相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Effects of boron content on the microstructure and mechanical properties of twin-roll strip casting borated steel sheets
Zhao-Jie Wang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Comparison of cracking sensitivity between high-permeability 1.5 wt% Si steel and 6.5 wt% Si steel in mushy zone
W. L. Hu et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2020)
Microstructure and mechanical properties of Al-7.9Zn-2.7Mg-2.0Cu (wt%) alloy strip fabricated by twin roll casting and hot rolling
Qianhao Zang et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2020)
Influence of Rolling Reduction on Secondary Recrystallization and Magnetic Properties in Strip-Cast Grain-Oriented 4.5% Si Steel
Xiang Lu et al.
STEEL RESEARCH INTERNATIONAL (2017)
Retaining {100} texture from initial columnar grains in 6.5 wt% Si electrical steels
Ruiyang Liang et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2017)
A novel ultra-low carbon grain oriented silicon steel produced by twin-roll strip casting
Yang Wang et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2016)
Effect of deformation on microstructure and mechanical properties of dual phase steel produced via strip casting simulation
Z. P. Xiong et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
Twin-roll strip casting: A competitive alternative for the production of high-manganese steels with advanced mechanical properties
Markus Daamen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Effects of warm temper rolling on microstructure, texture and magnetic properties of strip-casting 6.5 wt% Si electrical steel
Hao-Ze Li et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2014)
Characterization of microstructure, texture and magnetic properties in twin-roll casting high silicon non-oriented electrical steel
Hao-Ze Li et al.
MATERIALS CHARACTERIZATION (2014)
Development of λ-fiber recrystallization texture and magnetic property in Fe-6.5 wt% Si thin sheet produced by strip casting and warm rolling method
Hai-Tao Liu et al.
MATERIALS LETTERS (2013)
Bulk texture evolution of Cu-Nb nanolamellar composites during accumulative roll bonding
J. S. Carpenter et al.
ACTA MATERIALIA (2012)
Grain detection from 2d and 3d EBSD data-Specification of the MTEX algorithm
Florian Bachmann et al.
ULTRAMICROSCOPY (2011)
A finite strain elastic-viscoplastic self-consistent model for polycrystalline materials
H. Wang et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2010)
High Temperature Mechanical Properties of Micro-alloyed Carbon Steel in the Mushy Zone
L. Guo et al.
STEEL RESEARCH INTERNATIONAL (2010)
A novel pole figure inversion method: specification of the MTEX algorithm
R. Hielscher et al.
JOURNAL OF APPLIED CRYSTALLOGRAPHY (2008)
Tensile Deformation Behavior of Duplex Stainless Steel Studied by In-Situ Time-of-Flight Neutron Diffraction
N. Jia et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2008)
Interactions between the phase stress and the grain-orientation-dependent stress in duplex stainless steel during deformation
N. Jia et al.
ACTA MATERIALIA (2006)
A selfconsistent formulation for the prediction of the anisotropic behavior of viscoplastic polycrystals with voids
RA Lebensohn et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2004)
The effect of texture on ridging of ferritic stainless steel
HJ Shin et al.
ACTA MATERIALIA (2003)
The effects of superheating on texture and microstructure of Fe-4.5wt%Si steel strip by twin-roll strip casting
JY Park et al.
ISIJ INTERNATIONAL (2001)
Mechanical behavior of carbon steels in the temperature range of mushy zone
DJ Seol et al.
ISIJ INTERNATIONAL (2000)
分享论文
