相关参考文献
注意：仅列出部分参考文献，下载原文获取全部文献信息。Dynamic recrystallization behavior andmicrostructure evolution of high-performance Cu-3.28Ni-0.6Si-0.22Zn-0.11Cr-0.04P during hot compression
Chang-Sheng Wang et al.
RARE METALS (2021)
Effect of cross-rolling on microstructure and texture evolution and tensile behavior of aluminium-copper-lithium (AA2195) alloy
Niraj Nayan et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Characterisation of high rate plasticity in the uniaxial deformation of high purity copper at elevated temperatures
L. J. Lea et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2018)
Influence of rapid heating and cooling combined with deformation at ultrahigh strain rates on the microstructure evolution of pure titanium shaped charge liner
Kai Jiang et al.
MATERIALS CHARACTERIZATION (2018)
Microstructural evolution of adiabatic shear bands in pure copper during impact at high strain rates
Solomon Boakye-Yiadom et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Modeling spontaneous shear bands evolution in thick-walled cylinders subjected to external High-strain-rate loading
Mingtao Liu et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2016)
Self-organization of adiabatic shear bands in ZK60 Magnesium alloy
Yang Yang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
An experimental study on spontaneous adiabatic shear band formation in electro-magnetically collapsing cylinders
Z. Lovinger et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2015)
About quantitative EBSD analysis of deformation and recovery substructures in pure Tantalum
C. Moussa et al.
36TH RISO INTERNATIONAL SYMPOSIUM ON MATERIALS SCIENCE (2015)
Microstructural evolution and grain refinement mechanism of pure tungsten under explosive loading condition
Fuchi Wang et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2014)
Dynamic and post-dynamic recrystallization under hot, cold and severe plastic deformation conditions
Taku Sakai et al.
PROGRESS IN MATERIALS SCIENCE (2014)
Non-crystallographic shear banding in crystal plasticity FEM simulations: Example of texture evolution in α-brass
N. Jia et al.
ACTA MATERIALIA (2012)
High-Strain-Rate Deformation: Mechanical Behavior and Deformation Substructures Induced
George T. (Rusty) Gray
ANNUAL REVIEW OF MATERIALS RESEARCH, VOL 42 (2012)
On the room-temperature annealing of cryogenically rolled copper
T. Konkova et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Microstructural Aspects of Adiabatic Shear Failure in Annealed Ti6Al4V
P. Landau et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2010)
Self-organization behaviors of shear bands in 7075 T73 and annealed aluminum alloy
Y. Yang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)
Research of textures of ultrafine grains pure copper produced by accumulative roll-bonding
Liangwei Chen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)
Dynamic recrystallization of tungsten in a shaped charge liner
W. Guo et al.
SCRIPTA MATERIALIA (2009)
High-strain-rate response of ultra-fine-grained copper
A. Mishra et al.
ACTA MATERIALIA (2008)
The mechanical response of pure iron at high strain rates under dominant shear
D. Rittel et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2006)
Effect of shock compression method on the defect substructure in monocrystalline copper
BY Cao et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
Effect of low-temperature shock compression on the microstructure and strength of copper
DH Lassila et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2004)
Comparison of microstructures in electroformed copper liners of shaped charges before and after plastic deformation at different strain rates
WH Tian et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2003)
Laser-induced shock compression of monocrystalline copper: characterization and analysis
MA Meyers et al.
ACTA MATERIALIA (2003)
Microstructural evolution in adiabatic shear localization in stainless steel
MA Meyers et al.
ACTA MATERIALIA (2003)
Large strain constitutive behavior of OFHC copper over a wide range of strain rates using the shear compression specimen
D Rittel et al.
MECHANICS OF MATERIALS (2002)
Finite element simulation of shaped charges
JF Molinari
FINITE ELEMENTS IN ANALYSIS AND DESIGN (2002)
Self-organization of shear bands in titanium and Ti-6Al-4V alloy
Q Xue et al.
ACTA MATERIALIA (2002)
Microstructural evolution in adiabatic shear bands in Ta and Ta-W alloys
MT Pérez-Prado et al.
ACTA MATERIALIA (2001)
分享论文
