信息。The study of heat transfer and laminar flow of kerosene/multi-walled carbon nanotubes (MWCNTs) nanofluid in the microchannel heat sink with slip boundary condition
Abedin Arabpour et al.
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2018)
Filling angle and its effect on filling process in roll-to-roll ultraviolet imprint lithography
Jianping Wang et al.
JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2018)
Volume of fluid model to simulate the nanofluid flow and entropy generation in a single slope solar still
Saman Rashidi et al.
RENEWABLE ENERGY (2018)
Wall slip of complex fluids: Interfacial friction versus slip length
Benjamin Cross et al.
PHYSICAL REVIEW FLUIDS (2018)
Biomimetic Moth-eye Nanofabrication: Enhanced Antireflection with Superior Self-cleaning Characteristic
Jingyao Sun et al.
SCIENTIFIC REPORTS (2018)
Preparation of renewable antireflection moth-eye surfaces by nanoimprinting using anodic porous alumina molds
Takashi Yanagishita et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B (2018)
Efficient Charge Transfer and Fine-Tuned Energy Level Alignment in a THF- Processed Fullerene- Free Organic Solar Cell with 11.3% Efficiency
Zhong Zheng et al.
ADVANCED MATERIALS (2017)
Low-voltage blue-phase liquid crystal display with diamond-shape electrodes
Haiwei Chen et al.
LIQUID CRYSTALS (2017)
Jet cooling characteristics for ball bearings using the VOF multiphase model
Wei Wu et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2017)
Broadband image sensor array based on graphene-CMOS integration
Stijn Goossens et al.
NATURE PHOTONICS (2017)
A Quantum Dot Array for Enhanced Tricolor Liquid-Crystal Display
Yikun l Liu et al.
IEEE PHOTONICS JOURNAL (2017)
Silicon heterojunction solar cell with interdigitated back contacts for a photoconversion efficiency over 26%
Kunta Yoshikawa et al.
NATURE ENERGY (2017)
Fabrication of flexible silver nanowire conductive films and transmittance improvement based on moth-eye nanostructure array
Chengpeng Zhang et al.
JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2017)
Optimization and continuous fabrication of moth-eye nanostructure array on flexible polyethylene terephthalate substrate towards broadband antireflection
Chengpeng Zhang et al.
APPLIED OPTICS (2017)
Effect of droplet size, droplet placement, and gas dissolution on throughput and defect rate in UV nanoimprint lithography
Akhilesh Jain et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B (2017)
Micro-PIV measurements of flows induced by rotating microparticles near a boundary
Jamel Ali et al.
MICROFLUIDICS AND NANOFLUIDICS (2016)
Study on bubble defects in roll-to-roll UV imprinting process for micropyramid arrays II: Numerical study
Linfa Peng et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B (2016)
Study on bubble defects in roll-to-roll UV imprinting process for micropyramid arrays. I. Experiments
Hao Wu et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B (2016)
Fabrication of Moth-Eye Nanostructure Arrays Using Roll-to-Roll UV-Nanoimprint Lithography With an Anodic Aluminum Oxide Mold
Chengpeng Zhang et al.
IEEE TRANSACTIONS ON NANOTECHNOLOGY (2015)
Bubble defect control in low-cost roll-to-roll ultraviolet imprint lithography
Huichun Ye et al.
MICRO & NANO LETTERS (2014)
Study on Change in UV Nanoimprint Pattern by Altering Shrinkage of UV Curable Resin
Hiroshi Hiroshima et al.
JAPANESE JOURNAL OF APPLIED PHYSICS (2013)
Simulation of Resist Filling Properties under Condensable Gas Ambient in Ultraviolet Nanoimprint Lithography
Yoshinori Nagaoka et al.
JAPANESE JOURNAL OF APPLIED PHYSICS (2013)
Impact of Resist Shrinkage and Its Correction in Nanoimprint Lithography
Akira Horiba et al.
JAPANESE JOURNAL OF APPLIED PHYSICS (2013)
Fluid management in roll-to-roll nanoimprint lithography
A. Jain et al.
JOURNAL OF APPLIED PHYSICS (2013)
Numerical studies of electrically induced pattern formation by coupling liquid dielectrophoresis and two-phase flow
Hongmiao Tian et al.
ELECTROPHORESIS (2011)
Some recent advances in multi-material micro- and nano-manufacturing
E. B. Brousseau et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2010)
Process-simulation system for UV-nanoimprint lithography
Mayuko Shibata et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B (2010)
Numerical study on bubble trapping in UV nanoimprint lithography
Daisuke Morihara et al.
JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B (2009)
Resist Flow Behavior in Ultraviolet Nanoimprint Lithography as a Function of Contact Angle with Stamp and Substrate
Ki-Don Kim et al.
JAPANESE JOURNAL OF APPLIED PHYSICS (2008)
Flow property measurements for nanoimprint simulation
T. Leveder et al.
MICROELECTRONIC ENGINEERING (2007)
Simulation of fluid flow in the step and flash imprint lithography process
S Reddy et al.
MICROELECTRONIC ENGINEERING (2005)
Simulation of the filling process in micro channels for polymeric materials
DG Yao et al.
JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2002)